summaryrefslogtreecommitdiff
path: root/drivers
Commit message (Expand)AuthorAgeFilesLines
* i2c: the scheduled I2C RTC driver removalAdrian Bunk2008-01-275-1131/+0
* i2c-stub: Use a single array for byte and word operationsJean Delvare2008-01-271-7/+8
* i2c/tsl2550: Add power management addedRodolfo Giometti2008-01-271-0/+21
* i2c: Add support for the PCF8575 chipBart Van Assche2008-01-273-1/+230
* i2c-ibm_iic: Whitespace cleanupStefan Roese2008-01-272-99/+99
* i2c-pasemi: use i2c_add_numbered_adapter()Olof Johansson2008-01-271-1/+2
* i2c-nforce2: The nForce2 can do block transactionsJean Delvare2008-01-271-0/+1
* Merge git://git.kernel.org/pub/scm/linux/kernel/git/bart/ide-2.6Linus Torvalds2008-01-2662-1410/+960
|\
| * ide: remove REQ_TYPE_ATA_CMDBartlomiej Zolnierkiewicz2008-01-262-112/+11
| * ide: switch ide_cmd_ioctl() to use REQ_TYPE_ATA_TASKFILE requestsBartlomiej Zolnierkiewicz2008-01-262-34/+33
| * ide: switch set_xfer_rate() to use REQ_TYPE_ATA_TASKFILE requestsBartlomiej Zolnierkiewicz2008-01-262-4/+11
| * ide: fix final status check in drive_cmd_intr()Bartlomiej Zolnierkiewicz2008-01-261-2/+2
| * ide: check BUSY and ERROR status bits before reading data in drive_cmd_intr()Bartlomiej Zolnierkiewicz2008-01-261-3/+8
| * ide: don't enable local IRQs for PIO-in in driver_cmd_intr() (take 2)Bartlomiej Zolnierkiewicz2008-01-261-6/+9
| * ide: convert "empty" REQ_TYPE_ATA_CMD requests to use REQ_TYPE_ATA_TASKFILEBartlomiej Zolnierkiewicz2008-01-263-3/+5
| * ide: initialize rq->cmd_type in ide_init_drive_cmd() callersBartlomiej Zolnierkiewicz2008-01-263-1/+7
| * ide: use wait_drive_not_busy() in drive_cmd_intr() (take 2)Bartlomiej Zolnierkiewicz2008-01-262-6/+3
| * ide: kill DATA_READY defineBartlomiej Zolnierkiewicz2008-01-261-2/+2
| * ide: task_end_request() fixTejun Heo2008-01-262-14/+5
| * ide: use rq->nr_sectors in task_end_request()Bartlomiej Zolnierkiewicz2008-01-261-2/+2
| * ide: remove needless ->cursg clearing from task_end_request()Bartlomiej Zolnierkiewicz2008-01-261-2/+0
| * ide: set IDE_TFLAG_IN_* flags before queuing/executing commandBartlomiej Zolnierkiewicz2008-01-264-23/+20
| * ide-tape: fix handling of non-special requests in ->end_request methodBartlomiej Zolnierkiewicz2008-01-261-0/+5
| * ide: fix final status check in task_in_intr()Bartlomiej Zolnierkiewicz2008-01-261-1/+1
| * ide: clear HOB bit for REQ_TYPE_ATA_CMD requests in ide_end_drive_cmd()Bartlomiej Zolnierkiewicz2008-01-261-0/+2
| * ide: fix ->io_32bit race in ide_taskfile_ioctl()Tejun Heo2008-01-261-5/+12
| * cmd64x: remove /proc/ide/cmd64xBartlomiej Zolnierkiewicz2008-01-261-113/+1
| * ide: remove broken disk byte-swapping supportBartlomiej Zolnierkiewicz2008-01-263-36/+3
| * ide: add ide_busy_sleep() helperBartlomiej Zolnierkiewicz2008-01-261-22/+21
| * ide: make CONFIG_IDEPCI_PCIBUS_ORDER visible and deprecate itBartlomiej Zolnierkiewicz2008-01-261-1/+13
| * ide: move CONFIG_IDEPCI_PCIBUS_ORDER code to ide-scan-pci.cBartlomiej Zolnierkiewicz2008-01-262-103/+110
| * ide: print banner message once per controller in m68k host driversBartlomiej Zolnierkiewicz2008-01-265-35/+22
| * ide: add ide_set_irq() inline helperBartlomiej Zolnierkiewicz2008-01-264-22/+12
| * ide-pmac: use custom hwif->sg_max_nents only if DMA support is enabledBartlomiej Zolnierkiewicz2008-01-261-2/+2
| * rapide: remove write-only hwif->hwif_dataBartlomiej Zolnierkiewicz2008-01-261-2/+0
| * ide: use ide_init_port_hw() in setup-pci.cBartlomiej Zolnierkiewicz2008-01-261-16/+17
| * ide: always use ide_std_init_ports() in setup-pci.cBartlomiej Zolnierkiewicz2008-01-261-5/+1
| * au1xxx-ide: use ide_init_port_hw()Bartlomiej Zolnierkiewicz2008-01-261-4/+4
| * au1xxx-ide: au_ide_probe() fixesBartlomiej Zolnierkiewicz2008-01-261-3/+2
| * ide: make remaining built-in only IDE host drivers modular (take 2)Bartlomiej Zolnierkiewicz2008-01-2628-216/+164
| * ide: fix host drivers depending on ide_generic to probe for interfaces (take 2)Bartlomiej Zolnierkiewicz2008-01-2613-16/+70
| * cmd640: fix dependency on IDE_GENERICBartlomiej Zolnierkiewicz2008-01-261-0/+1
| * ide: move ide_arm_init() call from init_ide_data() to ide_init()Bartlomiej Zolnierkiewicz2008-01-262-4/+3
| * ide: drop 'initializing' argument from ide_register_hw()Bartlomiej Zolnierkiewicz2008-01-2614-66/+84
| * ide: add ide_init_port_hw() helperBartlomiej Zolnierkiewicz2008-01-265-66/+80
| * sgiioc4: always init hwif->io_portsBartlomiej Zolnierkiewicz2008-01-261-9/+6
| * ide: Fix build break caused by "ide: remove ideprobe_init()"Olof Johansson2008-01-261-1/+1
| * ide: remove ideprobe_init()Bartlomiej Zolnierkiewicz2008-01-262-39/+23
| * ide: add hwif->chipset fixup to ide_device_add()Bartlomiej Zolnierkiewicz2008-01-261-1/+5
| * swarm: set hwif->chipsetBartlomiej Zolnierkiewicz2008-01-261-0/+1
View Lorry Controller Status