summaryrefslogtreecommitdiff
path: root/configs/nanopi-k2_defconfig
Commit message (Collapse)AuthorAgeFilesLines
* ARM: rework amlogic configurationJerome Brunet2018-11-261-2/+0
| | | | | | | | | | | | | Rework the board SYS_BOARD, SYS_VENDOR and SYS_CONFIG_NAME setup by moving the board Kconfig into the mach-meson Kconfig to make it easier to add new boards for a SoC architecture and add a custom config header or custom board handler for a platform. This drops the board CONFIGs and the duplicate boards configs headers in favor of a single meson64.h config header. Signed-off-by: Jerome Brunet <jbrunet@baylibre.com> Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
* board: amlogic: factorise gxbb boardsJerome Brunet2018-11-261-1/+1
| | | | | | | | | | The nanopi-k2 and the odroid-c2 are similar enough to be supported by the same u-boot board. This change use odroid-c2 u-boot board for the nanopi-k2 as well. Dedicated defconfig are kept to customize the names and device tree. Signed-off-by: Jerome Brunet <jbrunet@baylibre.com> Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
* configs: Resync with savedefconfigTom Rini2018-09-031-1/+1
| | | | | | Rsync all defconfig files using moveconfig.py Signed-off-by: Tom Rini <trini@konsulko.com>
* Convert CONFIG_MISC_INIT_R to KconfigAdam Ford2018-08-171-0/+1
| | | | | | | | | This converts the following to Kconfig: CONFIG_MISC_INIT_R Signed-off-by: Adam Ford <aford173@gmail.com> [trini: Update the defaults logic slightly] Signed-off-by: Tom Rini <trini@konsulko.com>
* configs: Migrate CONFIG_NR_DRAM_BANKSTom Rini2018-08-161-0/+1
| | | | | | | | | | | We have the following cases: - CONFIG_NR_DRAM_BANKS was defined, migrate normally - CONFIG_NR_DRAM_BANKS_MAX was defined and then used for CONFIG_NR_DRAM_BANKS after a check, just migrate it over now. - CONFIG_NR_DRAM_BANKS was very oddly defined on p2771-0000-* (to 1024 + 2), set this to 8. Signed-off-by: Tom Rini <trini@konsulko.com>
* configs: Resync with savedefconfigTom Rini2018-08-071-3/+3
| | | | | | Rsync all defconfig files using moveconfig.py Signed-off-by: Tom Rini <trini@konsulko.com>
* boards: amlogic: Add FriendlyElec NanoPi K2 board supportThomas McKahan2018-07-191-0/+40
This adds platform code for the FriendlyElec NanoPi K2 board based on a Meson GXBB (S905) SoC with the Meson GXBB configuration. This initial submission only supports: - UART - MMC/SDCard - Ethernet - Reset Controller - Clock controller Cc: Yuefei Tan <yftan@friendlyarm.com> Signed-off-by: Thomas McKahan <tonymckahan@gmail.com> Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
View Lorry Controller Status