Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6: (1674 commits)
  qlcnic: adding co maintainer
  ixgbe: add support for active DA cables
  ixgbe: dcb, do not tag tc_prio_control frames
  ixgbe: fix ixgbe_tx_is_paused logic
  ixgbe: always enable vlan strip/insert when DCB is enabled
  ixgbe: remove some redundant code in setting FCoE FIP filter
  ixgbe: fix wrong offset to fc_frame_header in ixgbe_fcoe_ddp
  ixgbe: fix header len when unsplit packet overflows to data buffer
  ipv6: Never schedule DAD timer on dead address
  ipv6: Use POSTDAD state
  ipv6: Use state_lock to protect ifa state
  ipv6: Replace inet6_ifaddr->dead with state
  cxgb4: notify upper drivers if the device is already up when they load
  cxgb4: keep interrupts available when the ports are brought down
  cxgb4: fix initial addition of MAC address
  cnic: Return SPQ credit to bnx2x after ring setup and shutdown.
  cnic: Convert cnic_local_flags to atomic ops.
  can: Fix SJA1000 command register writes on SMP systems
  bridge: fix build for CONFIG_SYSFS disabled
  ARCNET: Limit com20020 PCI ID matches for SOHARD cards
  ...

Fix up various conflicts with pcmcia tree drivers/net/
{pcmcia/3c589_cs.c, wireless/orinoco/orinoco_cs.c and
wireless/orinoco/spectrum_cs.c} and feature removal
(Documentation/feature-removal-schedule.txt).

Also fix a non-content conflict due to pm_qos_requirement getting
renamed in the PM tree (now pm_qos_request) in net/mac80211/scan.c

1 files changed, 76 insertions, 0 deletions

diff --git a/include/linux/nl80211.h b/include/linux/nl80211.h
index 28ba20fda3e2..b7c77f9712f4 100644
--- a/include/linux/nl80211.h
+++ b/include/linux/nl80211.h
@@ -52,6 +52,8 @@
  *	%NL80211_ATTR_WIPHY_CHANNEL_TYPE, %NL80211_ATTR_WIPHY_RETRY_SHORT,
  *	%NL80211_ATTR_WIPHY_RETRY_LONG, %NL80211_ATTR_WIPHY_FRAG_THRESHOLD,
  *	and/or %NL80211_ATTR_WIPHY_RTS_THRESHOLD.
+ *	However, for setting the channel, see %NL80211_CMD_SET_CHANNEL
+ *	instead, the support here is for backward compatibility only.
  * @NL80211_CMD_NEW_WIPHY: Newly created wiphy, response to get request
  *	or rename notification. Has attributes %NL80211_ATTR_WIPHY and
  *	%NL80211_ATTR_WIPHY_NAME.
@@ -323,6 +325,21 @@
  *	the TX command and %NL80211_ATTR_FRAME includes the contents of the
  *	frame. %NL80211_ATTR_ACK flag is included if the recipient acknowledged
  *	the frame.
+ * @NL80211_CMD_SET_CQM: Connection quality monitor configuration. This command
+ *	is used to configure connection quality monitoring notification trigger
+ *	levels.
+ * @NL80211_CMD_NOTIFY_CQM: Connection quality monitor notification. This
+ *	command is used as an event to indicate the that a trigger level was
+ *	reached.
+ * @NL80211_CMD_SET_CHANNEL: Set the channel (using %NL80211_ATTR_WIPHY_FREQ
+ *	and %NL80211_ATTR_WIPHY_CHANNEL_TYPE) the given interface (identifed
+ *	by %NL80211_ATTR_IFINDEX) shall operate on.
+ *	In case multiple channels are supported by the device, the mechanism
+ *	with which it switches channels is implementation-defined.
+ *	When a monitor interface is given, it can only switch channel while
+ *	no other interfaces are operating to avoid disturbing the operation
+ *	of any other interfaces, and other interfaces will again take
+ *	precedence when they are used.
  *
  * @NL80211_CMD_MAX: highest used command number
  * @__NL80211_CMD_AFTER_LAST: internal use
@@ -419,6 +436,11 @@ enum nl80211_commands {
 	NL80211_CMD_SET_POWER_SAVE,
 	NL80211_CMD_GET_POWER_SAVE,
 
