/* Copyright 2018 The Chromium OS Authors. All rights reserved.
 * Use of this source code is governed by a BSD-style license that can be
 * found in the LICENSE file.
 */

#include "usb_mux.h"

/* USB Power delivery port management */

#ifndef __CROS_EC_USB_PD_TCPM_ANX7447_H
#define __CROS_EC_USB_PD_TCPM_ANX7447_H

/* Registers: TCPC address used */
#define ANX7447_REG_TCPC_SWITCH_0	0xB4
#define ANX7447_REG_TCPC_SWITCH_1	0xB5
#define ANX7447_REG_TCPC_AUX_SWITCH	0xB6

#define ANX7447_REG_INTR_ALERT_MASK_0	0xC9

#define ANX7447_REG_TCPC_CTRL_2		0xCD
#define ANX7447_REG_ENABLE_VBUS_PROTECT	0x20

#define ANX7447_REG_ADC_CTRL_1		0xBF
#define ANX7447_REG_ADCFSM_EN		0x20

/* Registers: SPI address used */
#define ANX7447_REG_INTP_SOURCE_0	0x67

#define ANX7447_REG_HPD_CTRL_0		0x7E
#define ANX7447_REG_HPD_MODE		0x01
#define ANX7447_REG_HPD_OUT		0x02
#define ANX7447_REG_HPD_IRQ0		0x04
#define ANX7447_REG_HPD_PLUG		0x08
#define ANX7447_REG_HPD_UNPLUG		0x10

#define ANX7447_REG_HPD_DEGLITCH_H	0x80
#define ANX7447_REG_HPD_DETECT		0x80
#define ANX7447_REG_HPD_OEN		0x40

#define ANX7447_REG_PAD_INTP_CTRL	0x85

#define ANX7447_REG_INTP_MASK_0		0x86

#define ANX7447_REG_INTP_CTRL_0		0x9E

#define ANX7447_REG_ANALOG_CTRL_8	0xA8
#define ANX7447_REG_VCONN_OCP_MASK	0x0C
#define ANX7447_REG_VCONN_OCP_240mA	0x00
#define ANX7447_REG_VCONN_OCP_310mA	0x04
#define ANX7447_REG_VCONN_OCP_370mA	0x08
#define ANX7447_REG_VCONN_OCP_440mA	0x0C

#define ANX7447_REG_ANALOG_CTRL_10	0xAA
#define ANX7447_REG_CABLE_DET_DIG	0x40

#define ANX7447_REG_R_VCONN_PWR_PRT_INRUSH_TIME_MASK	0x38
#define ANX7447_REG_R_VCONN_PWR_PRT_INRUSH_TIME_19US	0x00
#define ANX7447_REG_R_VCONN_PWR_PRT_INRUSH_TIME_38US	0x08
#define ANX7447_REG_R_VCONN_PWR_PRT_INRUSH_TIME_76US    0x10
#define ANX7447_REG_R_VCONN_PWR_PRT_INRUSH_TIME_152US   0x18
#define ANX7447_REG_R_VCONN_PWR_PRT_INRUSH_TIME_303US   0x20
#define ANX7447_REG_R_VCONN_PWR_PRT_INRUSH_TIME_607US	0x28
#define ANX7447_REG_R_VCONN_PWR_PRT_INRUSH_TIME_1210US	0x30
#define ANX7447_REG_R_VCONN_PWR_PRT_INRUSH_TIME_2430US	0x38

#define ANX7447_REG_ANALOG_CTRL_9	0xA9
#define ANX7447_REG_SAFE_MODE		0x80
#define ANX7447_REG_R_AUX_RES_PULL_SRC	0x20

/*
 * This section of defines are only required to support the config option
 * CONFIG_USB_PD_TCPM_ANX7447_OCM_ERASE_COMMAND.
 */
/* SPI registers used for OCM flash operations */
#define ANX7447_DELAY_IN_US		(20*1000)

