[PATCH] USB: Add isp116x-hcd USB host controller driver

This patch provides an "isp116x-hcd" driver for Philips'
ISP1160/ISP1161 USB host controllers.

The driver:
 - is relatively small, meant for use on embedded platforms.
 - runs usbtests 1-14 without problems for days.
 - has been in use by 6-7 different people on ARM and PPC platforms,
   running a range of devices including USB hubs.
 - supports suspend/resume of both the platform device and the root hub;
   supports remote wakeup of the root hub (but NOT the platform device)
   by USB devices.
 - does NOT support ISO transfers (nobody has asked for them).
 - is PIO-only.

Signed-off-by: Olav Kongas <ok@artecdesign.ee>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

1 files changed, 47 insertions, 0 deletions

diff --git a/include/linux/usb_isp116x.h b/include/linux/usb_isp116x.h
new file mode 100644
index 000000000000..5f5a9d9bd6c2
--- /dev/null
+++ b/include/linux/usb_isp116x.h
@@ -0,0 +1,47 @@
+
+/*
+ * Board initialization code should put one of these into dev->platform_data
+ * and place the isp116x onto platform_bus.
+ */
+
+struct isp116x_platform_data {
+	/* Enable internal resistors on downstream ports */
+	unsigned sel15Kres:1;
+	/* Chip's internal clock won't be stopped in suspended state.
+	   Setting/unsetting this bit takes effect only if
+	   'remote_wakeup_enable' below is not set. */
+	unsigned clknotstop:1;
+	/* On-chip overcurrent protection */
+	unsigned oc_enable:1;
+	/* INT output polarity */
+	unsigned int_act_high:1;
+	/* INT edge or level triggered */
+	unsigned int_edge_triggered:1;
+	/* WAKEUP pin connected - NOT SUPPORTED  */
+	/* unsigned remote_wakeup_connected:1; */
+	/* Wakeup by devices on usb bus enabled */
+	unsigned remote_wakeup_enable:1;
+	/* Switch or not to switch (keep always powered) */
+	unsigned no_power_switching:1;
+	/* Ganged port power switching (0) or individual port
+	   power switching (1) */
+	unsigned power_switching_mode:1;
+	/* Given port_power, msec/2 after power on till power good */
+	u8 potpg;
+	/* Hardware reset set/clear. If implemented, this function must:
+	   if set == 0,   deassert chip's HW reset pin
+	   otherwise,     assert chip's HW reset pin       */
+	void (*reset) (struct device * dev, int set);
+	/* Hardware clock start/stop. If implemented, this function must:
+	   if start == 0,    stop the external clock
+	   otherwise,        start the external clock
+	 */
+	void (*clock) (struct device * dev, int start);
+	/* Inter-io delay (ns). The chip is picky about access timings; it
+	   expects at least:
+	   150ns delay between consecutive accesses to DATA_REG,
+	   300ns delay between access to ADDR_REG and DATA_REG
+	   OE, WE MUST NOT be changed during these intervals
+	 */
+	void (*delay) (struct device * dev, int delay);
+};