NetSurf logging
===============

NetSurf has a large number of internal diagnostic messages which can
be viewed by the developer (or user if they wish)

Each message has a category and a level which can be used to control
which messages are displayed.

The message category is used to allow filters to separate messages of
the same level from different sources.

The logging levels, from low to high, are:

  - DEEPDEBUG
  - DEBUG
  - VERBOSE
  - INFO
  - WARNING
  - ERROR
  - CRITICAL

Compilation control
-------------------

At compilation time the logging behaviour can be controlled by using
configuration overrides in a Makefile.config The parameters are:

  - NETSURF_USE_NSLOG  
  This controls if the NetSurf logging library (nslog) is used to
  allow comprehensive filtering of messages. The value defaults to
  AUTO which will use pkg-config to locate the library and enable if
  present. If set to NO or the library cannot be located the browsers
  logging will revert to simple boolean enabled/disabled logging
  controlled by the -v command line switch.
  
  - NETSURF_LOG_LEVEL  
  This controls what level of message is compiled into the NetSurf
  binary. The default value is VERBOSE and when not using nslog this
  value is also used to select what level of logging is shown with the
  -v command line switch.
  
  - NETSURF_BUILTIN_LOG_FILTER  
  When using nslog this sets the default non-verbose filter. The
  default value ("level:WARNING") shows all messages of level WARNING
  and above

  - NETSURF_BUILTIN_VERBOSE_FILTER  
  When using nslog this sets the default verbose filter. The default
  value ("level:VERBOSE") shows all messages of level VERBOSE and
  above. The verbose level is selected from the commandline with the
  -v switch

Command line
------------

The main command line switches that control logging are:

  - -v
  switches between the normal and verbose levels

  - -V <file>
  Send the logging to a file instead of standard output 
  
  - -log_filter=<filter>
  Set the non verbose filter

  - -log_verbose_filter=<filter>
  Set the verbose filter

Options
-------

The logging filters can be configured by setting the log_filter and
log_verbose_filter options.

Adding messages
---------------

Messages can be easily added by including the utils/log.h header and
he NSLOG() macro. for example

    NSLOG(netsurf, INFO, "An example message %d", example_func());

nslog
-----

If the nslog library is used it allows for application of a filter to
control which messages are output. The nslog filter syntax is best
viewed in its [documentation](http://source.netsurf-browser.org/libnslog.git/tree/docs/mainpage.md)