/* Copyright 2018 The Chromium OS Authors. All rights reserved.
 * Use of this source code is governed by a BSD-style license that can be
 * found in the LICENSE file.
 *
 * TI LM3630A LED driver.
 */

#include "i2c.h"
#include "lm3630a.h"
#include "timer.h"


/* 8-bit I2C address */
#define LM3630A_I2C_ADDR (0x36 << 1)

static inline int lm3630a_write(uint8_t reg, uint8_t val)
{
	return i2c_write8(I2C_PORT_KBLIGHT, LM3630A_I2C_ADDR, reg, val);
}

static inline int lm3630a_read(uint8_t reg, int *val)
{
	return i2c_read8(I2C_PORT_KBLIGHT, LM3630A_I2C_ADDR, reg, val);
}

int lm3630a_poweron(void)
{
	int ret = 0;

	/* Sample PWM every 8 periods. */
	ret |= lm3630a_write(LM3630A_REG_FILTER_STRENGTH, 0x3);

	/* Enable feedback and PWM for banks A. */
	ret |= lm3630a_write(LM3630A_REG_CONFIG,
				LM3630A_CFG_BIT_FB_EN_A |
				LM3630A_CFG_BIT_PWM_EN_A);

	/* 24V, 800mA overcurrent protection, 500kHz boost frequency. */
	ret |= lm3630a_write(LM3630A_REG_BOOST_CONTROL,
				LM3630A_BOOST_OVP_24V |
				LM3630A_BOOST_OCP_800MA |
				LM3630A_FMODE_500KHZ);

	/* Limit current to 24.5mA */
	ret |= lm3630a_write(LM3630A_REG_A_CURRENT, 0x1a);

	/* Enable bank A, put in linear mode, and connect LED2 to bank A. */
	ret |= lm3630a_write(LM3630A_REG_CONTROL,
				LM3630A_CTRL_BIT_LINEAR_A |
				LM3630A_CTRL_BIT_LED_EN_A |
				LM3630A_CTRL_BIT_LED2_ON_A);

	/*
	 * Set full brightness so that PWM will control. This needs to happen
	 * after setting the control register, because enabling the banks
	 * resets the value to 0 (the short sleep prevents a race between the
	 * chip resetting the value to 0 and our command).
	 */
	usleep(100);
	ret |= lm3630a_write(LM3630A_REG_A_BRIGHTNESS, 0xff);

	return ret;
}

int lm3630a_poweroff(void)
{
	return lm3630a_write(LM3630A_REG_CONTROL, LM3630A_CTRL_BIT_SLEEP_CMD);
}