summaryrefslogtreecommitdiff
path: root/common
diff options
context:
space:
mode:
Diffstat (limited to 'common')
-rw-r--r--common/gaia_power.c9
-rw-r--r--common/pmu_tps65090.c67
2 files changed, 45 insertions, 31 deletions
diff --git a/common/gaia_power.c b/common/gaia_power.c
index 1b3cc61a2a..441f46f634 100644
--- a/common/gaia_power.c
+++ b/common/gaia_power.c
@@ -437,6 +437,8 @@ static int react_to_xpshold(unsigned int timeout_us)
*/
static void power_off(void)
{
+ int pmu_shutdown_retries = 3;
+
/* Call hooks before we drop power rails */
hook_notify(HOOK_CHIPSET_SHUTDOWN, 0);
/* switch off all rails */
@@ -449,7 +451,12 @@ static void power_off(void)
lid_changed = 0;
enable_sleep(SLEEP_MASK_AP_RUN);
powerled_set_state(POWERLED_STATE_OFF);
- if (pmu_shutdown())
+
+ while (--pmu_shutdown_retries >= 0) {
+ if (!pmu_shutdown())
+ break;
+ }
+ if (pmu_shutdown_retries < 0)
board_hard_reset();
CPUTS("Shutdown complete.\n");
}
diff --git a/common/pmu_tps65090.c b/common/pmu_tps65090.c
index 23027cd6a1..8d6d27a170 100644
--- a/common/pmu_tps65090.c
+++ b/common/pmu_tps65090.c
@@ -473,50 +473,57 @@ DECLARE_HOOK(HOOK_CHIPSET_PRE_INIT, pmu_init_registers, HOOK_PRIO_DEFAULT);
void pmu_init(void)
{
- int failure = 0;
+ int failure = 0, retries_remaining = 3;
+ while (--retries_remaining >= 0) {
+ failure = 0;
#ifdef CONFIG_PMU_BOARD_INIT
- if (!failure)
- failure = board_pmu_init();
+ if (!failure)
+ failure = board_pmu_init();
#else
- /* Init configuration
- * Fast charge timer : 2 hours
- * Charger : disable
- * External pin control : enable
- *
- * TODO: move settings to battery pack specific init
- */
- if (!failure)
- failure = pmu_write(CG_CTRL0, 2);
- /* Limit full charge current to 50%
- * TODO: remove this temporary hack.
- */
- if (!failure)
- failure = pmu_write(CG_CTRL3, 0xbb);
+ /* Init configuration
+ * Fast charge timer : 2 hours
+ * Charger : disable
+ * External pin control : enable
+ *
+ * TODO: move settings to battery pack specific init
+ */
+ if (!failure)
+ failure = pmu_write(CG_CTRL0, 2);
+ /* Limit full charge current to 50%
+ * TODO: remove this temporary hack.
+ */
+ if (!failure)
+ failure = pmu_write(CG_CTRL3, 0xbb);
#endif
- /* Enable interrupts */
- if (!failure) {
- failure = pmu_write(IRQ1MASK,
+ /* Enable interrupts */
+ if (!failure) {
+ failure = pmu_write(IRQ1MASK,
EVENT_VACG | /* AC voltage good */
EVENT_VSYSG | /* System voltage good */
EVENT_VBATG | /* Battery voltage good */
EVENT_CGACT | /* Charging status */
EVENT_CGCPL); /* Charging complete */
- }
- if (!failure)
- failure = pmu_write(IRQ2MASK, 0);
- if (!failure)
- failure = pmu_clear_irq();
+ }
+ if (!failure)
+ failure = pmu_write(IRQ2MASK, 0);
+ if (!failure)
+ failure = pmu_clear_irq();
- /* Enable charger interrupt. */
- if (!failure)
- failure = gpio_enable_interrupt(GPIO_CHARGER_INT);
+ /* Enable charger interrupt. */
+ if (!failure)
+ failure = gpio_enable_interrupt(GPIO_CHARGER_INT);
#ifdef CONFIG_AC_POWER_STATUS
- if (!failure)
- failure = gpio_set_flags(GPIO_AC_STATUS, GPIO_OUT_HIGH);
+ if (!failure)
+ failure = gpio_set_flags(GPIO_AC_STATUS, GPIO_OUT_HIGH);
#endif
+ /* Exit the retry loop if there was no failure */
+ if (!failure)
+ break;
+ }
+
if (failure)
board_hard_reset();
}