+	NL80211_CMD_SET_CQM,
+	NL80211_CMD_NOTIFY_CQM,
+
+	NL80211_CMD_SET_CHANNEL,
+
 	/* add new commands above here */
 
 	/* used to define NL80211_CMD_MAX below */
@@ -691,6 +713,18 @@ enum nl80211_commands {
  * @NL80211_ATTR_ACK: Flag attribute indicating that the frame was
  *	acknowledged by the recipient.
  *
+ * @NL80211_ATTR_CQM: connection quality monitor configuration in a
+ *	nested attribute with %NL80211_ATTR_CQM_* sub-attributes.
+ *
+ * @NL80211_ATTR_LOCAL_STATE_CHANGE: Flag attribute to indicate that a command
+ *	is requesting a local authentication/association state change without
+ *	invoking actual management frame exchange. This can be used with
+ *	NL80211_CMD_AUTHENTICATE, NL80211_CMD_DEAUTHENTICATE,
+ *	NL80211_CMD_DISASSOCIATE.
+ *
+ * @NL80211_ATTR_AP_ISOLATE: (AP mode) Do not forward traffic between stations
+ *	connected to this BSS.
+ *
  * @NL80211_ATTR_MAX: highest attribute number currently defined
  * @__NL80211_ATTR_AFTER_LAST: internal use
  */
@@ -842,6 +876,12 @@ enum nl80211_attrs {
 
 	NL80211_ATTR_PS_STATE,
 
+	NL80211_ATTR_CQM,
+
+	NL80211_ATTR_LOCAL_STATE_CHANGE,
+
+	NL80211_ATTR_AP_ISOLATE,
+
 	/* add attributes here, update the policy in nl80211.c */
 
 	__NL80211_ATTR_AFTER_LAST,
@@ -1583,4 +1623,40 @@ enum nl80211_ps_state {
 	NL80211_PS_ENABLED,
 };
 
+/**
+ * enum nl80211_attr_cqm - connection quality monitor attributes
+ * @__NL80211_ATTR_CQM_INVALID: invalid
+ * @NL80211_ATTR_CQM_RSSI_THOLD: RSSI threshold in dBm. This value specifies
+ *	the threshold for the RSSI level at which an event will be sent. Zero
+ *	to disable.
+ * @NL80211_ATTR_CQM_RSSI_HYST: RSSI hysteresis in dBm. This value specifies
+ *	the minimum amount the RSSI level must change after an event before a
+ *	new event may be issued (to reduce effects of RSSI oscillation).
+ * @NL80211_ATTR_CQM_RSSI_THRESHOLD_EVENT: RSSI threshold event
+ * @__NL80211_ATTR_CQM_AFTER_LAST: internal
+ * @NL80211_ATTR_CQM_MAX: highest key attribute
+ */
+enum nl80211_attr_cqm {
+	__NL80211_ATTR_CQM_INVALID,
+	NL80211_ATTR_CQM_RSSI_THOLD,
+	NL80211_ATTR_CQM_RSSI_HYST,
+	NL80211_ATTR_CQM_RSSI_THRESHOLD_EVENT,
+
+	/* keep last */
+	__NL80211_ATTR_CQM_AFTER_LAST,
+	NL80211_ATTR_CQM_MAX = __NL80211_ATTR_CQM_AFTER_LAST - 1
+};
+
+/**
+ * enum nl80211_cqm_rssi_threshold_event - RSSI threshold event
+ * @NL80211_CQM_RSSI_THRESHOLD_EVENT_LOW - The RSSI level is lower than the
+ *      configured threshold
+ * @NL80211_CQM_RSSI_THRESHOLD_EVENT_HIGH - The RSSI is higher than the
+ *      configured threshold
+ */
+enum nl80211_cqm_rssi_threshold_event {
+	NL80211_CQM_RSSI_THRESHOLD_EVENT_LOW,
+	NL80211_CQM_RSSI_THRESHOLD_EVENT_HIGH,
+};
+
 #endif /* __LINUX_NL80211_H */