diff options
Diffstat (limited to 'zephyr/Kconfig.charger')
-rw-r--r-- | zephyr/Kconfig.charger | 30 |
1 files changed, 0 insertions, 30 deletions
diff --git a/zephyr/Kconfig.charger b/zephyr/Kconfig.charger index c2c6eeb3f4..f408797d17 100644 --- a/zephyr/Kconfig.charger +++ b/zephyr/Kconfig.charger @@ -63,21 +63,6 @@ config PLATFORM_EC_CHARGE_MANAGER source is available on the hardware, so cannot be built without PLATFORM_EC_USBC. -config PLATFORM_EC_CHARGE_STATE_DEBUG - bool "Debug information about the charge state" - depends on PLATFORM_EC_CHARGE_MANAGER - help - Enables debug information regarding the current charge state. Enabling - this config will allow the EC_CMD_CHARGE_STATE host command to use the - CHARGE_STATE_CMD_GET_PARAM command to query the current charge state. - -config PLATFORM_EC_CMD_PWR_AVG - bool "Enable the console command to print power average" - depends on PLATFORM_EC_CHARGE_MANAGER - help - Enables the console command which prints out the current (past 1 - minute) power average. - config PLATFORM_EC_CHARGESPLASH bool "Charging splashscreen support" help @@ -186,8 +171,6 @@ config PLATFORM_EC_CHARGER_RAA489000 config PLATFORM_EC_CHARGER_RT9490 bool "Use the RT9490 charger" - default y - depends on DT_HAS_RICHTEK_RT9490_ENABLED || DT_HAS_ZEPHYR_RT9490_EMUL_ENABLED depends on PLATFORM_EC_I2C select PLATFORM_EC_CHARGER_OTG_SUPPORTED help @@ -204,12 +187,6 @@ config PLATFORM_EC_CHARGER_SM5803 Enables the driver for the SM5803. The SM5803 is the Silicon Mitus SM5803 Buck-Boost Charger. - This charger is known to be very inefficient when operating in buck-boost - mode (when input voltage is close to output voltage), such that permanent - damage may be done to the charger. Users should exercise caution around - choice of supported configurations: see b:260271871, b:258754576, and - b:230712704 for more information. - if PLATFORM_EC_OCPC @@ -222,13 +199,6 @@ config PLATFORM_EC_OCPC_DEF_RBATT_MOHMS This should be at a minimum the Rds(on) resistance of the BFET plus the series sense resistor. -config PLATFORM_EC_OCPC_DEF_DRIVELIMIT_MILLIVOLTS - int "Drive Limit for the OCPC PID control loop" - default 10 - help - Sets how agressively the OCPC PID control loop can adjust VSYS to drive - the battery with the correct current. - endif # PLATFORM_EC_OCPC config PLATFORM_EC_CHARGER_DISCHARGE_ON_AC |