summaryrefslogtreecommitdiff
path: root/board/waddledoo
Commit message (Expand)AuthorAgeFilesLines
* Dedede: Remove VSYNC sensorDiana Z2020-09-233-16/+0
* Dedede: Define GPIO_USB_C1_INT_ODL for all variantsDiana Z2020-09-091-0/+8
* Revert "Waddledoo: Add thermistors"Sooraj Govindan2020-09-092-27/+0
* WADDLEDOO: Use common battery codeSam Hurst2020-08-272-90/+65
* Dedede: Move Discharge on AC config to baseboardDiana Z2020-08-271-1/+0
* waddledoo/magolor: Add check for CFET disabledAseda Aboagye2020-08-261-0/+14
* Dedede: Move PWM to board levelDiana Z2020-08-212-0/+28
* waddledoo: Configure unused GPIOs as inputsBrian J. Nemec2020-08-191-0/+12
* Waddledoo: Add thermistorsSooraj Govindan2020-08-112-0/+27
* Revert "power: Clear AP_IDLE when waking up by PB or LID"Daisuke Nojiri2020-08-011-0/+1
* Dedede: Move extpower_is_present() to baseboardDiana Z2020-07-281-10/+1
* Waddledoo: Only set HDMI enable when HDMI DB is presentDiana Z2020-07-161-2/+4
* boten: split CONFIG_LED_PWM out into boardsxiong.huang2020-07-151-0/+1
* dedede: Move adc channel to board variantDevin Lu2020-07-141-0/+33
* Waddledoo: Enable HDMI daughterboardDiana Z2020-07-134-22/+103
* Charger: Add dynamic charger chip countDiana Z2020-07-111-1/+0
* DEDEDE: Increase board PD stack sizesSam Hurst2020-07-071-4/+4
* boten: use charger/TCPC RAA48900xiong.huang2020-06-141-0/+10
* boten: remove DB type-C port and peripheral chipsxiong.huang2020-06-111-0/+7
* waddledoo: Use TCPCI cached VBUS presenceAseda Aboagye2020-06-111-5/+2
* waddledoo: Enable OCPCAseda Aboagye2020-06-042-0/+28
* waddledee/waddledoo: Mark BC1.2 as always poweredAseda Aboagye2020-05-291-0/+2
* Extend the tcpci register dump.Andrew McRae2020-05-271-1/+1
* waddledoo: Add rotation matrices for sensorsAseda Aboagye2020-05-211-3/+16
* Waddledoo: configure ECH1_PACKET_MODEDiana Z2020-05-211-8/+9
* PD: Remove unnecessary PDCMD taskDiana Z2020-05-201-1/+0
* Waddledoo: enable gpio interrupt for base accelgyro sensorKo_Ko2020-05-051-0/+2
* waddledoo: Hibernate charger ICs when hibernatingAseda Aboagye2020-05-021-0/+10
* driver: Replace BMI160 to BMI in board configChing-Kang Yen2020-04-231-6/+6
* waddledoo/waddledee: Deassert ALL_SYS_PGOOD quicklyAseda Aboagye2020-04-211-3/+3
* dedede: Make EC_MKBP_INT_L open drainAseda Aboagye2020-03-261-1/+1
* waddledoo: Swap EN_PP5000_U & VOLUP_BTN_ODLAseda Aboagye2020-03-122-4/+40
* waddledoo: Enable CONFIG_SYSTEM_UNLOCKEDAseda Aboagye2020-03-121-0/+6
* usb_mux: retimer: mux as chained mux and retimerDenis Brockus2020-02-281-14/+14
* waddledoo: Set CMPOUT as inverted to enable 5VAseda Aboagye2020-02-251-0/+20
* dedede: Configure EN_VCCST as inputAseda Aboagye2020-02-221-1/+2
* dedede: Set pullup on PG_PP1050_ST_OD only after RSMRSTAseda Aboagye2020-02-211-1/+1
* tcpci: Rename TCPC_FLAGS_TCPCI_V2_0 to TCPC_FLAGS_TCPCI_REV2_0Edward Hill2020-02-141-6/+6
* Charger: Convert boards to use new driver structureDiana Z2020-02-042-2/+1
* waddledoo: Change PP1050_ST power goodAseda Aboagye2020-01-312-2/+2
* waddledoo: Add chg_chips tableAseda Aboagye2020-01-292-0/+17
* waddledoo: Enable USB Type-C redriverAseda Aboagye2020-01-292-0/+11
* pi3usb3x532: Pack i2c port in port_addrAseda Aboagye2020-01-241-2/+4
* waddledoo: don't enable pull-ups with low-voltage modeDavid Schneider2020-01-241-3/+3
* waddledoo: Enable TCPCI Rev2 v1.0 for TCPCsAseda Aboagye2020-01-221-10/+6
* waddledoo: Add LED supportAseda Aboagye2020-01-213-1/+84
* waddledoo: Add keyboard supportAseda Aboagye2020-01-214-5/+33
* waddledoo: Add Type-C, PD, and charging supportAseda Aboagye2020-01-217-4/+421
* Waddledoo: Add sensor supportDiana Z2020-01-144-0/+165
* waddledoo: Add JSL supportAseda Aboagye2020-01-084-14/+30
View Lorry Controller Status