summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
* Cr50: Add "wp" console command to control EC_WP_LBill Richardson2016-08-222-0/+33
* it83xx: lpc: add support 'CONFIG_KEYBOARD_IRQ_GPIO' and fix lpc_init()Dino Li2016-08-221-0/+68
* Cr50: Disable spstest command.Bill Richardson2016-08-221-5/+0
* charger: bd99955: Prevent truncated console command outputShawn Nematbakhsh2016-08-221-1/+3
* kevin: Save and restore display backlight PWM duty across sysjumpShawn Nematbakhsh2016-08-221-0/+25
* g: Remove unused CONFIG_RBOX_DEBUG featureBill Richardson2016-08-223-95/+2
* flash_ec: Add check for servo_has_cold_reset.Kevin Cheng2016-08-221-1/+7
* npcx: Apply deep idle bypass for hibernateMulin Chao2016-08-221-1/+24
* g: Remove obsolete spstpm commandBill Richardson2016-08-221-30/+0
* kevin: Disable hostcommand debuggingNicolas Boichat2016-08-221-0/+3
* pd: support Rp/Rp debug accessoriesVincent Palatin2016-08-222-30/+105
* it83xx: add reset cause of reset pinDino Li2016-08-221-1/+1
* TCPM: it83xx: support Rp 1.5/3.0A pullup configurationDino Li2016-08-221-7/+17
* it83xx: fix i2c moduleDino Li2016-08-221-12/+22
* anx7688: Add custom vbus functionNicolas Boichat2016-08-211-1/+16
* kevin: Keep LED test status with ectool led.Jongpil Jung2016-08-211-2/+0
* tpm: limit the length of the string reported through TPM_FW_VERVadim Bendebury2016-08-211-36/+9
* reef: add power led behaviorli feng2016-08-211-12/+57
* npcx: set the BUSY bit while handling ACPI command write.Kevin K Wong2016-08-212-8/+15
* sweetberry: add i2c supportNick Sanders2016-08-217-5/+814
* usb_updater: host side support protocol version 3Vadim Bendebury2016-08-213-105/+283
* Change transfer_endpoint to transfer_descriptorVadim Bendebury2016-08-211-24/+24
* g: usb_updater: add command line option to allow updating the RO sectionVadim Bendebury2016-08-211-1/+7
* g: usb_updater: clean up update protocol handlingVadim Bendebury2016-08-214-100/+86
* Fix AES CFB encryption for non-divisible-by-16 lengthsAndrey Pronin2016-08-201-18/+14
* Revert "shi: Enable SHI interrupt from CS interrupt"Shawn Nematbakhsh2016-08-211-43/+20
* shi: Enable SHI interrupt from CS interruptShawn Nematbakhsh2016-08-201-20/+43
* kevin: usb_pd: Accept VCONN swap only when 5V is availableShawn Nematbakhsh2016-08-201-2/+1
* COMMIT-QUEUE.ini: Change builders to compile-only.Aseda Aboagye2016-08-191-2/+4
* mkbp_event: Provide host event wake mask to hostShawn Nematbakhsh2016-08-191-0/+15
* chip/npcx/lpc: Fix SCI and SMI generationFurquan Shaikh2016-08-192-6/+37
* g: report RW header version along with code revisionVadim Bendebury2016-08-192-5/+33
* sweetberry: add build target for sweetberryNick Sanders2016-08-196-0/+236
* Standard locations for board specific battery codeVictor Prupis2016-08-195-4/+2
* kevin / gru: Enable VBUS discharge when swapping out of source roleShawn Nematbakhsh2016-08-191-1/+2
* pd: Support GPIO-controlled 5v dischargeShawn Nematbakhsh2016-08-192-0/+23
* Cr50: Remove unused AP_WP_L GPIOBill Richardson2016-08-191-5/+0
* COMMIT-QUEUE.ini: Disable chell-pre-cqNicolas Boichat2016-08-181-1/+1
* Correct mv values for the thermal sensors.Ravi Chandra Sadineni2016-08-171-12/+28
* Correct interpolation algorithm of thermal values.Ravi Chandra Sadineni2016-08-173-51/+52
* reef: Add internal pull-up for TCPC1 INT# by default.Shamile Khan2016-08-172-18/+7
* Reef: Turns off correct power rails when entering G3Rachel Nancollas2016-08-171-0/+15
* reef: make corrections to I2C GPIOs in gpio.incDavid Hendricks2016-08-171-9/+9
* stm32f446e-eval: add support for stm32f446Nick Sanders2016-08-1727-211/+2186
* ec_commands.h: Reserve 0x200-0x2FF for Rotor.Aseda Aboagye2016-08-171-5/+1
* btle: Improved stability of ble_tx functionLevi Oliver2016-08-171-0/+21
* board: it83xx_evb: fix build errorite015802016-08-171-4/+0
* Reef: Enable smart power control to the device's USB portsstabilize-8714.BVijay Hiremath2016-08-161-0/+8
* common/btle_ll.c: Return error code instead of uninitialized valueMartin Roth2016-08-161-1/+1
* fusb302: enable setting Rp valueVincent Palatin2016-08-163-0/+14