1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
|
/* Copyright (c) 2014 The Chromium OS Authors. All rights reserved.
* Use of this source code is governed by a BSD-style license that can be
* found in the LICENSE file.
*/
/* ryu board configuration */
#ifndef __BOARD_H
#define __BOARD_H
/* 48 MHz SYSCLK clock frequency */
#define CPU_CLOCK 48000000
/* the UART console is on USART2 (PD4/PD5) */
#undef CONFIG_UART_CONSOLE
#define CONFIG_UART_CONSOLE 2
/* By default, enable all console messages excepted USB */
#define CC_DEFAULT (CC_ALL & ~CC_MASK(CC_USBPD))
/* Optional features */
#undef CONFIG_CMD_HASH
#define CONFIG_CHARGE_MANAGER
#define CONFIG_CHARGE_RAMP
#define CONFIG_CMD_CHGRAMP
#define CONFIG_FORCE_CONSOLE_RESUME
#define CONFIG_STM_HWTIMER32
#define CONFIG_USB_POWER_DELIVERY
#define CONFIG_USB_PD_DUAL_ROLE
#define CONFIG_USB_PD_FLASH_ERASE_CHECK
#define CONFIG_USB_PD_INTERNAL_COMP
#define CONFIG_USB_SWITCH_PI3USB9281
#define CONFIG_USBC_SS_MUX
#define CONFIG_USBC_VCONN
#define CONFIG_ADC
#define CONFIG_ADC_SAMPLE_TIME 3
#define CONFIG_HW_CRC
#define CONFIG_I2C
#define CONFIG_LID_SWITCH
#define CONFIG_LOW_POWER_IDLE
#define CONFIG_VBOOT_HASH
#define CONFIG_WATCHDOG_HELP
#undef CONFIG_TASK_PROFILING
#define CONFIG_INDUCTIVE_CHARGING
#undef CONFIG_HIBERNATE
#undef CONFIG_UART_TX_DMA /* DMAC_CH7 is used by USB PD */
#define CONFIG_UART_RX_DMA
#define CONFIG_UART_RX_DMA_CH STM32_DMAC_USART2_RX
/* Charging/Power configuration */
#define CONFIG_BATTERY_RYU
#define CONFIG_BATTERY_BQ27541
#define CONFIG_BATTERY_CUT_OFF
#define CONFIG_BATTERY_REQUESTS_NIL_WHEN_DEAD
#define CONFIG_BATTERY_REVIVE_DISCONNECT
#define CONFIG_CHARGER
#define CONFIG_CHARGER_V2
#define CONFIG_CHARGER_BQ24773
#define CONFIG_CHARGER_ILIM_PIN_DISABLED
#define CONFIG_CHARGER_PROFILE_OVERRIDE
#define CONFIG_CHARGER_SENSE_RESISTOR 5
#define CONFIG_CHARGER_SENSE_RESISTOR_AC 10
#define CONFIG_CHARGER_INPUT_CURRENT 512
#define CONFIG_CHARGER_DISCHARGE_ON_AC
#define CONFIG_CHIPSET_TEGRA
#define CONFIG_PMIC_FW_LONG_PRESS_TIMER
#define CONFIG_POWER_COMMON
#define CONFIG_POWER_BUTTON
#define CONFIG_POWER_BUTTON_ACTIVE_STATE 1
/* I2C ports configuration */
#define I2C_PORT_MASTER 0
#define I2C_PORT_SLAVE 1
#define I2C_PORT_EC I2C_PORT_SLAVE
#define I2C_PORT_CHARGER I2C_PORT_MASTER
#define I2C_PORT_BATTERY I2C_PORT_MASTER
#define I2C_PORT_LIGHTBAR I2C_PORT_MASTER
/* slave address for host commands */
#ifdef HAS_TASK_HOSTCMD
#define CONFIG_HOSTCMD_I2C_SLAVE_ADDR 0x3c
#endif
/* USART and USB stream drivers */
#define CONFIG_STREAM_USART
#define CONFIG_STREAM_USART1
#define CONFIG_STREAM_USART3
#define CONFIG_STREAM_USB
/* USB Configuration */
#define CONFIG_USB
#define CONFIG_USB_PID 0x500f
/* Prevent the USB driver from initializing at boot */
#define CONFIG_USB_INHIBIT_INIT
/* USB interface indexes (use define rather than enum to expand them) */
#define USB_IFACE_CONSOLE 0
#define USB_IFACE_AP_STREAM 1
#define USB_IFACE_SH_STREAM 2
#define USB_IFACE_SPI 3
#define USB_IFACE_COUNT 4
/* USB endpoint indexes (use define rather than enum to expand them) */
#define USB_EP_CONTROL 0
#define USB_EP_CONSOLE 1
#define USB_EP_AP_STREAM 2
#define USB_EP_SH_STREAM 3
#define USB_EP_SPI 4
#define USB_EP_COUNT 5
/* Enable console over USB */
#define CONFIG_USB_CONSOLE
/* Enable control of SPI over USB */
#define CONFIG_SPI_MASTER_PORT 2
#define CONFIG_SPI_CS_GPIO GPIO_SPI_FLASH_NSS
#define CONFIG_USB_SPI
/* Enable Case Closed Debugging */
#define CONFIG_CASE_CLOSED_DEBUG
/* Maximum number of deferrable functions */
#undef DEFERRABLE_MAX_COUNT
#define DEFERRABLE_MAX_COUNT 12
#ifndef __ASSEMBLER__
/* Timer selection */
#define TIM_CLOCK32 5
#define TIM_WATCHDOG 19
#include "gpio_signal.h"
enum power_signal {
TEGRA_XPSHOLD = 0,
TEGRA_SUSPEND_ASSERTED,
/* Number of power signals */
POWER_SIGNAL_COUNT
};
/* ADC signal */
enum adc_channel {
ADC_VBUS = 0,
ADC_CC1_PD,
ADC_CC2_PD,
ADC_IADP,
ADC_IBAT,
/* Number of ADC channels */
ADC_CH_COUNT
};
/* Charge suppliers */
enum charge_supplier {
CHARGE_SUPPLIER_PD,
CHARGE_SUPPLIER_TYPEC,
CHARGE_SUPPLIER_BC12_DCP,
CHARGE_SUPPLIER_BC12_CDP,
CHARGE_SUPPLIER_BC12_SDP,
CHARGE_SUPPLIER_PROPRIETARY,
CHARGE_SUPPLIER_OTHER,
CHARGE_SUPPLIER_VBUS,
CHARGE_SUPPLIER_COUNT
};
/* supplier_priority table defined in board.c */
extern const int supplier_priority[];
/* USB string indexes */
enum usb_strings {
USB_STR_DESC = 0,
USB_STR_VENDOR,
USB_STR_PRODUCT,
USB_STR_VERSION,
USB_STR_CONSOLE_NAME,
USB_STR_AP_STREAM_NAME,
USB_STR_SH_STREAM_NAME,
USB_STR_COUNT
};
/* Discharge battery when on AC power for factory test. */
int board_discharge_on_ac(int enable);
/* Set the charge current limit. */
void board_set_charge_limit(int charge_ma);
#endif /* !__ASSEMBLER__ */
#endif /* __BOARD_H */
|
