summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
...
* rammus: Fix power leakagemichael_chen2018-10-092-3/+10
* atlas: add internal pullup to unused pinCaveh Jalali2018-10-091-0/+1
* atlas: fix chip variant configCaveh Jalali2018-10-091-1/+1
* cr50: rename a power-button press ISR.Namyoon Woo2018-10-081-3/+3
* Ampton: confirm thermistor partsDiana Z2018-10-081-1/+0
* intel_x86: Clear SCI/SMI masks only after host enters S0ixFurquan Shaikh2018-10-081-42/+43
* iteflash: make use of 256 byte pages when programming over CCDVadim Bendebury2018-10-081-6/+18
* iteflash: tweak verify_flash()Vadim Bendebury2018-10-081-3/+4
* iteflash: do not erase by defaultVadim Bendebury2018-10-082-2/+2
* usb-pd: allow a task to prevent TCPC LPMJett Rink2018-10-052-2/+33
* usb_i2c: provide a way to communicate non-i2c commandsVadim Bendebury2018-10-052-1/+48
* touchpad_st: log heatmap enable / disableWei-Han Chen2018-10-051-1/+4
* touchpad_st: update touchpad hung detection logicWei-Han Chen2018-10-051-8/+41
* grunt: Raise some task sizesJonathan Brandmeyer2018-10-054-20/+20
* grunt: Add minimal analyzestack configurationsJonathan Brandmeyer2018-10-055-0/+6
* careena, liara, aleena: Remove motion sensing supportJonathan Brandmeyer2018-10-0411-42/+20
* FIXUP: mkbp: add support for board-specific host notificationEnrico Granata2018-10-042-8/+34
* flash_ec: Disable the flashing-mode trigger for normal UART operationWai-Hong Tam2018-10-041-8/+28
* touchpad_st: read event fifo in heatmap modeWei-Han Chen2018-10-041-0/+4
* tcpc: Resume suspended ports after an intervalJonathan Brandmeyer2018-10-048-7/+71
* tcpc: Simplify ANX74XX device selectionJonathan Brandmeyer2018-10-042-3/+8
* glados: Increase size of RO segmentJonathan Brandmeyer2018-10-041-1/+1
* cheza: Reenable EC hibernateWai-Hong Tam2018-10-043-5/+28
* cheza: Turn off 3.3V rail on S5Wai-Hong Tam2018-10-042-4/+5
* kukui: Enable magnetometer.Yilun Lin2018-10-042-0/+28
* mag_cal: Support fixed-point calculation.Yilun Lin2018-10-0414-162/+554
* math_util: Support fp_div_dbz which handling division-by-zero error.Yilun Lin2018-10-041-0/+24
* touchpad_st: error event info is little endianWei-Han Chen2018-10-041-2/+2
* mt8183: Hold power button 10s for hard shutdown.Yilun Lin2018-10-041-2/+2
* rma: when processing 'RMA open' do not reboot the deviceVadim Bendebury2018-10-045-19/+56
* g: update test RO to allow self-signed RWs.Marius Schilder2018-10-043-55/+18
* grunt: Reduce PD turn off delayEdward Hill2018-10-041-4/+2
* octopus: remove CONFIG_SYSTEM_UNLOCKED optionJett Rink2018-10-045-15/+0
* Fleex:Add define OCTOPUS_BATT_FUEL_LOW_LEDmatt_wang2018-10-042-0/+3
* grunt: Move KSI03 HW bug work around out of baseboardEdward Hill2018-10-042-2/+4
* DragonEgg: Correct initial value of EC_PCH_RSMRST_LScott Collyer2018-10-041-1/+1
* DragonEgg: Change USB_A_HIGH_POWER to push-pullScott Collyer2018-10-042-2/+2
* touchpad_st: scale major & minorWei-Han Chen2018-10-041-2/+2
* touchpad_st: new error types: 0xf1, 0xf2, 0xf3Wei-Han Chen2018-10-041-6/+7
* touchpad_st: memory corruption detectionWei-Han Chen2018-10-041-25/+121
* cheza: Change GPIO for the rev-3 boardWai-Hong Tam2018-10-031-13/+11
* cheza: Enable low power idle modeRaviChandra Sadineni2018-10-031-0/+1
* cheza: Fix bmi160 interrupt pin settingPhilip Chen2018-10-031-1/+1
* FIXUP: sensor: Add flag for tight timestampingGwendal Grignou2018-10-031-0/+2
* cheza: Enable host commands flashspiinfo and uptimeinfoWai-Hong Tam2018-10-031-0/+2
* Aleena: Add GPIO-controlled tables for LED statusBen Chen2018-10-034-71/+55
* touchpad_st: show status report from STWei-Han Chen2018-10-032-1/+28
* octopus: motion_sense: provide option to defer the sensor resume actionsHarry Pan2018-10-031-0/+5
* grunt: Remove no longer needed GPIO_EN_PP5000Edward Hill2018-10-024-12/+0
* cheza: Enable CONFIG_VBOOT_HASHWai-Hong Tam2018-10-021-0/+2
View Lorry Controller Status