summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
* rose: add touchpad related host commandsWei-Ning Huang2017-06-072-0/+103
* scarlet: remove lid accel and add barometerphilipchen2017-06-072-29/+48
* Cr50: usb_updater: add commands to get/set board idVadim Bendebury2017-06-071-3/+131
* coral: Modify battery_info struct for 3S + 1P style batteryScott Collyer2017-06-062-513/+114
* stm32mon: Add support for STM32F412Gwendal Grignou2017-06-061-0/+1
* board: Add support for nucleo-f411reGwendal Grignou2017-06-068-25/+357
* cr50: usb_updater: do not send setup request unless necessaryVadim Bendebury2017-06-061-21/+26
* cr50: include more vendor commands into the USB setVadim Bendebury2017-06-061-1/+4
* cr50: usb_updater: add proper vendor command processingVadim Bendebury2017-06-061-39/+117
* scarlet: Adapt to the master branchPhilip Chen2017-06-065-37/+31
* scarlet: enable mkbpPhilip Chen2017-06-062-0/+7
* scarlet: Remove one usb type-c portphilipchen2017-06-065-59/+22
* scarlet: initial mainboardphilipchen2017-06-067-0/+1610
* eve: Set VCCIO rail to 0.85 and disable low powerDuncan Laurie2017-06-061-3/+2
* cr50: usb_updater: include return codes into USB response payloadVadim Bendebury2017-06-062-18/+34
* cr50: usb_upgrade: allow responses lager than requestsVadim Bendebury2017-06-062-5/+22
* rollback: Include board-generated entropy when adding entropyNicolas Boichat2017-06-063-4/+24
* hammer: Add board_get_entropy function (and test)Nicolas Boichat2017-06-065-0/+122
* isl9238: Enable system power monitor functionHarry Pan2017-06-062-0/+2
* g: add flag to delay int enable until board_initMary Ruthven2017-06-052-4/+6
* chip: g: Add support for UART bit banging.Aseda Aboagye2017-06-055-4/+570
* eve: Disable discharge-on-ac with board 5+Duncan Laurie2017-06-051-1/+1
* g: expand pinmux to print info on spi and i2cMary Ruthven2017-06-051-33/+40
* eve: Update LED behavior to match new specScott Collyer2017-06-053-97/+180
* cr50: implement an ASN.1 DER x.509 certificate builderVincent Palatin2017-06-052-3/+346
* usb_i2c: extend the protocol to support larger payloadChun-Ta Lin2017-06-054-14/+50
* BD9995X: Disable input current limiting for VBAT < VSYSREG_SETVijay Hiremath2017-06-032-1/+29
* poppy: Update led control logic to obey manual controlsNicolas Boichat2017-06-031-14/+20
* Add flash command support to boards with STM32F4Gwendal Grignou2017-06-038-385/+239
* hammer: Add support for new keyNicolas Boichat2017-06-024-2/+59
* stm32mon: Add offset/length parameter to read/write a particular memory regionGwendal Grignou2017-06-021-24/+33
* stm32mon: Add support for STM32F411Gwendal Grignou2017-06-021-27/+48
* stm32: cleanup flash-f by using constant from register.hGwendal Grignou2017-06-024-80/+122
* common: Add deferred erase supportGwendal Grignou2017-06-023-10/+107
* common: Add support for flash with regions of different sizeRong Chang2017-06-025-64/+257
* cr50: usb_upgrade: pass proper number of bytes to the vendor commandsVadim Bendebury2017-06-021-2/+5
* cr50: Add console and TPM vendor commands to get/set board IDPhilip Chen2017-06-026-10/+335
* eve: Swap volume up and down GPIODuncan Laurie2017-06-021-2/+3
* coral: GPIO modifications for differences from ReefScott Collyer2017-06-021-14/+10
* cr50: change the power button handlingVincent Palatin2017-06-021-8/+18
* cr50: configure flash counterVincent Palatin2017-06-023-9/+16
* Add non-volatile flash counterVincent Palatin2017-06-024-0/+287
* npcx: Fix response sizeGwendal Grignou2017-06-011-7/+14
* eve: default ALS config.Todd Broch2017-06-011-1/+1
* cr50: Have CCD_MODE_L respect "ccd keepalive".Aseda Aboagye2017-06-011-3/+4
* eve: Enable double tap gestureScott Collyer2017-06-012-5/+23
* eve: Enable gpio interrupt for bmi160 accelgyro sensorScott Collyer2017-06-011-0/+3
* sensor: Add board specific function for double tap eventScott Collyer2017-06-014-1/+18
* sensor: bmi160: Fix macro used to set double tap intersticeScott Collyer2017-05-311-1/+1
* codesigner: accept the new command line optionVadim Bendebury2017-05-312-2/+6