diff options
Diffstat (limited to 'README')
| -rw-r--r-- | README | 21 |
1 files changed, 13 insertions, 8 deletions
@@ -2819,6 +2819,12 @@ FIT uImage format: CONFIG_SPL_FAT_LOAD_PAYLOAD_NAME Filename to read to load U-Boot when reading from FAT + CONFIG_SPL_MPC83XX_WAIT_FOR_NAND + Set this for NAND SPL on PPC mpc83xx targets, so that + start.S waits for the rest of the SPL to load before + continuing (the hardware starts execution after just + loading the first page rather than the full 4K). + CONFIG_SPL_NAND_BASE Include nand_base.c in the SPL. Requires CONFIG_SPL_NAND_DRIVERS. @@ -2876,6 +2882,10 @@ FIT uImage format: CONFIG_SPL_LIBGENERIC_SUPPORT Support for lib/libgeneric.o in SPL binary + CONFIG_SPL_PAD_TO + Linker address to which the SPL should be padded before + appending the SPL payload. + CONFIG_SPL_TARGET Final target image containing SPL and payload. Some SPLs use an arch-specific makefile fragment instead, for @@ -3806,14 +3816,9 @@ Low Level (hardware related) configuration options: be used if available. These functions may be faster under some conditions but may increase the binary size. -- CONFIG_X86_NO_RESET_VECTOR - If defined, the x86 reset vector code is excluded. You will need - to do this when U-Boot is running from Coreboot. - -- CONFIG_X86_NO_REAL_MODE - If defined, x86 real mode code is omitted. This assumes a - 32-bit environment where such code is not needed. You will - need to do this when U-Boot is running from Coreboot. +- CONFIG_X86_RESET_VECTOR + If defined, the x86 reset vector code is included. This is not + needed when U-Boot is running from Coreboot. Freescale QE/FMAN Firmware Support: |