diff options
Diffstat (limited to 'board/fleex/board.h')
| -rw-r--r-- | board/fleex/board.h | 125 |
1 files changed, 0 insertions, 125 deletions
diff --git a/board/fleex/board.h b/board/fleex/board.h deleted file mode 100644 index cd04f31687..0000000000 --- a/board/fleex/board.h +++ /dev/null @@ -1,125 +0,0 @@ -/* Copyright 2018 The Chromium OS Authors. All rights reserved. - * Use of this source code is governed by a BSD-style license that can be - * found in the LICENSE file. - */ - -/* Fleex board configuration */ - -#ifndef __CROS_EC_BOARD_H -#define __CROS_EC_BOARD_H - -/* Select Baseboard features */ -#define VARIANT_OCTOPUS_EC_NPCX796FB -#define VARIANT_OCTOPUS_CHARGER_ISL9238 -#include "baseboard.h" - -/* EC console commands */ -#define CONFIG_CMD_ACCELS -#define CONFIG_CMD_ACCEL_INFO - -#define CONFIG_LED_COMMON -#define CONFIG_LED_ONOFF_STATES_BAT_LOW 10 - -/* - * Some fuel gagues will return 1% immediately, without the battery being - * charged to the point of being able to withstand Vbus loss, so re-set - * allowable Try.SRC level and reset level to 2% - */ -#undef CONFIG_USB_PD_TRY_SRC_MIN_BATT_SOC -#define CONFIG_USB_PD_TRY_SRC_MIN_BATT_SOC 2 - -#define CONFIG_USB_PD_RESET_MIN_BATT_SOC 2 - -/* Sensors */ -#define CONFIG_ACCEL_LIS2DE /* Lid accel */ -#define CONFIG_ACCELGYRO_LSM6DSM /* Base accel */ -/* Sensors without hardware FIFO are in forced mode */ -#define CONFIG_ACCEL_FORCE_MODE_MASK BIT(LID_ACCEL) -#define CONFIG_DYNAMIC_MOTION_SENSOR_COUNT - -/* Volume button */ -#define CONFIG_VOLUME_BUTTONS -#define GPIO_VOLUME_UP_L GPIO_EC_VOLUP_BTN_ODL -#define GPIO_VOLUME_DOWN_L GPIO_EC_VOLDN_BTN_ODL - -#define CONFIG_LID_ANGLE -#define CONFIG_LID_ANGLE_UPDATE -#define CONFIG_LID_ANGLE_SENSOR_BASE BASE_ACCEL -#define CONFIG_LID_ANGLE_SENSOR_LID LID_ACCEL - -#define CONFIG_TEMP_SENSOR -#define CONFIG_THERMISTOR -#define CONFIG_STEINHART_HART_3V3_13K7_47K_4050B -#define CONFIG_STEINHART_HART_3V3_51K1_47K_4050B - -/* TI gauge IC 500ms WDT timeout setting under battery sleep mode - * induced battery cut-off, under the following conditions: - * 1. SMBus communication on FC is once per minute which allows - * battery entering sleep mode; - * 2. System load < 10mA and accumulate 5 hours will trigger battery - * simulation and result in a 500ms WDT timeout. So change charge - * max sleep time from once/minute to once/10 seconds to prevent - * battery entering sleep mode. See b/133375756. - */ -#define CHARGE_MAX_SLEEP_USEC (10 * SECOND) - -#define CONFIG_ACCEL_LSM6DSM_INT_EVENT \ - TASK_EVENT_MOTION_SENSOR_INTERRUPT(BASE_ACCEL) - -/* Additional PPC second source */ -#define CONFIG_USBC_PPC_SYV682X -#define CONFIG_USBC_PPC_DEDICATED_INT -/* SYV682 isn't connected to CC, so TCPC must provide VCONN */ -#define CONFIG_USBC_PPC_SYV682X_NO_CC - -#ifndef __ASSEMBLER__ - -#include "gpio_signal.h" -#include "registers.h" - -enum adc_channel { - ADC_TEMP_SENSOR_AMB, /* ADC0 */ - ADC_TEMP_SENSOR_CHARGER, /* ADC1 */ - ADC_VBUS_C0, /* ADC9 */ - ADC_VBUS_C1, /* ADC4 */ - ADC_CH_COUNT -}; - -enum temp_sensor_id { - TEMP_SENSOR_BATTERY, - TEMP_SENSOR_AMBIENT, - TEMP_SENSOR_CHARGER, - TEMP_SENSOR_COUNT -}; - -enum pwm_channel { - PWM_CH_KBLIGHT, - PWM_CH_COUNT -}; - -/* Motion sensors */ -enum sensor_id { - LID_ACCEL, - BASE_ACCEL, - BASE_GYRO, - SENSOR_COUNT -}; - -/* List of possible batteries */ -enum battery_type { - BATTERY_BYD, - BATTERY_BYD16, - BATTERY_LGC, - BATTERY_LGC3, - BATTERY_SIMPLO, - BATTERY_SIMPLO_ATL, - BATTERY_SIMPLO_COS, - BATTERY_SIMPLO_LS, - BATTERY_SWD_ATL, - BATTERY_SWD_COS, - BATTERY_TYPE_COUNT, -}; - -#endif /* !__ASSEMBLER__ */ - -#endif /* __CROS_EC_BOARD_H */ |