diff options
Diffstat (limited to 'board/lazor/board.h')
| -rw-r--r-- | board/lazor/board.h | 131 |
1 files changed, 0 insertions, 131 deletions
diff --git a/board/lazor/board.h b/board/lazor/board.h deleted file mode 100644 index d045c13cb5..0000000000 --- a/board/lazor/board.h +++ /dev/null @@ -1,131 +0,0 @@ -/* Copyright 2020 The Chromium OS Authors. All rights reserved. - * Use of this source code is governed by a BSD-style license that can be - * found in the LICENSE file. - */ - -/* Lazor board configuration */ - -#ifndef __CROS_EC_BOARD_H -#define __CROS_EC_BOARD_H - -#include "baseboard.h" - -/* Internal SPI flash on NPCX7 */ -#define CONFIG_FLASH_SIZE_BYTES (512 * 1024) /* 512KB internal spi flash */ - -/* Switchcap */ -#define CONFIG_LN9310 - -/* Keyboard */ -#define CONFIG_KEYBOARD_PROTOCOL_MKBP - -#define CONFIG_PWM_KBLIGHT - -/* Battery */ -#define CONFIG_BATTERY_DEVICE_CHEMISTRY "LION" -#define CONFIG_BATTERY_REVIVE_DISCONNECT -#define CONFIG_BATTERY_FUEL_GAUGE - -/* BC 1.2 Charger */ -#define CONFIG_BC12_DETECT_PI3USB9201 - -/* USB */ -#define CONFIG_USB_PD_TCPM_MULTI_PS8XXX -#define CONFIG_USB_PD_TCPM_PS8751 -#define CONFIG_USB_PD_TCPM_PS8805 -#define CONFIG_USB_PD_TCPM_PS8805_FORCE_DID -#define CONFIG_USBC_PPC_SN5S330 -#define CONFIG_USB_PD_PORT_MAX_COUNT 2 - -/* USB-A */ -#define USB_PORT_COUNT 1 -#define CONFIG_USB_PORT_POWER_DUMB - -/* Sensors */ -#define CONFIG_DYNAMIC_MOTION_SENSOR_COUNT - -/* BMI160 Base accel/gyro */ -#define CONFIG_ACCELGYRO_BMI160 -#define CONFIG_ACCEL_INTERRUPTS -#define CONFIG_ACCELGYRO_BMI160_INT_EVENT \ - TASK_EVENT_MOTION_SENSOR_INTERRUPT(BASE_ACCEL) -#define OPT3001_I2C_ADDR_FLAGS OPT3001_I2C_ADDR1_FLAGS - -/* ICM426XX Base accel/gyro */ -#define CONFIG_ACCELGYRO_ICM426XX -#define CONFIG_ACCELGYRO_ICM426XX_INT_EVENT \ - TASK_EVENT_MOTION_SENSOR_INTERRUPT(BASE_ACCEL) - -/* KX022 lid accel */ -#define CONFIG_ACCEL_KX022 - -/* BMA253 lid accel */ -#define CONFIG_ACCEL_BMA255 -#define CONFIG_ACCEL_FORCE_MODE_MASK BIT(LID_ACCEL) - -#define CONFIG_LID_ANGLE -#define CONFIG_LID_ANGLE_SENSOR_BASE BASE_ACCEL -#define CONFIG_LID_ANGLE_SENSOR_LID LID_ACCEL -#define CONFIG_LID_ANGLE_UPDATE - -#define CONFIG_TABLET_MODE -#define CONFIG_TABLET_MODE_SWITCH -#define CONFIG_GMR_TABLET_MODE -#define GMR_TABLET_MODE_GPIO_L GPIO_TABLET_MODE_L - -/* GPIO alias */ -#define GPIO_AC_PRESENT GPIO_ACOK_OD -#define GPIO_WP_L GPIO_EC_WP_ODL -#define GPIO_PMIC_RESIN_L GPIO_PM845_RESIN_L -#define GPIO_SWITCHCAP_PG_INT_L GPIO_DA9313_GPIO0 -#define GPIO_SWITCHCAP_ON_L GPIO_SWITCHCAP_ON - -#ifndef __ASSEMBLER__ - -#include "gpio_signal.h" -#include "registers.h" -#include "sku.h" - -enum adc_channel { - ADC_VBUS, - ADC_AMON_BMON, - ADC_PSYS, - ADC_CH_COUNT -}; - -/* Motion sensors */ -enum sensor_id { - LID_ACCEL = 0, - BASE_ACCEL, - BASE_GYRO, - SENSOR_COUNT, -}; - -enum pwm_channel { - PWM_CH_KBLIGHT = 0, - PWM_CH_DISPLIGHT, - PWM_CH_COUNT -}; - -/* List of possible batteries */ -enum battery_type { - BATTERY_AP16L5J, - BATTERY_AP16L5J_009, - BATTERY_AP16L8J, - BATTERY_LGC_AP18C8K, - BATTERY_MURATA_AP18C4K, - BATTERY_TYPE_COUNT, -}; - -/* support factory keyboard test */ -#define CONFIG_KEYBOARD_FACTORY_TEST - -/* Reset all TCPCs. */ -void board_reset_pd_mcu(void); -void board_set_tcpc_power_mode(int port, int mode); -/* Motion sensor interrupt */ -void motion_interrupt(enum gpio_signal signal); - -#endif /* !defined(__ASSEMBLER__) */ - -#endif /* __CROS_EC_BOARD_H */ |