baseboard/herobrine/usb_pd_policy.c: Format with clang-format

BUG=b:236386294
BRANCH=none
TEST=none

Change-Id: I35a3a12d98874d666a4dfb3785ede63613e4dc3d
Signed-off-by: Jack Rosenthal <jrosenth@chromium.org>
Reviewed-on: https://chromium-review.googlesource.com/c/chromiumos/platform/ec/+/3727526
Reviewed-by: Jeremy Bettis <jbettis@chromium.org>

1 files changed, 18 insertions, 21 deletions

diff --git a/baseboard/herobrine/usb_pd_policy.c b/baseboard/herobrine/usb_pd_policy.c
index 7ca2688aef..0710a799c2 100644
--- a/baseboard/herobrine/usb_pd_policy.c
+++ b/baseboard/herobrine/usb_pd_policy.c
@@ -12,8 +12,8 @@
 #include "usbc_ppc.h"
 #include "util.h"
 
-#define CPRINTS(format, args...) cprints(CC_USBCHARGE, format, ## args)
-#define CPRINTF(format, args...) cprintf(CC_USBCHARGE, format, ## args)
+#define CPRINTS(format, args...) cprints(CC_USBCHARGE, format, ##args)
+#define CPRINTF(format, args...) cprintf(CC_USBCHARGE, format, ##args)
 
 int pd_check_vconn_swap(int port)
 {
@@ -23,10 +23,10 @@ int pd_check_vconn_swap(int port)
 
 static uint8_t vbus_en[CONFIG_USB_PD_PORT_MAX_COUNT];
 #if CONFIG_USB_PD_PORT_MAX_COUNT == 1
-static uint8_t vbus_rp[CONFIG_USB_PD_PORT_MAX_COUNT] = {TYPEC_RP_1A5};
+static uint8_t vbus_rp[CONFIG_USB_PD_PORT_MAX_COUNT] = { TYPEC_RP_1A5 };
 #else
-static uint8_t vbus_rp[CONFIG_USB_PD_PORT_MAX_COUNT] = {TYPEC_RP_1A5,
-							TYPEC_RP_1A5};
+static uint8_t vbus_rp[CONFIG_USB_PD_PORT_MAX_COUNT] = { TYPEC_RP_1A5,
+							 TYPEC_RP_1A5 };
 #endif
 
 static void board_vbus_update_source_current(int port)
@@ -107,11 +107,11 @@ __override int svdm_dp_config(int port, uint32_t *payload)
 	 *  (3) plug a monitor to the port-1 dongle.
 	 */
 
-	payload[0] = VDO(USB_SID_DISPLAYPORT, 1,
-			 CMD_DP_CONFIG | VDO_OPOS(opos));
-	payload[1] = VDO_DP_CFG(pin_mode,      /* pin mode */
-				1,             /* DPv1.3 signaling */
-				2);            /* UFP connected */
+	payload[0] =
+		VDO(USB_SID_DISPLAYPORT, 1, CMD_DP_CONFIG | VDO_OPOS(opos));
+	payload[1] = VDO_DP_CFG(pin_mode, /* pin mode */
+				1, /* DPv1.3 signaling */
+				2); /* UFP connected */
 	return 2;
 };
 
@@ -187,8 +187,7 @@ __override int svdm_dp_attention(int port, uint32_t *payload)
 		 * because of the board USB-C topology (limited to 2
 		 * lanes DP).
 		 */
-		usb_mux_set(port, USB_PD_MUX_DOCK,
-			    USB_SWITCH_CONNECT,
+		usb_mux_set(port, USB_PD_MUX_DOCK, USB_SWITCH_CONNECT,
 			    polarity_rm_dts(pd_get_polarity(port)));
 	} else {
 		/* Disconnect the DP port selection mux. */
@@ -200,13 +199,11 @@ __override int svdm_dp_attention(int port, uint32_t *payload)
 			ppc_set_sbu(port, 0);
 
 		/* Disconnect the DP but keep the USB SS lines in TCPC chip. */
-		usb_mux_set(port, USB_PD_MUX_USB_ENABLED,
-			    USB_SWITCH_CONNECT,
+		usb_mux_set(port, USB_PD_MUX_USB_ENABLED, USB_SWITCH_CONNECT,
 			    polarity_rm_dts(pd_get_polarity(port)));
 	}
 
-	if (chipset_in_state(CHIPSET_STATE_ANY_SUSPEND) &&
-	    (irq || lvl))
+	if (chipset_in_state(CHIPSET_STATE_ANY_SUSPEND) && (irq || lvl))
 		/*
 		 * Wake up the AP.  IRQ or level high indicates a DP sink is now
 		 * present.
@@ -231,16 +228,16 @@ __override int svdm_dp_attention(int port, uint32_t *payload)
 		gpio_set_level(hpd, 1);
 
 		/* Set the minimum time delay (2ms) for the next HPD IRQ */
-		svdm_hpd_deadline[port] = get_time().val +
-			HPD_USTREAM_DEBOUNCE_LVL;
+		svdm_hpd_deadline[port] =
+			get_time().val + HPD_USTREAM_DEBOUNCE_LVL;
 	} else if (irq & !lvl) {
 		CPRINTF("ERR:HPD:IRQ&LOW\n");
 		return 0;
 	} else {
 		gpio_set_level(hpd, lvl);
 		/* Set the minimum time delay (2ms) for the next HPD IRQ */
-		svdm_hpd_deadline[port] = get_time().val +
-			HPD_USTREAM_DEBOUNCE_LVL;
+		svdm_hpd_deadline[port] =
+			get_time().val + HPD_USTREAM_DEBOUNCE_LVL;
 	}
 
 	return 1;
@@ -255,7 +252,7 @@ __override void svdm_exit_dp_mode(int port)
 
 		/* Signal AP for the HPD low event */
 		usb_mux_hpd_update(port, USB_PD_MUX_HPD_LVL_DEASSERTED |
-					 USB_PD_MUX_HPD_IRQ_DEASSERTED);
+						 USB_PD_MUX_HPD_IRQ_DEASSERTED);
 		gpio_set_level(GPIO_DP_HOT_PLUG_DET, 0);
 	}
 }