diff options
Diffstat (limited to 'include')
| -rw-r--r-- | include/linux/nl80211.h | 65 | ||||
| -rw-r--r-- | include/net/cfg80211.h | 131 | ||||
| -rw-r--r-- | include/net/mac80211.h | 6 | ||||
| -rw-r--r-- | include/net/wireless.h | 3 |
4 files changed, 203 insertions, 2 deletions
diff --git a/include/linux/nl80211.h b/include/linux/nl80211.h index 4bc27049f4e5..8802d1bda382 100644 --- a/include/linux/nl80211.h +++ b/include/linux/nl80211.h @@ -143,6 +143,13 @@ * added to all specified management frames generated by * kernel/firmware/driver. * + * @NL80211_CMD_GET_SCAN: get scan results + * @NL80211_CMD_TRIGGER_SCAN: trigger a new scan with the given parameters + * @NL80211_CMD_NEW_SCAN_RESULTS: scan notification (as a reply to + * NL80211_CMD_GET_SCAN and on the "scan" multicast group) + * @NL80211_CMD_SCAN_ABORTED: scan was aborted, for unspecified reasons, + * partial scan results may be available + * * @NL80211_CMD_MAX: highest used command number * @__NL80211_CMD_AFTER_LAST: internal use */ @@ -192,6 +199,11 @@ enum nl80211_commands { NL80211_CMD_GET_REG, + NL80211_CMD_GET_SCAN, + NL80211_CMD_TRIGGER_SCAN, + NL80211_CMD_NEW_SCAN_RESULTS, + NL80211_CMD_SCAN_ABORTED, + /* add new commands above here */ /* used to define NL80211_CMD_MAX below */ @@ -305,6 +317,18 @@ enum nl80211_commands { * @NL80211_ATTR_IE: Information element(s) data (used, e.g., with * %NL80211_CMD_SET_MGMT_EXTRA_IE). * + * @NL80211_ATTR_MAX_NUM_SCAN_SSIDS: number of SSIDs you can scan with + * a single scan request, a wiphy attribute. + * + * @NL80211_ATTR_SCAN_FREQUENCIES: nested attribute with frequencies (in MHz) + * @NL80211_ATTR_SCAN_SSIDS: nested attribute with SSIDs, leave out for passive + * scanning and include a zero-length SSID (wildcard) for wildcard scan + * @NL80211_ATTR_SCAN_GENERATION: the scan generation increases whenever the + * scan result list changes (BSS expired or added) so that applications + * can verify that they got a single, consistent snapshot (when all dump + * messages carried the same generation number) + * @NL80211_ATTR_BSS: scan result BSS + * * @NL80211_ATTR_MAX: highest attribute number currently defined * @__NL80211_ATTR_AFTER_LAST: internal use */ @@ -372,6 +396,13 @@ enum nl80211_attrs { NL80211_ATTR_MGMT_SUBTYPE, NL80211_ATTR_IE, + NL80211_ATTR_MAX_NUM_SCAN_SSIDS, + + NL80211_ATTR_SCAN_FREQUENCIES, + NL80211_ATTR_SCAN_SSIDS, + NL80211_ATTR_SCAN_GENERATION, + NL80211_ATTR_BSS, + /* add attributes here, update the policy in nl80211.c */ __NL80211_ATTR_AFTER_LAST, @@ -841,4 +872,38 @@ enum nl80211_channel_type { NL80211_CHAN_HT40MINUS, NL80211_CHAN_HT40PLUS }; + +/** + * enum nl80211_bss - netlink attributes for a BSS + * + * @__NL80211_BSS_INVALID: invalid + * @NL80211_BSS_FREQUENCY: frequency in MHz (u32) + * @NL80211_BSS_TSF: TSF of the received probe response/beacon (u64) + * @NL80211_BSS_BEACON_INTERVAL: beacon interval of the (I)BSS (u16) + * @NL80211_BSS_CAPABILITY: capability field (CPU order, u16) + * @NL80211_BSS_INFORMATION_ELEMENTS: binary attribute containing the + * raw information elements from the probe response/beacon (bin) + * @NL80211_BSS_SIGNAL_MBM: signal strength of probe response/beacon + * in mBm (100 * dBm) (s32) + * @NL80211_BSS_SIGNAL_UNSPEC: signal strength of the probe response/beacon + * in unspecified units, scaled to 0..100 (u8) + * @__NL80211_BSS_AFTER_LAST: internal + * @NL80211_BSS_MAX: highest BSS attribute + */ +enum nl80211_bss { + __NL80211_BSS_INVALID, + NL80211_BSS_BSSID, + NL80211_BSS_FREQUENCY, + NL80211_BSS_TSF, + NL80211_BSS_BEACON_INTERVAL, + NL80211_BSS_CAPABILITY, + NL80211_BSS_INFORMATION_ELEMENTS, + NL80211_BSS_SIGNAL_MBM, + NL80211_BSS_SIGNAL_UNSPEC, + + /* keep last */ + __NL80211_BSS_AFTER_LAST, + NL80211_BSS_MAX = __NL80211_BSS_AFTER_LAST - 1 +}; + #endif /* __LINUX_NL80211_H */ diff --git a/include/net/cfg80211.h b/include/net/cfg80211.h index dd1fd51638fc..09a0b268e5cf 100644 --- a/include/net/cfg80211.h +++ b/include/net/cfg80211.h @@ -4,6 +4,10 @@ #include <linux/netlink.h> #include <linux/skbuff.h> #include <linux/nl80211.h> +#include <linux/if_ether.h> +#include <linux/ieee80211.h> +#include <linux/wireless.h> +#include <net/iw_handler.h> #include <net/genetlink.h> /* remove once we remove the wext stuff */ #include <net/iw_handler.h> @@ -505,6 +509,83 @@ struct wiphy; struct ieee80211_channel; /** + * struct cfg80211_ssid - SSID description + * @ssid: the SSID + * @ssid_len: length of the ssid + */ +struct cfg80211_ssid { + u8 ssid[IEEE80211_MAX_SSID_LEN]; + u8 ssid_len; +}; + +/** + * struct cfg80211_scan_request - scan request description + * + * @ssids: SSIDs to scan for (active scan only) + * @n_ssids: number of SSIDs + * @channels: channels to scan on. + * @n_channels: number of channels for each band + * @wiphy: the wiphy this was for + * @ifidx: the interface index + */ +struct cfg80211_scan_request { + struct cfg80211_ssid *ssids; + int n_ssids; + struct ieee80211_channel **channels; + u32 n_channels; + + /* internal */ + struct wiphy *wiphy; + int ifidx; +}; + +/** + * enum cfg80211_signal_type - signal type + * + * @CFG80211_SIGNAL_TYPE_NONE: no signal strength information available + * @CFG80211_SIGNAL_TYPE_MBM: signal strength in mBm (100*dBm) + * @CFG80211_SIGNAL_TYPE_UNSPEC: signal strength, increasing from 0 through 100 + */ +enum cfg80211_signal_type { + CFG80211_SIGNAL_TYPE_NONE, + CFG80211_SIGNAL_TYPE_MBM, + CFG80211_SIGNAL_TYPE_UNSPEC, +}; + +/** + * struct cfg80211_bss - BSS description + * + * This structure describes a BSS (which may also be a mesh network) + * for use in scan results and similar. + * + * @bssid: BSSID of the BSS + * @tsf: timestamp of last received update + * @beacon_interval: the beacon interval as from the frame + * @capability: the capability field in host byte order + * @information_elements: the information elements (Note that there + * is no guarantee that these are well-formed!) + * @len_information_elements: total length of the information elements + * @signal: signal strength value + * @signal_type: signal type + * @priv: private area for driver use, has at least wiphy->bss_priv_size bytes + */ +struct cfg80211_bss { + struct ieee80211_channel *channel; + + u8 bssid[ETH_ALEN]; + u64 tsf; + u16 beacon_interval; + u16 capability; + u8 *information_elements; + size_t len_information_elements; + + s32 signal; + enum cfg80211_signal_type signal_type; + + u8 priv[0] __attribute__((__aligned__(sizeof(void *)))); +}; + +/** * struct cfg80211_ops - backend description for wireless configuration * * This struct is registered by fullmac card drivers and/or wireless stacks @@ -571,6 +652,11 @@ struct ieee80211_channel; * @set_channel: Set channel * * @set_mgmt_extra_ie: Set extra IE data for management frames + * + * @scan: Request to do a scan. If returning zero, the scan request is given + * the driver, and will be valid until passed to cfg80211_scan_done(). + * For scan results, call cfg80211_inform_bss(); you can call this outside + * the