drop unnecessary boards, chips and cts tests

The only board which would be built from this branch is Cr50. bds,
fizz and host boards are necessary for proper make infrastructure
operation and tests.

lm4 and npcx are chips used by the bds and fizz boards, so they are
also kept around.

BRANCH=cr50, cr50-mp
BUG=b:145912698
TEST='make buildall -j' succeeds

Change-Id: I937b2b8642c1fe91578fc9615438ae22c165b20f
Signed-off-by: Vadim Bendebury <vbendeb@chromium.org>
Reviewed-on: https://chromium-review.googlesource.com/c/chromiumos/platform/ec/+/1986942
Reviewed-by: Namyoon Woo <namyoon@chromium.org>
Reviewed-by: Mary Ruthven <mruthven@chromium.org>
Reviewed-by: Andrey Pronin <apronin@chromium.org>

1 files changed, 0 insertions, 225 deletions

diff --git a/chip/it83xx/intc.c b/chip/it83xx/intc.c
deleted file mode 100644
index 8783a76983..0000000000
--- a/chip/it83xx/intc.c
+++ /dev/null
@@ -1,225 +0,0 @@
-/* Copyright 2015 The Chromium OS Authors. All rights reserved.
- * Use of this source code is governed by a BSD-style license that can be
- * found in the LICENSE file.
- */
-
-#include "common.h"
-#include "intc.h"
-#include "it83xx_pd.h"
-#include "kmsc_chip.h"
-#include "registers.h"
-#include "task.h"
-#include "tcpm.h"
-#include "usb_pd.h"
-
-#ifdef CONFIG_USB_PD_TCPM_ITE83XX
-static void chip_pd_irq(enum usbpd_port port)
-{
-	task_clear_pending_irq(usbpd_ctrl_regs[port].irq);
-
-	/* check status */
-	if (USBPD_IS_HARD_RESET_DETECT(port)) {
-		/* clear interrupt */
-		IT83XX_USBPD_ISR(port) = USBPD_REG_MASK_HARD_RESET_DETECT;
-		task_set_event(PD_PORT_TO_TASK_ID(port),
-			PD_EVENT_TCPC_RESET, 0);
-	} else {
-		if (USBPD_IS_RX_DONE(port)) {
-			tcpm_enqueue_message(port);
-			/* clear RX done interrupt */
-			IT83XX_USBPD_ISR(port) = USBPD_REG_MASK_MSG_RX_DONE;
-		}
-		if (USBPD_IS_TX_DONE(port)) {
-			/* clear TX done interrupt */
-			IT83XX_USBPD_ISR(port) = USBPD_REG_MASK_MSG_TX_DONE;
-			task_set_event(PD_PORT_TO_TASK_ID(port),
-				TASK_EVENT_PHY_TX_DONE, 0);
-		}
-#ifdef IT83XX_INTC_PLUG_IN_SUPPORT
-		if (USBPD_IS_PLUG_IN_OUT_DETECT(port)) {
-			/*
-			 * When tcpc detect type-c plug in, then disable
-			 * this interrupt. Because any cc volt changes
-			 * (include pd negotiation) would trigger plug in
-			 * interrupt, frequently plug in interrupt and wakeup
-			 * pd task may cause task starvation or device dead
-			 * (ex.transmit lots SRC_Cap).
-			 *
-			 * When polling disconnect will enable detect type-c
-			 * plug in again.
-			 *
-			 * Clear detect type-c plug in interrupt status.
-			 */
-			IT83XX_USBPD_TCDCR(port) |=
-				(USBPD_REG_PLUG_IN_OUT_DETECT_DISABLE |
-				 USBPD_REG_PLUG_IN_OUT_DETECT_STAT);
-			task_set_event(PD_PORT_TO_TASK_ID(port),
-				PD_EVENT_CC, 0);
-		}
-#endif //IT83XX_INTC_PLUG_IN_SUPPORT
-	}
-}
-#endif
-
-void intc_cpu_int_group_5(void)
-{
-	/* Determine interrupt number. */
-	int intc_group_5 = intc_get_ec_int();
-
-	switch (intc_group_5) {
-#if defined(CONFIG_HOSTCMD_X86) && defined(HAS_TASK_KEYPROTO)
