[user@linuxbox imx-bootlets-src-10.05.02]$ make CROSS_COMPILE=arm-none-eabi-  clean
rm -rf *.sb
rm -f sd_mmc_bootstream.raw
rm -f linux_prep/board/*.o
...
Files:
rm -f power_prep.o eabi.o
Build output:
make[1]: Leaving directory `/home/...'
[user@linuxbox imx-bootlets-src-10.05.02]$ make CROSS_COMPILE=arm-none-eabi-
make[1]: Entering directory `/home/...'
...
#@echo "generating U-Boot boot stream image"
#elftosb2 -z -c ./uboot_prebuilt.db -o imx23_uboot.sb
echo "generating kernel bootstream file sd_mmc_bootstream.raw"
generating kernel bootstream file sd_mmc_bootstream.raw
#Please use cfimager to burn xxx_linux.sb. The below way will no
#work at imx28 platform.
> test
$ test
rm -f sd_mmc_bootstream.raw
[user@linuxbox imx-bootlets-src-10.05.02]$
pi@raspberrypi ~ $ sudo sh -c "echo 17 > /sys/class/gpio/export"
pi@raspberrypi ~ $ sudo sh -c "echo out > /sys/class/gpio/gpio17/direction"
pi@raspberrypi ~ $ sudo sh -c "echo 1 > /sys/class/gpio/gpio17/value"
pi@raspberrypi ~ $ sudo sh -c "echo 0 > /sys/class/gpio/gpio17/value"
pi@raspberrypi ~ $
[user@linuxbox ~]$ # copy other stuff to the SD card
root@imx233-olinuxino-micro:~# lsmod
  Not tainted
[user@linuxbox ~]$ tail -n 2 /mnt/rpi/etc/inittab
#Spawn a getty on Raspberry Pi serial line
T0:23:respawn:/sbin/getty -L ttyAMA0 115200 vt100
pi@raspberrypi:~/Adafruit-WebIDE$ mkdir tmp
pi@raspberrypi:~/Adafruit-WebIDE$ npm config set tmp tmp
pi@raspberrypi:~/Adafruit-WebIDE$ npm install
pi@raspberrypi ~/Adafruit-WebIDE $ ifconfig eth0
eth0      Link encap:Ethernet  HWaddr b5:33:ff:33:ee:aq
          inet addr:10.42.0.60  Bcast:10.42.0.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:21867 errors:0 dropped:0 overruns:0 frame:0
          TX packets:8684 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:27338495 (26.0 MiB)  TX bytes:1268356 (1.2 MiB)