summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
* gsctool: add -B to override version sniffing.Marius Schilder2018-06-072-30/+40
* motion_sense: Remove unnecessary includeGwendal Grignou2018-06-071-1/+0
* Fizz: Add fan for WukongRyan.Zhang2018-06-072-34/+82
* Fizz: add CONFIG_BOARD_HAS_RTC_RESETRyan Zhang2018-06-075-4/+14
* gsctool: add support for wp vendor commandMary Ruthven2018-06-071-4/+47
* cr50: add vendor command to get wp settingMary Ruthven2018-06-072-0/+44
* charge_manager: Pass struct charge_port_info as constDaisuke Nojiri2018-06-072-3/+3
* careena: Add batteries configurationDevin Lu2018-06-072-19/+110
* octopus: remove ADCs for VBUSJett Rink2018-06-076-26/+1
* drivers/touchpad_st.c: wait full initialize by re-calling deferredWei-Han Chen2018-06-071-35/+34
* power: Rename rockchip to rk3288Nicolas Boichat2018-06-074-5/+4
* power: Rename mediatek to mt817xNicolas Boichat2018-06-076-7/+7
* nocturne: Change SYS_RST_L to open drain.Aseda Aboagye2018-06-071-1/+1
* cheza: Read board version from GPIO pinsPhilip Chen2018-06-071-1/+1
* Nami: Change battery config to AP15O5L for AkaliDaisuke Nojiri2018-06-071-14/+45
* phaser: update GPIO based on newest schematicsJett Rink2018-06-071-6/+7
* octopus: rename USB-C signal namesJett Rink2018-06-075-20/+20
* sn5s330: Track source enabled state locallyEdward Hill2018-06-071-34/+5
* usb_charger: Always update VBUS charge supplierEdward Hill2018-06-071-11/+8
* Nami: Set PD_MAX_POWER_MW to 70WDaisuke Nojiri2018-06-061-2/+2
* driver/touchpad_st.c: fix a bug in st_tp_resetWei-Han Chen2018-06-061-8/+12
* whiskers: Expose a switch for tablet modeNicolas Boichat2018-06-066-37/+98
* it83xx: espi: enable eSPI_reset#Dino Li2018-06-066-0/+45
* it83xx: espi: enable eSPI interruptDino Li2018-06-062-60/+172
* servo_v4: use coreboot toolchainNick Sanders2018-06-051-0/+2
* stoney: Rename GPIO_PCH_RCIN_L to GPIO_SYS_RESET_LJonathan Brandmeyer2018-06-054-5/+5
* Nami: Toggle Anx7447 reset line at start-upDaisuke Nojiri2018-06-052-6/+8
* atlas: config PCH_PWR_BTN as push-pullCaveh Jalali2018-06-052-2/+2
* atlas: fix GPIOC2/PWM1 functionCaveh Jalali2018-06-051-1/+1
* stoney: strip unused forcing_coldreset path.Jonathan Brandmeyer2018-06-041-12/+2
* stm32: use D-cache on STM32H7Vincent Palatin2018-06-045-7/+18
* bq25703: Report actual input current limitVijay Hiremath2018-06-042-1/+16
* cortex-m: add D-cache supportVincent Palatin2018-06-049-14/+159
* stm32: fix ignoring bus fault on M7Vincent Palatin2018-06-041-0/+2
* meowth_fp: update AP interrupt configurationVincent Palatin2018-06-042-3/+1
* cheza: Switch USB port-0 HS to the hubWai-Hong Tam2018-06-011-2/+2
* nocturne: Add NVMe power enable controls.Aseda Aboagye2018-06-011-0/+8
* atlas: board version 1 supportCaveh Jalali2018-06-014-49/+23
* chgstv2: Fix manual control via EC console.Aseda Aboagye2018-06-013-2/+32
* Nami: Blink power LED in sleep for PantheonDaisuke Nojiri2018-06-011-7/+7
* battery: Move fuel gauge code to commonEdward Hill2018-06-0115-387/+56
* grunt: Board specific battery infoEdward Hill2018-06-0111-67/+389
* Nami: Fix battery_is_present detectionDaisuke Nojiri2018-06-011-21/+44
* Nami: Enable board specific battery detection logicRyan Zhang2018-06-011-0/+1
* g: add documentation pointing to p256 modular reduction verification in CoqJade Philipoom2018-06-011-0/+28
* nocturne: Set V085A output voltage to 0.85V.Aseda Aboagye2018-05-311-0/+3
* charger: bq25703: Exit low power mode prior to reading ADCScott Collyer2018-05-312-2/+54
* gsctool: add factory mode commandMary Ruthven2018-05-311-13/+53
* cr50: add command for factory resetMary Ruthven2018-05-314-0/+64
* scarlet: Don't disable idle mode in S3Philip Chen2018-05-311-2/+1
View Lorry Controller Status