diff options
Diffstat (limited to 'board/pompom')
| -rw-r--r-- | board/pompom/gpio.inc | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/board/pompom/gpio.inc b/board/pompom/gpio.inc index 9d2a453ee0..74dbc2d6b5 100644 --- a/board/pompom/gpio.inc +++ b/board/pompom/gpio.inc @@ -22,9 +22,9 @@ GPIO_INT(EC_VOLUP_BTN_ODL, PIN(F, 2), GPIO_INT_BOTH | GPIO_PULL_UP, button_inte GPIO_INT(EC_WP_ODL, PIN(A, 1), GPIO_INT_BOTH, switch_interrupt) /* Write protection */ GPIO_INT(LID_OPEN_EC, PIN(D, 2), GPIO_INT_BOTH, lid_interrupt) /* Lid open */ GPIO_INT(AP_RST_L, PIN(C, 1), GPIO_INT_BOTH | GPIO_SEL_1P8V, chipset_ap_rst_interrupt) /* PMIC to signal AP reset */ -GPIO_INT(PS_HOLD, PIN(A, 4), GPIO_INT_BOTH | GPIO_PULL_DOWN | GPIO_SEL_1P8V, power_signal_interrupt) /* Indicate when AP triggers reset/shutdown */ -GPIO_INT(PMIC_FAULT_L, PIN(A, 3), GPIO_INT_BOTH | GPIO_SEL_1P8V, power_signal_interrupt) /* Any PMIC fault? */ -GPIO_INT(AP_SUSPEND, PIN(5, 7), GPIO_INT_BOTH | GPIO_SEL_1P8V, power_signal_interrupt) /* Suspend signal from PMIC */ +GPIO_INT(PS_HOLD, PIN(A, 4), GPIO_INT_BOTH | GPIO_PULL_DOWN, power_signal_interrupt) /* Indicate when AP triggers reset/shutdown */ +GPIO_INT(PMIC_FAULT_L, PIN(A, 3), GPIO_INT_BOTH, power_signal_interrupt) /* Any PMIC fault? */ +GPIO_INT(AP_SUSPEND, PIN(5, 7), GPIO_INT_BOTH, power_signal_interrupt) /* Suspend signal from PMIC */ GPIO_INT(DEPRECATED_AP_RST_REQ, PIN(C, 2), GPIO_INT_BOTH | GPIO_PULL_DOWN | GPIO_SEL_1P8V, power_signal_interrupt) /* Deprecated AP initiated reset indicator */ /* * When switch-cap is off, the POWER_GOOD signal is floating. Need a pull-down @@ -38,7 +38,7 @@ GPIO_INT(AP_EC_SPI_CS_L, PIN(5, 3), GPIO_INT_FALLING | GPIO_PULL_DOWN, shi_cs /* Sensor interrupts */ GPIO_INT(LID_360_L, PIN(7, 2), GPIO_INT_BOTH, gmr_tablet_switch_isr) -GPIO_INT(ACCEL_GYRO_INT_L, PIN(A, 0), GPIO_INT_FALLING | GPIO_SEL_1P8V, bmi160_interrupt) /* Accelerometer/gyro interrupt */ +GPIO_INT(ACCEL_GYRO_INT_L, PIN(A, 0), GPIO_INT_FALLING, bmi160_interrupt) /* Accelerometer/gyro interrupt */ /* * EC_RST_ODL acts as a wake source from hibernate mode. However, it does not @@ -49,8 +49,8 @@ GPIO(EC_ENTERING_RW, PIN(E, 1), GPIO_OUT_LOW) /* Indicate when EC is en GPIO(EC_BATT_PRES_ODL, PIN(E, 5), GPIO_INPUT) /* Battery Present */ /* PMIC/AP 1.8V */ -GPIO(PM7180_RESIN_D_L, PIN(3, 2), GPIO_ODR_HIGH | GPIO_SEL_1P8V) /* PMIC reset trigger */ -GPIO(PMIC_KPD_PWR_ODL, PIN(D, 6), GPIO_ODR_HIGH | GPIO_SEL_1P8V) /* PMIC power button */ +GPIO(PM7180_RESIN_D_L, PIN(3, 2), GPIO_ODR_HIGH) /* PMIC reset trigger */ +GPIO(PMIC_KPD_PWR_ODL, PIN(D, 6), GPIO_ODR_HIGH) /* PMIC power button */ GPIO(EC_INT_L, PIN(A, 2), GPIO_ODR_HIGH) /* Interrupt line between AP and EC */ GPIO(QSIP_ON, PIN(5, 0), GPIO_OUT_LOW) /* Not used, for non-switchcap testing */ |