#define ANX7447_REG_R_RAM_CTRL			0x05
#define ANX7447_REG_R_FLASH_RW_CTRL		0x30
#define ANX7447_REG_R_FLASH_STATUS_0		0x31
#define ANX7447_REG_FLASH_INST_TYPE		0x33
#define ANX7447_REG_FLASH_ERASE_TYPE		0x34
#define ANX7447_REG_OCM_CTRL_0			0x6E
#define ANX7447_REG_ADDR_GPIO_CTRL_0		0x88
#define ANX7447_REG_OCM_VERSION			0xB4

/* R_RAM_CTRL bit definitions */
#define ANX7447_R_RAM_CTRL_FLASH_DONE			(1<<7)

/* R_FLASH_RW_CTRL bit definitions */
#define ANX7447_R_FLASH_RW_CTRL_GENERAL_INST_EN		(1<<6)
#define ANX7447_R_FLASH_RW_CTRL_FLASH_ERASE_EN		(1<<5)
#define ANX7447_R_FLASH_RW_CTRL_WRITE_STATUS_EN		(1<<2)
#define ANX7447_R_FLASH_RW_CTRL_FLASH_READ		(1<<1)
#define ANX7447_R_FLASH_RW_CTRL_FLASH_WRITE		(1<<0)

/* R_FLASH_STATUS_0 definitions */
#define ANX7447_FLASH_STATUS_SPI_STATUS_0		0x43

/* FLASH_ERASE_TYPE bit definitions */
#define ANX7447_FLASH_INST_TYPE_WRITEENABLE		0x06
#define ANX7447_FLASH_ERASE_TYPE_CHIPERASE		0x60

/* OCM_CTRL_0 bit definitions */
#define ANX7447_OCM_CTRL_OCM_RESET			(1<<6)

/* ADDR_GPIO_CTRL_0 bit definitions */
#define ANX7447_ADDR_GPIO_CTRL_0_SPI_WP			(1<<7)
#define ANX7447_ADDR_GPIO_CTRL_0_SPI_CLK_ENABLE		(1<<6)
/* End of defines used for CONFIG_USB_PD_TCPM_ANX7447_OCM_ERASE_COMMAND */

struct anx7447_i2c_addr {
	uint16_t	tcpc_addr_flags;
	uint16_t	spi_addr_flags;
};

#define AN7447_TCPC0_I2C_ADDR_FLAGS	0x2C
#define AN7447_TCPC1_I2C_ADDR_FLAGS	0x2B
#define AN7447_TCPC2_I2C_ADDR_FLAGS	0x2A
#define AN7447_TCPC3_I2C_ADDR_FLAGS	0x29

#define AN7447_SPI0_I2C_ADDR_FLAGS	0x3F
#define AN7447_SPI1_I2C_ADDR_FLAGS	0x37
#define AN7447_SPI2_I2C_ADDR_FLAGS	0x32
#define AN7447_SPI3_I2C_ADDR_FLAGS	0x31

/*
 * Time TEST_R must be held high for a reset
 */
#define ANX74XX_RESET_HOLD_MS	1
/*
 * Time after TEST_R reset to wait for eFuse loading
 */
#define ANX74XX_RESET_FINISH_MS	2

int anx7447_set_power_supply_ready(int port);
int anx7447_power_supply_reset(int port);
int anx7447_board_charging_enable(int port, int enable);

void anx7447_hpd_mode_en(int port);
void anx7447_hpd_output_en(int port);

extern const struct tcpm_drv anx7447_tcpm_drv;
extern const struct usb_mux_driver anx7447_usb_mux_driver;
void anx7447_tcpc_clear_hpd_status(int port);
void anx7447_tcpc_update_hpd_status(const struct usb_mux *me,
				    mux_state_t mux_state);

/**
 * Erase OCM flash if it's not empty
 *
 * @param port: USB-C port number
 * @return: EC_SUCCESS or EC_ERROR_*
 */
int anx7447_flash_erase(int port);

#endif /* __CROS_EC_USB_PD_TCPM_ANX7688_H */