summaryrefslogtreecommitdiff
path: root/board/nami
Commit message (Expand)AuthorAgeFilesLines
* motion_lid: Use CONFIG_TABLET_MODEFurquan Shaikh2018-11-291-2/+0
* tablet_mode: Introduce hall sensor specific handlingFurquan Shaikh2018-11-292-3/+3
* Nami: modify actual_key_mask to enable the "Search" key for the keyboardSue Chen2018-11-271-1/+3
* Nami: Add new LED behavior for factory modeSue Chen2018-11-261-4/+35
* Nami: Supply power up to 3A + 1.5ADaisuke Nojiri2018-11-161-0/+1
* Nami: Apply full factor to full capacityDaisuke Nojiri2018-11-151-0/+2
* usb-c: use higher priority task for interruptsJett Rink2018-11-141-9/+12
* Nami: Use display battery percentage to control LEDDaisuke Nojiri2018-11-081-20/+27
* Nami: Add keymasks for page-up/down, home, end, deleteDaisuke Nojiri2018-10-311-21/+24
* dptf: Get rid of CONFIG_DPTF_DEVICE_ORIENTATIONFurquan Shaikh2018-10-301-1/+0
* Nami: Add keypad supportDaisuke Nojiri2018-10-242-1/+11
* Nami: Extend SKU from 16 bit to 32 bitDaisuke Nojiri2018-10-192-4/+4
* ss-mux: remove unused port_addr initializationv2.0.0Jett Rink2018-09-171-2/+0
* usb-c: add high priority tasks for interruptsJett Rink2018-09-171-1/+3
* type: Rename matrix_3x3_t to mat33_fp_tYilun Lin2018-09-131-3/+3
* chgstv2: Use lower charge threshold for boot if AC power is presentDaisuke Nojiri2018-08-171-2/+4
* Nami: Report error for disconnected battery on SonaDaisuke Nojiri2018-08-161-2/+36
* servo_v4: add per port dualrole settingNick Sanders2018-08-151-2/+2
* Nami: Allow battery LED to turn off on battery errorDaisuke Nojiri2018-08-071-21/+26
* Nami: Delay and repeat gas gauge detectionElmo_Lan2018-08-032-12/+26
* espi: Rename CONFIG_HOSTCMD_ESPI_VW_SIGNALS to CONFIG_HOSTCMD_ESPI_VW_SLP_SIG...Furquan Shaikh2018-07-271-1/+1
* Nami: Disable ACPI and host event log messagesDaisuke Nojiri2018-07-251-0/+6
* Nami: Reverse polarity of USB2_IDDaisuke Nojiri2018-07-242-3/+2
* Nami: Add local sensor of F75303 for AkaliDaisuke Nojiri2018-07-232-9/+73
* Nami: Disable Accel/Gyro sensor for clamshellsDaisuke Nojiri2018-07-203-8/+20
* nami: Undef CONFIG_USBC_SS_MUX_DFP_ONLY to enable device modeShelley Chen2018-07-191-1/+0
* Nami: Remove ALS from all projectsDaisuke Nojiri2018-07-192-45/+0
* Nami: Set boot power thresholdsDaisuke Nojiri2018-07-171-3/+8
* Nami: Show status on power LED even when PWR_STATE_ERRORDaisuke Nojiri2018-07-171-0/+3
* Nami: Add power LED control to SonaDaisuke Nojiri2018-07-171-3/+15
* Nami: Toggle power of PS8713B on suspend/resumeDaisuke Nojiri2018-07-122-1/+3
* Nami: Enable temperature contorl by fanDaisuke Nojiri2018-07-102-4/+99
* Nami: configure motion sensors for board variants earlyDaisuke Nojiri2018-06-291-14/+14
* Nami: Add fan configurations for Sona and PantheonDaisuke Nojiri2018-06-291-2/+30
* Nami: Support battery_check_disconnect for TI and Renesas gaugeDaisuke Nojiri2018-06-281-4/+71
* Nami: Set GPIO42 to high Z for older boardsDaisuke Nojiri2018-06-271-0/+4
* Nami: Lock ECDaisuke Nojiri2018-06-271-6/+1
* Nami: Make LED pulse in S3/S0ix every 2 seconds for VayneDaisuke Nojiri2018-06-221-1/+1
* Nami: Disable blinking LED on battery error for PantheonDaisuke Nojiri2018-06-221-0/+2
* Nami: Change rotation for accels and gyro for AkaliDaisuke Nojiri2018-06-211-6/+8
* Nami: Enable USB2_ID when data role is UFPDaisuke Nojiri2018-06-212-4/+7
* Nami: Reduce buck-boost mode switching frequency of isl9238Daisuke Nojiri2018-06-181-2/+11
* Nami: Set initial fan duty to 50%Daisuke Nojiri2018-06-181-0/+2
* Nami: Increase PWM frequency for LEDs and keyboard backlightDaisuke Nojiri2018-06-151-3/+8
* Nami: Enable EC_CMD_FLASH_SPI_INFODaisuke Nojiri2018-06-071-0/+1
* Nami: Change battery config to AP15O5L for AkaliDaisuke Nojiri2018-06-071-14/+45
* Nami: Set PD_MAX_POWER_MW to 70WDaisuke Nojiri2018-06-061-2/+2
* Nami: Toggle Anx7447 reset line at start-upDaisuke Nojiri2018-06-052-6/+8
* Nami: Blink power LED in sleep for PantheonDaisuke Nojiri2018-06-011-7/+7
* Nami: Fix battery_is_present detectionDaisuke Nojiri2018-06-011-21/+44
View Lorry Controller Status