1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
|
/* Copyright 2022 The ChromiumOS Authors
* Use of this source code is governed by a BSD-style license that can be
* found in the LICENSE file.
*/
/* Gelarshie board configuration */
#ifndef __CROS_EC_BOARD_H
#define __CROS_EC_BOARD_H
#include "baseboard.h"
/* On-body detection */
#define CONFIG_BODY_DETECTION
#define CONFIG_BODY_DETECTION_SENSOR LID_ACCEL
#define CONFIG_BODY_DETECTION_VAR_NOISE_FACTOR 150 /* % */
#define CONFIG_GESTURE_DETECTION
#define CONFIG_GESTURE_DETECTION_MASK BIT(CONFIG_BODY_DETECTION_SENSOR)
#define CONFIG_GESTURE_HOST_DETECTION
#define CONFIG_BUTTON_TRIGGERED_RECOVERY
/* Internal SPI flash on NPCX7 */
#define CONFIG_FLASH_SIZE_BYTES (512 * 1024) /* 512KB internal spi flash */
/* Switchcap */
#define CONFIG_LN9310
/* Save some flash space */
#define CONFIG_LTO
#define CONFIG_USB_PD_DEBUG_LEVEL 2
#undef CONFIG_CMD_FLASHINFO
#undef CONFIG_CMD_MMAPINFO
#undef CONFIG_CMD_ACCELSPOOF
#undef CONFIG_CMD_ACCEL_FIFO
#undef CONFIG_CMD_ACCEL_INFO
#undef CONFIG_CMD_TASK_RESET
#undef CONFIG_CONSOLE_CMDHELP
/* Battery */
#define CONFIG_BATTERY_DEVICE_CHEMISTRY "LION"
#define CONFIG_BATTERY_REVIVE_DISCONNECT
#define CONFIG_BATTERY_FUEL_GAUGE
#define CONFIG_BATTERY_VENDOR_PARAM
/* charger margin */
#define CONFIG_CHARGER_INPUT_CURRENT_DERATE_PCT 5
/* Enable PD3.0 */
#define CONFIG_USB_PD_REV30
/* BC 1.2 Charger */
#define CONFIG_BC12_DETECT_PI3USB9201
/* USB */
#define CONFIG_USB_PD_TCPM_MULTI_PS8XXX
#define CONFIG_USB_PD_TCPM_PS8755
#define CONFIG_USB_PD_TCPM_PS8805
#define CONFIG_USB_PD_TCPM_PS8805_FORCE_DID
#define CONFIG_USBC_PPC_SN5S330
#define CONFIG_USB_PD_PORT_MAX_COUNT 2
/* BMI160 Lid accel/gyro */
#define CONFIG_ACCELGYRO_BMI160
#define CONFIG_ACCELGYRO_BMI160_INT_EVENT \
TASK_EVENT_MOTION_SENSOR_INTERRUPT(LID_ACCEL)
#define OPT3001_I2C_ADDR_FLAGS OPT3001_I2C_ADDR1_FLAGS
#define CONFIG_ACCELGYRO_BMI260
#define CONFIG_ACCELGYRO_BMI260_INT_EVENT \
TASK_EVENT_MOTION_SENSOR_INTERRUPT(LID_ACCEL)
#define CONFIG_TABLET_MODE
#define CONFIG_TABLET_MODE_SWITCH
#define CONFIG_GMR_TABLET_MODE
#define CONFIG_FRONT_PROXIMITY_SWITCH
#define CONFIG_MKBP_INPUT_DEVICES
#define CONFIG_DETACHABLE_BASE
#define CONFIG_BASE_ATTACHED_SWITCH
/* GPIO alias */
#define GPIO_AC_PRESENT GPIO_CHG_ACOK_OD
#define GPIO_WP_L GPIO_EC_FLASH_WP_ODL
#define GPIO_PMIC_RESIN_L GPIO_PM845_RESIN_L
#define GPIO_TABLET_MODE_L GPIO_LID_360_L
#define GPIO_KS_ATTACHED_L GPIO_LID_INT_N_HALL1
#define GPIO_KS_OPEN GPIO_LID_INT_N_HALL2
#define GPIO_SWITCHCAP_PG_INT_L GPIO_LN9310_INT
#ifndef __ASSEMBLER__
#include "gpio_signal.h"
#include "registers.h"
enum adc_channel {
ADC_VBUS,
ADC_AMON_BMON,
ADC_PSYS,
ADC_BASE_DET,
ADC_CH_COUNT
};
/* Motion sensors */
enum sensor_id {
LID_ACCEL = 0,
LID_GYRO,
SENSOR_COUNT,
};
enum pwm_channel { PWM_CH_DISPLIGHT = 0, PWM_CH_COUNT };
/* List of possible batteries */
enum battery_type {
BATTERY_GH02047XL_1C,
BATTERY_GH02047XL,
BATTERY_DS02032XL,
BATTERY_DS02032XL_1C,
BATTERY_TYPE_COUNT,
};
/* Reset all TCPCs. */
void board_reset_pd_mcu(void);
void board_set_tcpc_power_mode(int port, int mode);
/* Base detection */
void base_detect_interrupt(enum gpio_signal signal);
/* motion sensor interrupt */
void motion_interrupt(enum gpio_signal signal);
#endif /* !defined(__ASSEMBLER__) */
#endif /* __CROS_EC_BOARD_H */
|
