blob: 0c82661f34bfd5faf2a6779453027d315abd1275 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
|
<!---
This file is reset every time a new release is done. This file describes changes that have not yet been released.
Example Doc Change:
### Headline for the required change
Description of the required change.
-->
### Chef now handles URI Schemes in a case insensitive manner
Previously, when a URI scheme contained all uppercase letters, Chef would reject the URI as invalid. In compliance with RFC3986, Chef now treats URI schemes in a case insensitive manner. This applies to all resources which accept URIs such as remote_file etc.
### Experimental Audit Mode Feature
There is a new command_line flag provided for `chef-client`: `--audit-mode`. This accepts 1 of 3 arguments:
* disabled (default) - Audits are disabled and the phase is skipped. This is the default while Audit mode is an
experimental feature.
* enabled - Audits are enabled and will be performed after the converge phase.
* audit_only - Audits are enabled and convergence is disabled. Only audits will be performed.
### Chef Why Run Mode Ignores Audit Phase
Because most users enable `why_run` mode to determine what resources convergence will update on their system, the audit
phase is not executed. There is no way to get both `why_run` output and audit output in 1 single command. To get
audit output without performing convergence use the `--audit-mode` flag.
#### Editors note 1
The `--audit-mode` flag should be a link to the documentation for that flag
#### Editors node 2
This probably only needs to be a bullet point added to http://docs.getchef.com/nodes.html#about-why-run-mode under the
`certain assumptions` section
|