scan/scan_done bracket too. */ struct cfg80211_ops { int (*suspend)(struct wiphy *wiphy); @@ -648,6 +734,9 @@ struct cfg80211_ops { int (*set_mgmt_extra_ie)(struct wiphy *wiphy, struct net_device *dev, struct mgmt_extra_ie_params *params); + + int (*scan)(struct wiphy *wiphy, struct net_device *dev, + struct cfg80211_scan_request *request); }; /* temporary wext handlers */ @@ -658,5 +747,47 @@ int cfg80211_wext_siwmode(struct net_device *dev, struct iw_request_info *info, u32 *mode, char *extra); int cfg80211_wext_giwmode(struct net_device *dev, struct iw_request_info *info, u32 *mode, char *extra); +int cfg80211_wext_siwscan(struct net_device *dev, + struct iw_request_info *info, + union iwreq_data *wrqu, char *extra); +int cfg80211_wext_giwscan(struct net_device *dev, + struct iw_request_info *info, + struct iw_point *data, char *extra); + +/** + * cfg80211_scan_done - notify that scan finished + * + * @request: the corresponding scan request + * @aborted: set to true if the scan was aborted for any reason, + * userspace will be notified of that + */ +void cfg80211_scan_done(struct cfg80211_scan_request *request, bool aborted); + +/** + * cfg80211_inform_bss - inform cfg80211 of a new BSS + * + * @wiphy: the wiphy reporting the BSS + * @bss: the found BSS + * @gfp: context flags + * + * This informs cfg80211 that BSS information was found and + * the BSS should be updated/added. + */ +struct cfg80211_bss* +cfg80211_inform_bss_frame(struct wiphy *wiphy, + struct ieee80211_channel *channel, + struct ieee80211_mgmt *mgmt, size_t len, + s32 signal, enum cfg80211_signal_type sigtype, + gfp_t gfp); + +struct cfg80211_bss *cfg80211_get_bss(struct wiphy *wiphy, + struct ieee80211_channel *channel, + const u8 *bssid, + const u8 *ssid, size_t ssid_len); +struct cfg80211_bss *cfg80211_get_mesh(struct wiphy *wiphy, + struct ieee80211_channel *channel, + const u8 *meshid, size_t meshidlen, + const u8 *meshcfg); +void cfg80211_put_bss(struct cfg80211_bss *bss); #endif /* __NET_CFG80211_H */ diff --git a/include/net/mac80211.h b/include/net/mac80211.h index 341f3e595ebd..88fa3e03e3e9 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -1406,7 +1406,8 @@ struct ieee80211_ops { void (*update_tkip_key)(struct ieee80211_hw *hw, struct ieee80211_key_conf *conf, const u8 *address, u32 iv32, u16 *phase1key); - int (*hw_scan)(struct ieee80211_hw *hw, u8 *ssid, size_t len); + int (*hw_scan)(struct ieee80211_hw *hw, + struct cfg80211_scan_request *req); int (*get_stats)(struct ieee80211_hw *hw, struct ieee80211_low_level_stats *stats); void (*get_tkip_seq)(struct ieee80211_hw *hw, u8 hw_key_idx, @@ -1844,8 +1845,9 @@ void ieee80211_wake_queues(struct ieee80211_hw *hw); * mac80211 that the scan finished. * * @hw: the hardware that finished the scan + * @aborted: set to true if scan was aborted */ -void ieee80211_scan_completed(struct ieee80211_hw *hw); +void ieee80211_scan_completed(struct ieee80211_hw *hw, bool aborted); /** * ieee80211_iterate_active_interfaces - iterate active interfaces diff --git a/include/net/wireless.h b/include/net/wireless.h index a42c1562d52b..1c6285eb1666 100644 --- a/include/net/wireless.h +++ b/include/net/wireless.h @@ -213,6 +213,9 @@ struct wiphy { bool custom_regulatory; bool strict_regulatory; + int bss_priv_size; + u8 max_scan_ssids; + /* If multiple wiphys are registered and you're handed e.g. * a regular netdev with assigned ieee80211_ptr, you won't * know whether it points to a wiphy your driver has registered |