-v[spec]

--verbose=[spec]

Sets logging levels. Without any spec, sets the log level for every module and destination to dbg. Otherwise, spec is a list of words separated by spaces or commas or colons, up to one from each category below:

A valid module name, as displayed by the vlog/list command on ovs-appctl(8), limits the log level change to the specified module.
syslog, console, or file, to limit the log level change to only to the system log, to the console, or to a file, respectively. (If --detach is specified, the daemon closes its standard file descriptors, so logging to the console will have no effect.)

On Windows platform, syslog is accepted as a word and is only useful along with the --syslog-target option (the word has no effect otherwise).
off, emer, err, warn, info, or dbg, to control the log level. Messages of the given severity or higher will be logged, and messages of lower severity will be filtered out. off filters out all messages. See ovs-appctl(8) for a definition of each log level.

Case is not significant within spec.

Regardless of the log levels set for file, logging to a file will not take place unless --log-file is also specified (see below).

For compatibility with older versions of OVS, any is accepted as a word but has no effect.

-v

--verbose

Sets the maximum logging verbosity level, equivalent to --verbose=dbg.

-vPATTERN:destination:pattern

--verbose=PATTERN:destination:pattern

Sets the log pattern for destination to pattern. Refer to ovs-appctl(8) for a description of the valid syntax for pattern.

-vFACILITY:facility

--verbose=FACILITY:facility

Sets the RFC5424 facility of the log message. facility can be one of kern, user, mail, daemon, auth, syslog, lpr, news, uucp, clock, ftp, ntp, audit, alert, clock2, local0, local1, local2, local3, local4, local5, local6 or local7. If this option is not specified, daemon is used as the default for the local system syslog and local0 is used while sending a message to the target provided via the --syslog-target option.

--log-file[=file]

Enables logging to a file. If file is specified, then it is used as the exact name for the log file. The default log file name used if file is omitted is @LOGDIR@/program.log.

--syslog-target=host:port

Send syslog messages to UDP port on host, in addition to the system syslog. The host must be a numerical IP address, not a hostname.

--syslog-method=method

Specify method as how syslog messages should be sent to syslog daemon. The following forms are supported:

libc, to use the libc syslog() function. This is the default behavior. Downside of using this options is that libc adds fixed prefix to every message before it is actually sent to the syslog daemon over /dev/log UNIX domain socket.
unix:file, to use a UNIX domain socket directly. It is possible to specify arbitrary message format with this option. However, rsyslogd 8.9 and older versions use hard coded parser function anyway that limits UNIX domain socket use. If you want to use arbitrary message format with older rsyslogd versions, then use UDP socket to localhost IP address instead.
udp:ip:port, to use a UDP socket. With this method it is possible to use arbitrary message format also with older rsyslogd. When sending syslog messages over UDP socket extra precaution needs to be taken into account, for example, syslog daemon needs to be configured to listen on the specified UDP port, accidental iptables rules could be interfering with local syslog traffic and there are some security considerations that apply to UDP sockets, but do not apply to UNIX domain sockets.