summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
* fuzz: Hide conflicts with cstdlib and use clang++ for linking.Allen Webb2018-09-077-24/+73
* tcpm:it83xx: GRL-USB-PD TDA2.1.2.2 BIST testRuibin Chang2018-09-0710-0/+45
* rammus: add CONFIG_BOARD_VERSION_CBI to enable board version queryZhuohao Lee2018-09-071-0/+1
* Liara: Add supported batteriesJonathan Brandmeyer2018-09-053-6/+79
* npcx: Decide erase size based on ro/rw region sizeFurquan Shaikh2018-09-055-10/+41
* grunt: Enable CONFIG_I2C_BUS_MAY_BE_UNPOWEREDEdward Hill2018-09-052-1/+11
* bip: use PS8751 HPD status function for C1Jett Rink2018-09-051-1/+1
* ss-mux: update semantics for TCPC/MUX only used as MUXJett Rink2018-09-0518-176/+181
* cr50: Make SN data available through vNVRAM.Louis Collard2018-09-051-1/+14
* cr50: Add commands to get/set serial number bits.Louis Collard2018-09-0512-31/+416
* flash_ec: add rammus boardZhuohao Lee2018-09-051-0/+2
* driver: accel: Prevent ODR from crashing the ECGwendal Grignou2018-09-053-32/+21
* driver: lsm6dsm: Allow roundup to work below 13HzGwendal Grignou2018-09-051-1/+1
* iteflash : enable global resetDonald Huang2018-09-051-8/+16
* ICL: Modify force_shutdown to meet PCH timing requirementsScott Collyer2018-09-051-3/+10
* DragonEgg: Add support to Type C port 1Scott Collyer2018-09-046-4/+53
* ppc: Add driver for Silergy SYV682x PPCScott Collyer2018-09-044-0/+396
* hwtimer: Tidy up and clarify some hw_clock commentsSimon Glass2018-09-041-3/+20
* chip/npcx: Tidy up comments for init_hw_timer()Simon Glass2018-09-042-2/+9
* octopus: consolidate identical definesJett Rink2018-09-047-24/+9
* octopus: enabled DPTF device orientationJett Rink2018-09-046-13/+2
* bip: add tablet mode for consistencyJett Rink2018-09-043-0/+8
* cr50: fix sps driver sync problemsVadim Bendebury2018-09-043-90/+21
* Add CONFIG_GPIO_INIT_POWER_ON_DELAY_MSEdward Hill2018-09-045-3/+58
* Phaser: support quick charge function of batteryHuangGe Haha2018-09-041-0/+44
* cbi: fail set command early if WP is assertedJett Rink2018-09-041-5/+12
* flash_ec: Look for npcx_monitor.bin in the same dir as ec.binRaul E Rangel2018-09-041-0/+10
* tablet-mode: add disable functionJett Rink2018-09-042-0/+26
* Bobba: Set motion_sensor_count to 0 for clamshellsTino Liu2018-09-041-2/+2
* servo_micro: Increase USB stream TX size to 64 bytesNicolas Boichat2018-09-041-1/+1
* npcx: WoV: enhance the WoV driver and fix bugsCHLin2018-09-035-157/+401
* usb_hid_keyboard: Keep tablet mode status when clearing reportNicolas Boichat2018-09-031-0/+9
* cheza: Disable the base explicitly in S5Wai-Hong Tam2018-09-031-4/+17
* usb_update: add extra command "UPDATE_EXTRA_CMD_CONSOLE_READ_*"Wei-Han Chen2018-09-035-16/+101
* driver/touchpad_st: add more debug commandsWei-Han Chen2018-09-032-1/+49
* usb_hid_touchpad: fix report count of device capabilitiesWei-Han Chen2018-09-031-1/+1
* it83xx: espi: write-1 clear bug of VMCTRL1 registertim2018-09-032-7/+7
* whiskers: Drive DETECT_PATH_DISABLE_L low, pull-up on BACKLIGHT_ENNicolas Boichat2018-09-031-1/+2
* iteflash : fix program page addressDonald Huang2018-09-031-7/+8
* whiskers: Disable keyboard scanning and touchpad in tablet modeNicolas Boichat2018-09-033-30/+105
* meep: Add Power LED behaviorZick Wei2018-09-023-10/+44
* rammus: Fix the dut keeps reboot due to the EC assert.Zhuohao Lee2018-09-021-6/+5
* cheza: Enable floating point unitWai-Hong Tam2018-08-311-0/+1
* cheza: Enable some button featuresWai-Hong Tam2018-08-311-0/+3
* rammus: decrease UART bufferJett Rink2018-08-311-1/+1
* cleanup: remove tcpc* extern function declarationsJett Rink2018-08-312-16/+20
* nocturne: Use USBC alert signal for TCPC alert statusScott Collyer2018-08-311-10/+14
* grunt: Configure ANX3429 interrupt as open-drainEdward Hill2018-08-311-0/+1
* meep: add VBUS voltage adc sensingDevin Lu2018-08-313-0/+29
* rammus: rammus: Modify TCPC port1 I2C bus to I2C0_0 from I2C0_1.michael_chen2018-08-311-1/+1
View Lorry Controller Status