diff options
| -rw-r--r-- | board/eve/board.c | 48 |
1 files changed, 16 insertions, 32 deletions
diff --git a/board/eve/board.c b/board/eve/board.c index d9f99fa7aa..aed81eccbb 100644 --- a/board/eve/board.c +++ b/board/eve/board.c @@ -644,38 +644,6 @@ static void board_lid_change(void) } DECLARE_HOOK(HOOK_LID_CHANGE, board_lid_change, HOOK_PRIO_DEFAULT); -void board_hibernate_late(void) -{ - int i; - const uint32_t hibernate_pins[][2] = { - {GPIO_LID_OPEN, GPIO_INT_RISING}, - /* - * BD99956 handles charge input automatically. We'll disable - * charge output in hibernate. Charger will assert ACOK_OD - * when VBUS or VCC are plugged in. - */ - {GPIO_USB_C0_5V_EN, GPIO_INPUT | GPIO_PULL_DOWN}, - {GPIO_USB_C1_5V_EN, GPIO_INPUT | GPIO_PULL_DOWN}, - }; - - /* Change GPIOs' state in hibernate for better power consumption */ - for (i = 0; i < ARRAY_SIZE(hibernate_pins); ++i) - gpio_set_flags(hibernate_pins[i][0], hibernate_pins[i][1]); - - gpio_config_module(MODULE_KEYBOARD_SCAN, 0); - - /* - * Calling gpio_config_module sets disabled alternate function pins to - * GPIO_INPUT. But to prevent keypresses causing leakage currents - * while hibernating we want to enable GPIO_PULL_UP as well. - */ - gpio_set_flags_by_mask(0x2, 0x03, GPIO_INPUT | GPIO_PULL_UP); - gpio_set_flags_by_mask(0x1, 0x7F, GPIO_INPUT | GPIO_PULL_UP); - gpio_set_flags_by_mask(0x0, 0xE0, GPIO_INPUT | GPIO_PULL_UP); - /* KBD_KS02 needs to have a pull-down enabled to match cr50 */ - gpio_set_flags_by_mask(0x1, 0x80, GPIO_INPUT | GPIO_PULL_DOWN); -} - void board_hibernate(void) { /* Enable both the VBUS & VCC ports before entering PG3 */ @@ -683,6 +651,22 @@ void board_hibernate(void) /* Turn BGATE OFF for power saving */ bd9995x_set_power_save_mode(BD9995X_PWR_SAVE_MAX); + + /* Shut down PMIC */ + CPRINTS("Triggering PMIC shutdown"); + uart_flush_output(); + if (i2c_write8(I2C_PORT_PMIC, I2C_ADDR_BD99992, 0x49, 0x01)) { + /* + * If we can't tell the PMIC to shutdown, instead reset + * and don't start the AP. Hopefully we'll be able to + * communicate with the PMIC next time. + */ + CPRINTS("PMIC I2C failed"); + uart_flush_output(); + system_reset(SYSTEM_RESET_LEAVE_AP_OFF); + } + while (1) + ; } static int gpio_get_ternary(enum gpio_signal gpio) |