-	case IT83XX_IRQ_KBC_OUT:
-		lpc_kbc_obe_interrupt();
-		break;
-
-	case IT83XX_IRQ_KBC_IN:
-		lpc_kbc_ibf_interrupt();
-		break;
-#endif
-	default:
-		break;
-	}
-}
-DECLARE_IRQ(CPU_INT_GROUP_5, intc_cpu_int_group_5, 2);
-
-void intc_cpu_int_group_4(void)
-{
-	/* Determine interrupt number. */
-	int intc_group_4 = intc_get_ec_int();
-
-	switch (intc_group_4) {
-#ifdef CONFIG_HOSTCMD_X86
-	case IT83XX_IRQ_PMC_IN:
-		pm1_ibf_interrupt();
-		break;
-
-	case IT83XX_IRQ_PMC2_IN:
-		pm2_ibf_interrupt();
-		break;
-
-	case IT83XX_IRQ_PMC3_IN:
-		pm3_ibf_interrupt();
-		break;
-
-	case IT83XX_IRQ_PMC4_IN:
-		pm4_ibf_interrupt();
-		break;
-
-	case IT83XX_IRQ_PMC5_IN:
-		pm5_ibf_interrupt();
-		break;
-#endif
-	default:
-		break;
-	}
-}
-DECLARE_IRQ(CPU_INT_GROUP_4, intc_cpu_int_group_4, 2);
-
-void intc_cpu_int_group_12(void)
-{
-	/* Determine interrupt number. */
-	int intc_group_12 = intc_get_ec_int();
-
-	switch (intc_group_12) {
-#ifdef CONFIG_PECI
-	case IT83XX_IRQ_PECI:
-		peci_interrupt();
-		break;
-#endif
-#ifdef CONFIG_HOSTCMD_ESPI
-	case IT83XX_IRQ_ESPI:
-		espi_interrupt();
-		break;
-
-	case IT83XX_IRQ_ESPI_VW:
-		espi_vw_interrupt();
-		break;
-#endif
-#ifdef CONFIG_USB_PD_TCPM_ITE83XX
-	case IT83XX_IRQ_USBPD0:
-		chip_pd_irq(USBPD_PORT_A);
-		break;
-
-	case IT83XX_IRQ_USBPD1:
-		chip_pd_irq(USBPD_PORT_B);
-		break;
-#endif /* CONFIG_USB_PD_TCPM_ITE83XX */
-	default:
-		break;
-	}
-}
-DECLARE_IRQ(CPU_INT_GROUP_12, intc_cpu_int_group_12, 2);
-
-void intc_cpu_int_group_7(void)
-{
-	/* Determine interrupt number. */
-	int intc_group_7 = intc_get_ec_int();
-
-	switch (intc_group_7) {
-#ifdef CONFIG_ADC
-	case IT83XX_IRQ_ADC:
-		adc_interrupt();
-		break;
-#endif
-	default:
-		break;
-	}
-}
-DECLARE_IRQ(CPU_INT_GROUP_7, intc_cpu_int_group_7, 2);
-
-void intc_cpu_int_group_6(void)
-{
-	/* Determine interrupt number. */
-	int intc_group_6 = intc_get_ec_int();
-
-	switch (intc_group_6) {
-#if defined(CONFIG_I2C_MASTER) || defined(CONFIG_I2C_SLAVE)
-	case IT83XX_IRQ_SMB_A:
-#ifdef CONFIG_I2C_SLAVE
-		if (IT83XX_SMB_SFFCTL & IT83XX_SMB_SAFE)
-			i2c_slv_interrupt(IT83XX_I2C_CH_A);
-		else
-#endif
-			i2c_interrupt(IT83XX_I2C_CH_A);
-		break;
-
-	case IT83XX_IRQ_SMB_B:
-		i2c_interrupt(IT83XX_I2C_CH_B);
-		break;
-
-	case IT83XX_IRQ_SMB_C:
-		i2c_interrupt(IT83XX_I2C_CH_C);
-		break;
-
-	case IT83XX_IRQ_SMB_D:
-#ifdef CONFIG_I2C_SLAVE
-		if (!(IT83XX_I2C_CTR(3) & IT83XX_I2C_MODE))
-			i2c_slv_interrupt(IT83XX_I2C_CH_D);
-		else
-#endif
-			i2c_interrupt(IT83XX_I2C_CH_D);
-		break;
-
-	case IT83XX_IRQ_SMB_E:
-#ifdef CONFIG_I2C_SLAVE
-		if (!(IT83XX_I2C_CTR(0) & IT83XX_I2C_MODE))
-			i2c_slv_interrupt(IT83XX_I2C_CH_E);
-		else
-#endif
-			i2c_interrupt(IT83XX_I2C_CH_E);
-		break;
-
-	case IT83XX_IRQ_SMB_F:
-#ifdef CONFIG_I2C_SLAVE
-		if (!(IT83XX_I2C_CTR(1) & IT83XX_I2C_MODE))
-			i2c_slv_interrupt(IT83XX_I2C_CH_F);
-		else
-#endif
-			i2c_interrupt(IT83XX_I2C_CH_F);
-		break;
-#endif
-	default:
-		break;
-	}
-}
-DECLARE_IRQ(CPU_INT_GROUP_6, intc_cpu_int_group_6, 2);