To create @file{tpasswd.conf} which holds the g and n values for SRP protocol
(generator and a large prime), run:
@example
$ srptool --create-conf /etc/tpasswd.conf
@end example

This command will create @file{/etc/tpasswd} and will add user 'test' (you
will also be prompted for a password). Verifiers are stored by default
in the way libsrp expects.
@example
$ srptool --passwd /etc/tpasswd --passwd-conf /etc/tpasswd.conf -u test
@end example


This command will check against a password. If the password matches
the one in @file{/etc/tpasswd} you will get an ok.
@example
$ srptool --passwd /etc/tpasswd --passwd\-conf /etc/tpasswd.conf --verify -u test
@end example