/**
 * Tests that flow control outputs a log when it is maximally engaged on some cadence.
 *
 * @tags: [
 *   requires_flow_control,
 *   requires_majority_read_concern,
 *   requires_replication,
 * ]
 */
(function() {
"use strict";

const replSet = new ReplSetTest({name: "flow_control_logging", nodes: 3});
replSet.startSet({
    setParameter: {
        flowControlSamplePeriod: 1,  // Increase resolution to detect lag in a light write workload.
        flowControlWarnThresholdSeconds: 1,
        // Configure flow control to engage after one second of lag.
        flowControlTargetLagSeconds: 1,
        flowControlThresholdLagPercentage: 1,
        // Use a speedy no-op writer to avoid needing a robust background writer.
        writePeriodicNoops: true,
        periodicNoopIntervalSecs:
            2  // replSet.initiate() can hang with a one second interval for reasons.
    }
});
replSet.initiate();

// Stop replication which will pin the commit point.
for (let sec of replSet.getSecondaries()) {
    assert.commandWorked(sec.adminCommand(
        {configureFailPoint: "pauseBatchApplicationAfterWritingOplogEntries", mode: "alwaysOn"}));
}

const timeoutMilliseconds = 30 * 1000;
// The test has stopped replication and the primary's no-op writer is configured to create an
// oplog entry every other second. Once the primary notices the sustainer rate is not moving, it
// should start logging a warning once per second. This check waits for two log messages to make
// sure the appropriate state variables are being reset.
checkLog.containsWithAtLeastCount(replSet.getPrimary(),
                                  "Flow control is engaged and the sustainer point is not moving.",
                                  2,
                                  timeoutMilliseconds);

// Restart replication so the replica set will shut down.
for (let sec of replSet.getSecondaries()) {
    assert.commandWorked(sec.adminCommand(
        {configureFailPoint: "pauseBatchApplicationAfterWritingOplogEntries", mode: "off"}));
}

replSet.stopSet();
})();