summaryrefslogtreecommitdiff
diff options
context:
space:
mode:
-rw-r--r--include/media/v4l2-subdev.h23
1 files changed, 23 insertions, 0 deletions
diff --git a/include/media/v4l2-subdev.h b/include/media/v4l2-subdev.h
index 02c6f4d11ed3..9195ad490ee2 100644
--- a/include/media/v4l2-subdev.h
+++ b/include/media/v4l2-subdev.h
@@ -90,10 +90,31 @@ struct v4l2_decode_vbi_line {
not yet implemented) since ops provide proper type-checking.
*/
+/* Subdevice external IO pin configuration */
+#define V4L2_SUBDEV_IO_PIN_DISABLE (1 << 0) /* ENABLE assumed */
+#define V4L2_SUBDEV_IO_PIN_OUTPUT (1 << 1)
+#define V4L2_SUBDEV_IO_PIN_INPUT (1 << 2)
+#define V4L2_SUBDEV_IO_PIN_SET_VALUE (1 << 3) /* Set output value */
+#define V4L2_SUBDEV_IO_PIN_ACTIVE_LOW (1 << 4) /* ACTIVE HIGH assumed */
+
+struct v4l2_subdev_io_pin_config {
+ u32 flags; /* V4L2_SUBDEV_IO_PIN_* flags for this pin's config */
+ u8 pin; /* Chip external IO pin to configure */
+ u8 function; /* Internal signal pad/function to route to IO pin */
+ u8 value; /* Initial value for pin - e.g. GPIO output value */
+ u8 strength; /* Pin drive strength */
+};
+
/* s_config: if set, then it is always called by the v4l2_i2c_new_subdev*
functions after the v4l2_subdev was registered. It is used to pass
platform data to the subdev which can be used during initialization.
+ s_io_pin_config: configure one or more chip I/O pins for chips that
+ multiplex different internal signal pads out to IO pins. This function
+ takes a pointer to an array of 'n' pin configuration entries, one for
+ each pin being configured. This function could be called at times
+ other than just subdevice initialization.
+
init: initialize the sensor registors to some sort of reasonable default
values. Do not use for new drivers and should be removed in existing
drivers.
@@ -115,6 +136,8 @@ struct v4l2_subdev_core_ops {
int (*g_chip_ident)(struct v4l2_subdev *sd, struct v4l2_dbg_chip_ident *chip);
int (*log_status)(struct v4l2_subdev *sd);
int (*s_config)(struct v4l2_subdev *sd, int irq, void *platform_data);
+ int (*s_io_pin_config)(struct v4l2_subdev *sd, size_t n,
+ struct v4l2_subdev_io_pin_config *pincfg);
int (*init)(struct v4l2_subdev *sd, u32 val);
int (*load_fw)(struct v4l2_subdev *sd);
int (*reset)(struct v4l2_subdev *sd, u32 val);