diff options
Diffstat (limited to 'drivers/scsi/fcoe')
| -rw-r--r-- | drivers/scsi/fcoe/fcoe.c | 42 |
1 files changed, 29 insertions, 13 deletions
diff --git a/drivers/scsi/fcoe/fcoe.c b/drivers/scsi/fcoe/fcoe.c index 7022a16b14f6..4834d3c130d6 100644 --- a/drivers/scsi/fcoe/fcoe.c +++ b/drivers/scsi/fcoe/fcoe.c @@ -74,6 +74,7 @@ static int fcoe_rcv(struct sk_buff *, struct net_device *, static int fcoe_percpu_receive_thread(void *); static void fcoe_clean_pending_queue(struct fc_lport *); static void fcoe_percpu_clean(struct fc_lport *); +static int fcoe_link_speed_update(struct fc_lport *); static int fcoe_link_ok(struct fc_lport *); static struct fc_lport *fcoe_hostlist_lookup(const struct net_device *); @@ -631,6 +632,8 @@ static int fcoe_netdev_config(struct fc_lport *lport, struct net_device *netdev) port->fcoe_pending_queue_active = 0; setup_timer(&port->timer, fcoe_queue_timer, (unsigned long)lport); + fcoe_link_speed_update(lport); + if (!lport->vport) { /* * Use NAA 1&2 (FC-FS Rev. 2.0, Sec. 15) to generate WWNN/WWPN: @@ -1829,6 +1832,9 @@ static int fcoe_device_notification(struct notifier_block *notifier, FCOE_NETDEV_DBG(netdev, "Unknown event %ld " "from netdev netlink\n", event); } + + fcoe_link_speed_update(lport); + if (link_possible && !fcoe_link_ok(lport)) fcoe_ctlr_link_up(&fcoe->ctlr); else if (fcoe_ctlr_link_down(&fcoe->ctlr)) { @@ -2128,26 +2134,19 @@ out_nomod: } /** - * fcoe_link_ok() - Check if the link is OK for a local port - * @lport: The local port to check link on - * - * Any permanently-disqualifying conditions have been previously checked. - * This also updates the speed setting, which may change with link for 100/1000. - * - * This function should probably be checking for PAUSE support at some point - * in the future. Currently Per-priority-pause is not determinable using - * ethtool, so we shouldn't be restrictive until that problem is resolved. - * - * Returns: 0 if link is OK for use by FCoE. + * fcoe_link_speed_update() - Update the supported and actual link speeds + * @lport: The local port to update speeds for * + * Returns: 0 if the ethtool query was successful + * -1 if the ethtool query failed */ -int fcoe_link_ok(struct fc_lport *lport) +int fcoe_link_speed_update(struct fc_lport *lport) { struct fcoe_port *port = lport_priv(lport); struct net_device *netdev = port->fcoe->netdev; struct ethtool_cmd ecmd = { ETHTOOL_GSET }; - if (netif_oper_up(netdev) && !dev_ethtool_get_settings(netdev, &ecmd)) { + if (!dev_ethtool_get_settings(netdev, &ecmd)) { lport->link_supported_speeds &= ~(FC_PORTSPEED_1GBIT | FC_PORTSPEED_10GBIT); if (ecmd.supported & (SUPPORTED_1000baseT_Half | @@ -2167,6 +2166,23 @@ int fcoe_link_ok(struct fc_lport *lport) } /** + * fcoe_link_ok() - Check if the link is OK for a local port + * @lport: The local port to check link on + * + * Returns: 0 if link is UP and OK, -1 if not + * + */ +int fcoe_link_ok(struct fc_lport *lport) +{ + struct fcoe_port *port = lport_priv(lport); + struct net_device *netdev = port->fcoe->netdev; + + if (netif_oper_up(netdev)) + return 0; + return -1; +} + +/** * fcoe_percpu_clean() - Clear all pending skbs for an local port * @lport: The local port whose skbs are to be cleared * |