summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
...
* elm: set SPI2 interface to low in S5Koro Chen2016-05-301-18/+33
* reef: Initialize charge suppliers after change manager is initializedVijay Hiremath2016-05-284-14/+36
* BD99955: Get the VBUS provided status from individual portsVijay Hiremath2016-05-285-10/+39
* reef: Re-factor PP5000 and PP3300 enable/disableDavid Hendricks2016-05-271-41/+29
* apollolake: modify PMIC_EN and RSMRST_N handlingKevin K Wong2016-05-273-19/+55
* Timer initialization & conversion bug fixesNadim Taha2016-05-281-16/+9
* pwm: Modify new PWM host commands to take 16-bit duty cycleShawn Nematbakhsh2016-05-273-13/+22
* lucid: Add battery temp to temp_sensors listMary Ruthven2016-05-272-0/+23
* cr50: disable UART peripheral when the device is powered off.Mary Ruthven2016-05-273-2/+27
* cr50: dont drive UART output if servo is connectedMary Ruthven2016-05-275-61/+181
* cr50: monitor the state of Servo, the EC, and APMary Ruthven2016-05-279-7/+295
* kevin: rk3399: ectool interface for EC RTC alarmShelley Chen2016-05-272-0/+38
* common: Hide hcdebug_mode_names behind CONFIG_CMD_HCDEBUGStefan Reinauer2016-05-261-0/+2
* Cr50: NvMem: Connected function stubs in /board/tpm2/NVMem.cScott2016-05-265-7/+296
* Cr50: Enabling NvMem in board.c and board.hScott2016-05-262-0/+48
* NvMem: Added NV Memory module to ec/common/Scott2016-05-269-2/+999
* servo_micro: add programmable serial numberNick Sanders2016-05-267-29/+297
* servo_v4: Fix ADC console commandNick Sanders2016-05-269-239/+18
* amenia: update TCPC0 reset/power down assertion timeKevin K Wong2016-05-261-2/+2
* CR50: increment prime generation counternagendra modadugu2016-05-262-11/+25
* mkbp_event: Don't discard event source structures due to LTOShawn Nematbakhsh2016-05-251-3/+3
* USB Serial: Add simple install scriptAnton Staaf2016-05-251-0/+19
* CR50: remove dependence of assert.h on util.hnagendra modadugu2016-05-252-30/+34
* ectool: use v2 ABI for fallback 'readmem' ioctlBrian Norris2016-05-241-3/+3
* reef: Initialize VBUS + BC1.2 charge_manager suppliersShawn Nematbakhsh2016-05-241-0/+29
* elm: Add support for I2C tunnel protectionNicolas Boichat2016-05-242-1/+14
* common/i2c: Add I2C passthru_protect commandNicolas Boichat2016-05-245-4/+177
* common/i2c: Add get_i2c_port functionNicolas Boichat2016-05-241-38/+26
* reef: keep analogix pd chip in resetAaron Durbin2016-05-241-1/+1
* reef: change USB_C0_PD_INT voltage toleranceAaron Durbin2016-05-241-1/+1
* reef: don't reset analogix pd chip out of band of driverAaron Durbin2016-05-241-4/+3
* Driver: BD99955: Enable BC1.2 supportVijay Hiremath2016-05-2423-85/+372
* amenia: enable tcpc support for amenia 1.2Kevin K Wong2016-05-243-89/+28
* amenia: update for amenia 1.2 hardwareVijay Hiremath2016-05-245-140/+249
* it83xx: fix wrong setting of 'IT83XX_ECPM_SCDCR3' registerDino Li2016-05-241-3/+0
* usb_serial: ignore make byproductsVadim Bendebury2016-05-241-0/+12
* it83xx: Add GPIO group K and LDino Li2016-05-242-7/+25
* kevin: rk3399: enabling RTC wakeupShelley Chen2016-05-233-1/+27
* reef: Initial commitDavid Hendricks2016-05-2010-4/+1758
* spi_flash: Add protect_range table for W25Q40stabilize-8350.21.BDavid Hendricks2016-05-192-0/+49
* elm: Set internal pull-high to GPI pins below.tonycwlin2016-05-191-4/+4
* COMMON: Add extend function for tmp432 ICRyan Zhang2016-05-182-0/+90
* chip: it83xx: Optimize interrupt usage of LPC accessDino Li2016-05-185-26/+16
* npcx: Modify gpio's interrupt utilitiesMulin Chao2016-05-181-22/+14
* TCPM : Added driver for Analogix's anx74xx chipsAman Kumar2016-05-184-0/+955
* kevin / gru: Update battery parametersShawn Nematbakhsh2016-05-181-3/+16
* LED: add green/red support for host commandsZhengShunQian2016-05-181-4/+13
* board: it83xx_evb: support PD EVBDino Li2016-05-186-44/+469
* do not allow console commands with names longer than 14 charactersVadim Bendebury2016-05-181-0/+4
* shorten long console command namesVadim Bendebury2016-05-182-2/+2
View Lorry Controller Status