summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
* ite: exclude keyboard interrupts if no keyboard taskJett Rink2018-03-293-7/+8
* battery_temp: initial commit.Todd Broch2018-03-291-0/+56
* atlas: add board name to flash_ecCaveh Jalali2018-03-291-0/+1
* yorp: Add tcpc alert handlingScott Collyer2018-03-291-6/+61
* charge_state_v2: Use lid and base batteries to determine if near fullNicolas Boichat2018-03-281-2/+15
* Nami: Multiple configurations of motion sensorsElthan_Huang2018-03-282-36/+65
* cr50: use system_rollback_detected to detect rollbackMary Ruthven2018-03-281-1/+1
* charge_state_v2: Hibernate base in S5 with no ACNicolas Boichat2018-03-283-5/+43
* common/ec_ec_comm_master/slave: Add support for EC hibernateNicolas Boichat2018-03-283-2/+63
* chgstv2: Notify charge state transitionDaisuke Nojiri2018-03-281-8/+16
* sweetberry: add current and voltage loggingNick Sanders2018-03-286-64/+230
* wand: Fix second UART module, remove unneeded internal pull-upNicolas Boichat2018-03-281-2/+2
* charge_state_v2: Add debugging command for dual-battery algoNicolas Boichat2018-03-281-0/+98
* yorp: Add support for LG and Panasonic batteriesScott Collyer2018-03-282-16/+378
* usbc: add default I2C addressesJett Rink2018-03-2813-30/+84
* chip/ite: add ADC constantsJett Rink2018-03-281-0/+5
* scarlet: Limit the maximal acceptable VBUS to 5.5VPhilip Chen2018-03-271-1/+1
* yorp: Fix I2C slave address for PPCScott Collyer2018-03-271-2/+2
* isl923x: Set OTG enable debounce time to 150msNicolas Boichat2018-03-271-0/+1
* meowth: zoombini: Enable CONFIG_VSTORE.Aseda Aboagye2018-03-271-0/+2
* g: add stream sniffing for DUT spiflash content.Marius Schilder2018-03-271-0/+11
* g: add missing define for UART register UART_VAL.Marius Schilder2018-03-271-0/+1
* cr50 release: use signer executable installed on chrootVadim Bendebury2018-03-271-4/+9
* yorp: Enable VSTORE config optionsFurquan Shaikh2018-03-271-0/+2
* driver/touchpad_st.c: implement touchpad fw updateWei-Han Chen2018-03-271-1/+232
* i2c: expose port num during unwedge console output.Todd Broch2018-03-261-4/+5
* nautilus: enable accel force mode mask on nautilusJongpil Jung2018-03-261-0/+3
* whiskers: enable ST touchpadWei-Han Chen2018-03-262-11/+61
* ec: add driver/touchpad_st.cWei-Han Chen2018-03-264-5/+732
* lpc: remove lpc_host_resetJett Rink2018-03-264-64/+0
* Remove the unnecessary words of "Disable touchpad" in the commentsKaiyen Chang2018-03-264-4/+8
* Nami: initial x,y,z-axis direction of lid and base g-sensorElmo_Lan2018-03-261-6/+6
* sensor: bmi160/bma2x2: Fix the timeout value of compensation.Marco Chen2018-03-262-2/+2
* yorp: update virtual wire note for PLT_RST_LJett Rink2018-03-261-1/+2
* bip: enable CONFIG_IT83XX_FLASH_CLOCK_48MHZ to support eSPI speed of 50MhzJett Rink2018-03-261-0/+3
* bip: add UART interrupt to exit deep doze modeJett Rink2018-03-262-3/+5
* bip: remove GPIO_HIB_WAKE_HIGH option GPIOJett Rink2018-03-261-2/+1
* stoney: Rename PGOOD GPIOsEdward Hill2018-03-269-28/+28
* Add config for boards that cannot distinguish reset typeDuncan Laurie2018-03-267-4/+13
* keyboard: Add config option for refresh key rowDuncan Laurie2018-03-263-0/+12
* intel_x86: Move chipset reset logic to common codeVijay Hiremath2018-03-254-50/+31
* apollolake: Remove AP cold reset logicVijay Hiremath2018-03-251-29/+8
* yorp: Switch on blue LED on boot-upFurquan Shaikh2018-03-243-0/+28
* Code cleanup: Rename GPIO PCH_RCIN_L to SYS_RESET_LVijay Hiremath2018-03-249-12/+12
* battery/max17055: Report the raw measured currentPhilip Chen2018-03-231-1/+1
* meowth: Add GPP_B14_STRAP pins for both SKUs.Aseda Aboagye2018-03-231-0/+5
* bip: add gpio definitionsJett Rink2018-03-231-1/+45
* tcpc: rename CONFIG_USB_PD_TCPM_ANX74XX to CONFIG_USB_PD_TCPM_ANX3429Jett Rink2018-03-239-9/+16
* yorp: Add config option for VBUS detectionScott Collyer2018-03-231-1/+1
* makefile: fix build time warningsVadim Bendebury2018-03-231-0/+2
View Lorry Controller Status