summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
* panic: Set EC_HOST_EVENT_PANIC on chipset resetFurquan Shaikh2017-11-301-1/+2
* software_panic: Add a new software panic type for PMIC faultFurquan Shaikh2017-11-301-0/+1
* nds32: enable GCC LTODino Li2017-11-306-12/+27
* g:sps: do not stall reset when CS is assertedVadim Bendebury2017-11-301-14/+0
* coral: disable tablet mode interrupt for clamshell models.Harry Pan2017-11-301-0/+7
* coral: never enter tablet mode for clamshell SKUs.Harry Pan2017-11-301-1/+6
* nami: initial setup for ecYH Lin2017-11-298-0/+1738
* nautilus: enable gyro and accelerometer.Jongpil Jung2017-11-292-130/+153
* ish: make ISH system_reset noreturnli feng2017-11-291-0/+2
* detachables: Updating button command to support multiple buttonsShelley Chen2017-11-291-30/+67
* coffeecake: Change host high pullup from Rp1500 to Rp3000Rong Chang2017-11-291-1/+1
* grunt: Enable CONFIG_BRINGUP.Justin TerAvest2017-11-291-0/+2
* coffeecake: Workaround P0 EN_USB_PD leakageRong Chang2017-11-293-17/+39
* coffeecake: Set PID to assigned one for Coffee CakeBenson Leung2017-11-291-1/+1
* coffeecake: Set to 22.5W maximum output via Type-C (2.5A @ 9V)Benson Leung2017-11-292-4/+4
* coffeecake: Set usb output voltage back to 5V on a power supply resetBenson Leung2017-11-291-0/+1
* coffeecake: Set Unconstrained Power (aka Ext) bit on 5V PDOBenson Leung2017-11-291-1/+4
* coffeecake: enable dual roleRong Chang2017-11-296-38/+182
* charger: add sy21612 buck-boost converter driverRong Chang2017-11-294-0/+379
* coffeecake: initial commitRong Chang2017-11-299-0/+874
* npcx: unset ESPIRSTWE bit to prevent ec cannot enter low power modeCHLin2017-11-282-2/+2
* nautilus: correct board id.Jongpil Jung2017-11-281-2/+2
* Coral: add Bruce features.Ryan Zhang2017-11-282-2/+3
* servo_updater: add better default argsNick Sanders2017-11-281-5/+55
* sb_fw_update: Get rid of CONFIG_SB_FIRMWARE_UPDATEFurquan Shaikh2017-11-285-396/+0
* intel_x86: Auto power-on after battery SOC is above minimum requiredFurquan Shaikh2017-11-281-5/+49
* cannonlake: Check for hard and soft off in chipset_force_shutdownFurquan Shaikh2017-11-281-1/+1
* skylake: Check for hard and soft off in chipset_force_shutdownFurquan Shaikh2017-11-281-1/+1
* chipset: Introduce CHIPSET_STATE_ANY_SUSPENDFurquan Shaikh2017-11-2812-18/+15
* charge_manager: Give dedicated chargers highest priorityDaisuke Nojiri2017-11-281-9/+9
* gsctool: add option to disable RMA modeVadim Bendebury2017-11-281-3/+15
* cr50: ccd: add vendor command to disable RMA modeVadim Bendebury2017-11-282-0/+70
* hostevents: Reclaim EC_HOST_EVENT_EXTENDED bitFurquan Shaikh2017-11-281-6/+0
* host_event_commands: Fix off-by-one errorFurquan Shaikh2017-11-281-1/+9
* charge_manager: Add EC_CMD_OVERRIDE_DEDICATED_CHARGER_LIMITDaisuke Nojiri2017-11-288-4/+48
* Separate VBUS detection and measurement mechanismsPhilip Chen2017-11-272-1/+12
* OPT3001: Support MOTIONSENSE_CMD_SENSOR_[OFFSET|RANGE] for calibration.Marco Chen2017-11-266-70/+87
* hammer: enable large block reading on usb i2c passthru.Chun-Ta Lin2017-11-245-54/+177
* ec: reconfigure GPIO60 to be INPUT | PULL_UP for power savingsRuben Rodriguez Buchillon2017-11-231-1/+1
* ec_commands: Add structs for host command protocol V4Randall Spangler2017-11-221-1/+135
* poppy/soraka/nautilus: Do not enable V5A in deep sleep stateFurquan Shaikh2017-11-222-38/+0
* nautilus: remove revision related code.Jongpil Jung2017-11-221-13/+1
* nautilus: Remove CONFIG_BUTTON_RECOVERYFurquan Shaikh2017-11-222-7/+0
* nautilus: Get rid of board_has_working_reset_flagsFurquan Shaikh2017-11-221-12/+0
* nautilus: remove base-related code.Jongpil Jung2017-11-222-173/+0
* nautilus: control power ledJongpil Jung2017-11-222-112/+74
* poppy/soraka: Add GPIO_SEL_1P8V flag for 1.8V pinsFurquan Shaikh2017-11-221-3/+3
* gsctool: clean up error processingVadim Bendebury2017-11-211-14/+31
* nautilus: enable touchpad,backlight and disable base.Jongpil Jung2017-11-212-21/+4
* nautilus: remove als.Jongpil Jung2017-11-214-22/+0