summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
...
* motion: Remove duplicate shutdown codeGwendal Grignou2015-10-284-16/+8
* driver: si114x: Fail init of proximity sensor if light sensor fails.Gwendal Grignou2015-10-282-1/+4
* driver: bmi160: Add magic sequence to unlockGwendal Grignou2015-10-271-1/+12
* Remove cyan ec configurationBernie Thompson2015-10-2710-789/+0
* charger: Add LIMIT_POWER charger param for low bat + weak chargerShawn Nematbakhsh2015-10-277-3/+74
* i2c: get battery information from charge stateMary Ruthven2015-10-276-4/+90
* chell: Set SPI flash chip to W25X40Duncan Laurie2015-10-271-1/+1
* flash_ec: Add support for flashing chell PDDuncan Laurie2015-10-271-2/+3
* it8380dev: gpio - remove comment about E4Dino Li2015-10-251-2/+0
* it8380dev: Increase DLM sizeDino Li2015-10-253-10/+22
* it8380dev: fix clock moduleDino Li2015-10-2512-37/+399
* glados: oak: reboot EC if PD MCU crashesAlec Berg2015-10-235-21/+34
* pd: remove unnecessary delay in phy initAlec Berg2015-10-231-1/+1
* ryu: fix lid close detectionVincent Palatin2015-10-231-1/+1
* ryu: do not pull EN_PP3300Vincent Palatin2015-10-231-1/+1
* common: lightbar: Add histeresis to prevent flickeringGwendal Grignou2015-10-236-23/+96
* board: ryu: Compass and Gyro stays up in S5Gwendal Grignou2015-10-231-2/+2
* mec1322: Remove CONFIG_PORT80_TASK_EN from boards.Aseda Aboagye2015-10-238-8/+0
* lars: remove port80 taskAlec Berg2015-10-231-2/+1
* glados: chell: add VCONN swap abilityAlec Berg2015-10-234-0/+20
* pd: change battery and variable sink cap for voltage inaccuracyAlec Berg2015-10-2310-20/+18
* pd: send soft reset on boot if VBUS is presentAlec Berg2015-10-234-49/+41
* oak: revise suspend gpio setting for rev4YH Huang2015-10-231-0/+4
* oak: stm32f0: implement i2c_set_timeoutRong Chang2015-10-232-8/+16
* Cr50: Support USB on 15MHz FPGA imageBill Richardson2015-10-222-13/+152
* Lars: Init boardRyan Zhang2015-10-2213-1/+1590
* flash_ec: Use the chip name to check stm32 boardTom Wai-Hong Tam2015-10-221-28/+27
* tcpc: re-initialize tcpc if it reboots while tcpm is runningAlec Berg2015-10-226-28/+96
* Cr50: Support FPGA image m3.dist_20151021_054409Bill Richardson2015-10-229-2514/+2915
* ps8740: Make revision check a minimum instead of explicit valueDuncan Laurie2015-10-211-1/+1
* flash_ec: Add chell and lars boardsDuncan Laurie2015-10-211-0/+2
* Kunimitsu: Add support to enable L3GD20H gyrometerVijay Hiremath2015-10-212-0/+46
* kunimitsu: enable USB-A port power controlKevin K Wong2015-10-212-4/+5
* common: Add lightbar dimming based on outside light.Gwendal Grignou2015-10-206-7/+97
* lightbar: define primary colorsGwendal Grignou2015-10-201-9/+18
* driver: Add L3GD20H gyrometer basic driver supportBolat Dinc2015-10-205-0/+546
* oak_pd: reduce image size and build full RO and RWAlec Berg2015-10-202-8/+22
* Kunimitsu: Enable motion_sense_taskstabilize-smaug-7566.Bli feng2015-10-191-0/+1
* nuc: Remove unnecessary NPCX_EC_FLASH_SIZE definition in npcx.Mulin Chao2015-10-192-18/+11
* mec1322: Abort curr DMA xfer in dma_disable_all().Aseda Aboagye2015-10-191-0/+8
* cr50: move tpm2 stubs.c file to this repositoryVadim Bendebury2015-10-192-1/+580
* port80: Remove HAS_TASK_PORT80.Aseda Aboagye2015-10-192-68/+0
* mec1322: Change the Port 80 task to a timer IRQ.Aseda Aboagye2015-10-1910-14/+91
* glados_pd: reduce image size and build full RO and RWAlec Berg2015-10-193-4/+25
* stm32f05x: Use correct erase block size of 1kBAlec Berg2015-10-191-1/+1
* glados_pd: oak_pd: add and enable option for i2c slave onlyAlec Berg2015-10-197-4/+11
* stm32: add synchronous debug printfAlec Berg2015-10-1912-48/+128
* Provide interface to random number generatorVadim Bendebury2015-10-173-8/+50
* Cr50: enable modificaton of flash bank 1Bill Richardson2015-10-171-0/+10
* Kunimitsu: PMIC: Keep the emergency reset time to defaultVijay Hiremath2015-10-171-11/+0
View Lorry Controller Status