diff options
Diffstat (limited to 'board/nucleo-g431rb/board.h')
-rw-r--r-- | board/nucleo-g431rb/board.h | 72 |
1 files changed, 0 insertions, 72 deletions
diff --git a/board/nucleo-g431rb/board.h b/board/nucleo-g431rb/board.h deleted file mode 100644 index a65daa4364..0000000000 --- a/board/nucleo-g431rb/board.h +++ /dev/null @@ -1,72 +0,0 @@ -/* Copyright 2020 The Chromium OS Authors. All rights reserved. - * Use of this source code is governed by a BSD-style license that can be - * found in the LICENSE file. - */ - -/* STM32G431 Nucleo-64 board configuration */ - -#ifndef __CROS_EC_BOARD_H -#define __CROS_EC_BOARD_H - -/* Optional features */ -#define CONFIG_SYSTEM_UNLOCKED /* Allow dangerous commands while in dev. */ - -#define CPU_CLOCK 48000000 -#define CONFIG_STM_HWTIMER32 -#define TIM_CLOCK32 2 -#define TIM_CLOCK_MSB 3 -#define TIM_CLOCK_LSB 15 -#define TIM_WATCHDOG 7 - -/* Nucelo platform does not have a lid switch */ -#undef CONFIG_LID_SWITCH - - -/* Setup UART console */ -/* - * The STM32G431 Nucleo-64 has two UARTs which can be connected to the virtual - * com port(VCP) of the STLINK chip. The VCP to STM32G4 connection depends on - * solder bridge configuration. The default configuration is VCP to LUPAURT - * (PA2/PA3). In order to reuse existing stm32 uart drivers, UART9 is used to - * indicate that lpuart is being used. - * - * The STM32G4 has a DMAMUX and so both the DMA channel and DMAMUX request - * numbers need to be specified here. - */ -#define STM32G431_EVAL_USE_LPUART_CONSOLE -#undef CONFIG_UART_CONSOLE -#define CONFIG_UART_TX_DMA -#undef CONFIG_UART_TX_BUF_SIZE -#define CONFIG_UART_TX_BUF_SIZE 2048 - -#ifdef STM32G431_EVAL_USE_LPUART_CONSOLE -#define CONFIG_UART_CONSOLE 9 -#define CONFIG_UART_TX_DMA_CH STM32_DMAC_LPUART_TX -#define CONFIG_UART_TX_DMA_PH DMAMUX_REQ_UART9_TX -#else -#define CONFIG_UART_CONSOLE 1 -#define CONFIG_UART_TX_DMA_CH STM32_DMAC_USART1_TX -#define CONFIG_UART_TX_DMA_PH DMAMUX_REQ_USART1_TX -#endif - - -/* - * Macros for GPIO signals used in common code that don't match the - * schematic names. Signal names in gpio.inc match the schematic and are - * then redefined here to so it's more clear which signal is being used for - * which purpose. - */ -#define GPIO_ENTERING_RW GPIO_EC_ENTERING_RW -#define GPIO_WP_L GPIO_EC_WP_L - - - -#ifndef __ASSEMBLER__ - -#include "gpio_signal.h" -#include "registers.h" - - -#endif /* !__ASSEMBLER__ */ - -#endif /* __CROS_EC_BOARD_H */ |