diff options
Diffstat (limited to 'doc/administration/troubleshooting/elasticsearch.md')
-rw-r--r-- | doc/administration/troubleshooting/elasticsearch.md | 8 |
1 files changed, 4 insertions, 4 deletions
diff --git a/doc/administration/troubleshooting/elasticsearch.md b/doc/administration/troubleshooting/elasticsearch.md index a39fe4ba8c3..12b82e4bc48 100644 --- a/doc/administration/troubleshooting/elasticsearch.md +++ b/doc/administration/troubleshooting/elasticsearch.md @@ -189,7 +189,7 @@ Moving past that, it is best to attempt the same search using the [Elasticsearch If the results: -- Sync up, then there is not a technical "issue" per se. Instead, it might be a problem +- Sync up, then there is not a technical "issue." Instead, it might be a problem with the Elasticsearch filters we are using. This can be complicated, so it is best to escalate to GitLab support to check these and guide you on the potential on whether or not a feature request is needed. @@ -330,10 +330,10 @@ feel free to update that page with issues you encounter and solutions. Setting up Elasticsearch isn't too bad, but it can be a bit finicky and time consuming. -The easiest method is to spin up a docker container with the required version and +The easiest method is to spin up a Docker container with the required version and bind ports 9200/9300 so it can be used. -The following is an example of running a docker container of Elasticsearch v7.2.0: +The following is an example of running a Docker container of Elasticsearch v7.2.0: ```shell docker pull docker.elastic.co/elasticsearch/elasticsearch:7.2.0 @@ -342,7 +342,7 @@ docker run -p 9200:9200 -p 9300:9300 -e "discovery.type=single-node" docker.elas From here, you can: -- Grab the IP of the docker container (use `docker inspect <container_id>`) +- Grab the IP of the Docker container (use `docker inspect <container_id>`) - Use `<IP.add.re.ss:9200>` to communicate with it. This is a quick method to test out Elasticsearch, but by no means is this a |