diff options
Diffstat (limited to 'doc/dlt_multinode.md')
| -rw-r--r-- | doc/dlt_multinode.md | 33 |
1 files changed, 9 insertions, 24 deletions
diff --git a/doc/dlt_multinode.md b/doc/dlt_multinode.md index ff9c85c..bfb13aa 100644 --- a/doc/dlt_multinode.md +++ b/doc/dlt_multinode.md @@ -38,10 +38,14 @@ GatewayMode = 1 ### Gateway Configuration File -The MultiNode configuration file has to be loaded by the Gateway DLT Daemon -during startup. +The MultiNode configuration file has to be loaded by the Gateway DLT Daemon during startup. + +Example: ``` +[General] +Interval=1 + [PassiveNode1] ; IP Address. (Mandatory) IPaddress = 192.168.2.32 @@ -51,7 +55,8 @@ Port = 3495 EcuID = ECU2 ; Connection to passive node only on demand. Default ‘OnStartup’ if not specified Connect = OnDemand -; timeout in seconds +; Stop connecting to passive node, if not successful after 10 retries. +; Set to 0 for endless retry. Timeout = 10 ; Send following control messages after connection is established SendControl=0x03, 0x13 @@ -60,27 +65,7 @@ SendControl=0x03, 0x13 SendSerialHeader=1 ``` -The configuration file is written in an INI file format and contains information -about different connected passive nodes. Each passive node’s connection -parameters are specified in a unique numbered separate section -([PassiveNode{1,2, …N}]). Because TCP is the only supported communication -channel, the IPaddress and Port of the Passive DLT Daemon has to be specified. - -With the Connect property it is possible to specify when the Gateway DLT Daemon -shall connect to the passive node. The following values are allowed: -- OnStartup - The Gateway DLT Daemon tries to connect to the Passive DLT Daemon - immediately after the Gateway DLT Daemon is started. -- OnDemand - The Gateway DLT Daemon tries to connect to the Passive DLT Daemon - when it receives a connection request. - -The Timeout property specifies the time after which the Gateway DLT Daemon stops -connecting attempts to a Passive DLT Daemon. If the connection is not -established within the specified time, the Gateway DLT Daemon gives up -connecting attempts and writes an error messages to its internal log. The -following control messages are supported to be send to a passive node -automatically after connection is established: -- 0x03: Get Log Info -- 0x13: Get Software Version +For more details, please refer to [dlt_gateway.conf.5.md](dlt_gateway.conf.5.md) ## Using DLT MultiNode |