diff options
Diffstat (limited to 'tests/tunnel-push-pop.at')
| -rw-r--r-- | tests/tunnel-push-pop.at | 56 |
1 files changed, 56 insertions, 0 deletions
diff --git a/tests/tunnel-push-pop.at b/tests/tunnel-push-pop.at index f7172433e..65e338d0d 100644 --- a/tests/tunnel-push-pop.at +++ b/tests/tunnel-push-pop.at @@ -551,6 +551,62 @@ OVS_WAIT_UNTIL([test `ovs-pcap p0.pcap | grep 50540000000a5054000000091235 | wc OVS_VSWITCHD_STOP AT_CLEANUP +AT_SETUP([tunnel_push_pop - packet_out debug_slow]) + +OVS_VSWITCHD_START( + [add-port br0 p0 dnl + -- set Interface p0 type=dummy ofport_request=1 dnl + other-config:hwaddr=aa:55:aa:55:00:00]) +AT_CHECK([ovs-appctl vlog/set dpif_netdev:dbg]) +AT_CHECK([ovs-vsctl add-br int-br -- set bridge int-br datapath_type=dummy]) +AT_CHECK([ovs-vsctl add-port int-br t2 dnl + -- set Interface t2 type=geneve options:remote_ip=1.1.2.92 dnl + options:key=123 ofport_request=2]) + +dnl First setup dummy interface IP address, then add the route +dnl so that tnl-port table can get valid IP address for the device. +AT_CHECK([ovs-appctl netdev-dummy/ip4addr br0 1.1.2.88/24], [0], [OK +]) +AT_CHECK([ovs-appctl ovs/route/add 1.1.2.92/24 br0], [0], [OK +]) +AT_CHECK([ovs-ofctl add-flow br0 action=normal]) + +dnl This ARP reply from p0 has two effects: +dnl 1. The ARP cache will learn that 1.1.2.92 is at f8:bc:12:44:34:b6. +dnl 2. The br0 mac learning will learn that f8:bc:12:44:34:b6 is on p0. +AT_CHECK([ + ovs-appctl netdev-dummy/receive p0 dnl + 'recirc_id(0),in_port(2),dnl + eth(src=f8:bc:12:44:34:b6,dst=ff:ff:ff:ff:ff:ff),eth_type(0x0806),dnl + arp(sip=1.1.2.92,tip=1.1.2.88,op=2,sha=f8:bc:12:44:34:b6,tha=00:00:00:00:00:00)' +]) + +AT_CHECK([ovs-vsctl -- set Interface p0 options:tx_pcap=p0.pcap]) + +packet=50540000000a505400000009123 +encap=f8bc124434b6aa55aa5500000800450000320000400040113406010102580101025c83a917c1001e00000000655800007b00 + +dnl Output to tunnel from a int-br internal port. +dnl Checking that the packet arrived and it was correctly encapsulated. +AT_CHECK([ovs-ofctl add-flow int-br "in_port=LOCAL,actions=debug_slow,output:2"]) +AT_CHECK([ovs-appctl netdev-dummy/receive int-br "${packet}4"]) +OVS_WAIT_UNTIL([test `ovs-pcap p0.pcap | grep "${encap}${packet}4" | wc -l` -ge 1]) +dnl Sending again to exercise the non-miss upcall path. +AT_CHECK([ovs-appctl netdev-dummy/receive int-br "${packet}4"]) +OVS_WAIT_UNTIL([test `ovs-pcap p0.pcap | grep "${encap}${packet}4" | wc -l` -ge 2]) + +dnl Output to tunnel from the controller. +AT_CHECK([ovs-ofctl -O OpenFlow13 packet-out int-br CONTROLLER "debug_slow,output:2" "${packet}5"]) +OVS_WAIT_UNTIL([test `ovs-pcap p0.pcap | grep "${encap}${packet}5" | wc -l` -ge 1]) + +dnl Datapath actions should not have tunnel push action. +AT_CHECK([ovs-appctl dpctl/dump-flows | grep -q tnl_push], [1]) +dnl There should be slow_path action instead. +AT_CHECK([ovs-appctl dpctl/dump-flows | grep -q 'slow_path(action)'], [0]) + +OVS_VSWITCHD_STOP +AT_CLEANUP + AT_SETUP([tunnel_push_pop - underlay bridge match]) OVS_VSWITCHD_START([add-port br0 p0 -- set Interface p0 type=dummy ofport_request=1 other-config:hwaddr=aa:55:aa:55:00:00]) |