| Commit message (Collapse) | Author | Age | Files | Lines |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Previously usb_charger.c supported only pi3usb9281, but now support for
additional parts is required. Move pericom-specific code (including the
usb_charger tasks that handles various quirks of that part) to the
pi3usb9281 usb_switch driver.
Going forward, usb_switch drivers must implement
usb_charger_set_switches() and must have some method (such as a task or
interrupt handler) to update charge_manager with information about
attached chargers.
BUG=chrome-os-partner:53363
BRANCH=None
TEST=`make buildall -j`
Signed-off-by: Shawn Nematbakhsh <shawnn@chromium.org>
Change-Id: I4df74e043d8cf2e532d48c39c73b7dc2930f7d3b
Reviewed-on: https://chromium-review.googlesource.com/344289
Commit-Ready: Shawn N <shawnn@chromium.org>
Tested-by: Shawn N <shawnn@chromium.org>
Reviewed-by: Vincent Palatin <vpalatin@chromium.org>
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
This unifies all the EC header files to use __CROS_EC_FILENAME_H
as the include guard. Well, except for test/ util/ and extra/
which use __TEST_ __UTIL_ and __EXTRA_ prefixes respectively.
BUG=chromium:496895
BRANCH=none
TEST=make buildall -j
Signed-off-by: Bill Richardson <wfrichar@chromium.org>
Change-Id: Iea71b3a08bdec94a11239de810a2b2e152b15029
Reviewed-on: https://chromium-review.googlesource.com/278121
Reviewed-by: Randall Spangler <rspangler@chromium.org>
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Previously we supported using a single pi3usb9281 chip, or using two
chips on the same i2c bus behind a mux. Now that we need to support a
third configuration of multiple chips on different busses, it makes
sense to be able to configure the configuration freely at the board
level.
BUG=chrome-os-partner:40920
TEST=Manual on samus_pd. Plug USB charger, verify detection is correct
on both charge ports.
BRANCH=None
Change-Id: I120dcb1c3ceb6f013b92407effcd8cb66e7ffcce
Signed-off-by: Shawn Nematbakhsh <shawnn@chromium.org>
Reviewed-on: https://chromium-review.googlesource.com/276511
Reviewed-by: Alec Berg <alecaberg@chromium.org>
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Bits 1 and 3 of the control register are read 1, write 1, but RO
firmware may have zero'd these bits. Therefore, always set the bits
high, ignoring the read value.
TEST=Manual on Samus. Starting from .90 RO, flash new RW and verify
BC1.2 charger detection is working.
BUG=chrome-os-partner:37241
BRANCH=Samus
Change-Id: I2f71718f74e50fe9b664dbe3da1578ee4c995136
Signed-off-by: Shawn Nematbakhsh <shawnn@chromium.org>
Reviewed-on: https://chromium-review.googlesource.com/254880
Reviewed-by: Alec Berg <alecaberg@chromium.org>
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
REG_CONTROL has two sets of reserved bits:
- Bits 5 thru 7 are read x, write 0.
- Bits 1 and 3 have undocumented function and should not be changed from
read value.
BUG=chrome-os-partner:36360
TEST=Manual on Samus. Cold boot unit and insert 2.4A charger. Verify
that charger is correctly detected.
BRANCH=Samus
Change-Id: I240d352817910eda404b72be13e2c913a4b76079
Signed-off-by: Shawn Nematbakhsh <shawnn@chromium.org>
Reviewed-on: https://chromium-review.googlesource.com/246560
Reviewed-by: Alec Berg <alecaberg@chromium.org>
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
PI3USB9281A is compatible with our existing driver but has a different
device ID.
BUG=chrome-os-partner:35567
TEST=Manual on samus_pd. Verify that "invalid ID 0x18" prints are not
seen on console.
BRANCH=Samus
Signed-off-by: Shawn Nematbakhsh <shawnn@chromium.org>
Change-Id: I275ed50fcbcb3c2e385292408be6de51055903fb
Reviewed-on: https://chromium-review.googlesource.com/241764
Reviewed-by: Duncan Laurie <dlaurie@chromium.org>
Reviewed-by: Alec Berg <alecaberg@chromium.org>
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Samus USB ports can't actually act as UFPs, so open switches when in
UFP mode.
BUG=chrome-os-partner:32003
TEST=Manual on Samus. Connect two Samus units, run `pd 1 swap data`,
verify that switches are opened on switch to UFP. Unplug samus and
connect a USB 2.0 device instead, verify that ports are again closed.
BRANCH=samus
Change-Id: I9e1ca58089caf29e419698c8426bf8b72500833a
Signed-off-by: Shawn Nematbakhsh <shawnn@chromium.org>
Reviewed-on: https://chromium-review.googlesource.com/233711
Reviewed-by: Alec Berg <alecaberg@chromium.org>
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Get type-c port power info including power role, charger type,
and charging info. Also added host command to get number of type-c
ports.
Also adds new charging suppliers for pericom identified chargers
including DCP, CDP, SDP, proprietary, and other chargers. Priority
of these for charging is set in samus board file.
BUG=chrome-os-partner:32650
BRANCH=samus
TEST=run 'ectool --name=cros_pd usbpdpower' and verify correct
status with minimuffin, zinger, and type-C to type-A adapter.
Change-Id: I1dabbe7de4185a23df5684a5ea9a2d944f1f6ff5
Signed-off-by: Alec Berg <alecaberg@chromium.org>
Reviewed-on: https://chromium-review.googlesource.com/223523
Tested-by: Shawn Nematbakhsh <shawnn@chromium.org>
Reviewed-by: Shawn Nematbakhsh <shawnn@chromium.org>
Reviewed-by: Patrick Georgi <pgeorgi@chromium.org>
Reviewed-by: Todd Broch <tbroch@chromium.org>
Reviewed-by: Vincent Palatin <vpalatin@chromium.org>
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Decode Pericom registers to current limits.
BUG=chrome-os-partner:32003
TEST=Manual on samus_pd. Insert 1A Apple charger, verify current limit
is correctly detected as 1A.
BRANCH=samus
Change-Id: I310d9f22cef80e97c1734e6a56f0034ebe01df31
Signed-off-by: Shawn Nematbakhsh <shawnn@chromium.org>
Reviewed-on: https://chromium-review.googlesource.com/222638
Reviewed-by: Alec Berg <alecaberg@chromium.org>
|
|
BRANCH=none
BUG=none
TEST=verify that usb switch funcitons
Change-Id: Ie897a2ae94042abefbb349d30dfa183caaec9ed0
Signed-off-by: Dominic Chen <ddchen@chromium.org>
Reviewed-on: https://chromium-review.googlesource.com/209846
Reviewed-by: Vic Yang <victoryang@chromium.org>
|