1 files changed, 0 insertions, 123 deletions
diff --git a/board/mrbland/board.h b/board/mrbland/board.h
deleted file mode 100644
index f4cb398c50..0000000000
--- a/board/mrbland/board.h
+++ /dev/null
@@ -1,123 +0,0 @@
-/* Copyright 2021 The Chromium OS Authors. All rights reserved.
- * Use of this source code is governed by a BSD-style license that can be
- * found in the LICENSE file.
- */
-
-/* Mrbland board configuration */
-
-#ifndef __CROS_EC_BOARD_H
-#define __CROS_EC_BOARD_H
-
-#include "baseboard.h"
-
-/* TODO(waihong): Remove the following bringup features */
-#define CONFIG_BRINGUP
-#define CONFIG_SYSTEM_UNLOCKED /* Allow dangerous commands. */
-#define CONFIG_USB_PD_DEBUG_LEVEL 3
-#define CONFIG_CMD_GPIO_EXTENDED
-#define CONFIG_CMD_POWERINDEBUG
-#define CONFIG_I2C_DEBUG
-
-#define CONFIG_BUTTON_TRIGGERED_RECOVERY
-
-/* Internal SPI flash on NPCX7 */
-#define CONFIG_FLASH_SIZE_BYTES (512 * 1024)  /* 512KB internal spi flash */
-
-/* Switchcap */
-#define CONFIG_LN9310
-
-/* Battery */
-#define CONFIG_BATTERY_DEVICE_CHEMISTRY  "LION"
-#define CONFIG_BATTERY_REVIVE_DISCONNECT
-#define CONFIG_BATTERY_FUEL_GAUGE
-#define CONFIG_BATTERY_VENDOR_PARAM
-#define CONFIG_BATTERY_V2
-#define CONFIG_BATTERY_COUNT 1
-#define CONFIG_HOSTCMD_BATTERY_V2
-
-/* Enable PD3.0 */
-#define CONFIG_USB_PD_REV30
-
-/* BC 1.2 Charger */
-#define CONFIG_BC12_DETECT_PI3USB9201
-
-/* USB */
-#define CONFIG_USB_PD_TCPM_MULTI_PS8XXX
-#define CONFIG_USB_PD_TCPM_PS8755
-#define CONFIG_USB_PD_TCPM_PS8805
-#define CONFIG_USBC_PPC_SN5S330
-#define CONFIG_USB_PD_PORT_MAX_COUNT 1
-
-/* I2C */
-#undef I2C_PORT_TCPC0
-#define I2C_PORT_TCPC0   NPCX_I2C_PORT2_0
-
-/* Lid accel/gyro */
-#define CONFIG_ACCELGYRO_BMI160
-#define CONFIG_ACCEL_INTERRUPTS
-#define CONFIG_ACCELGYRO_BMI160_INT_EVENT \
-	TASK_EVENT_MOTION_SENSOR_INTERRUPT(LID_ACCEL)
-#define OPT3001_I2C_ADDR_FLAGS OPT3001_I2C_ADDR1_FLAGS
-#define CONFIG_ACCELGYRO_ICM42607
-#define CONFIG_ACCELGYRO_ICM42607_INT_EVENT \
-	TASK_EVENT_MOTION_SENSOR_INTERRUPT(LID_ACCEL)
-
-#define CONFIG_TABLET_MODE
-#define CONFIG_TABLET_MODE_SWITCH
-#define CONFIG_FRONT_PROXIMITY_SWITCH
-
-#define CONFIG_DETACHABLE_BASE
-#define CONFIG_BASE_ATTACHED_SWITCH
-
-/* GPIO alias */
-#define GPIO_AC_PRESENT GPIO_CHG_ACOK_OD
-#define GPIO_WP_L GPIO_EC_FLASH_WP_ODL
-#define GPIO_PMIC_RESIN_L GPIO_PM845_RESIN_L
-#define GPIO_SWITCHCAP_PG_INT_L GPIO_LN9310_INT
-
-#define CONFIG_MKBP_INPUT_DEVICES
-
-#ifndef __ASSEMBLER__
-
-#include "gpio_signal.h"
-#include "registers.h"
-
-enum adc_channel {
-	ADC_VBUS,
-	ADC_AMON_BMON,
-	ADC_PSYS,
-	ADC_BASE_DET,
-	ADC_CH_COUNT
-};
-
-/* Motion sensors */
-enum sensor_id {
-	LID_ACCEL = 0,
-	LID_GYRO,
-	SENSOR_COUNT,
-};
-
-enum pwm_channel {
-	PWM_CH_DISPLIGHT = 0,
-	PWM_CH_COUNT
-};
-
-/* List of possible batteries */
-enum battery_type {
-	BATTERY_L21C2PG1,
-	BATTERY_L21D2PG1,
-	BATTERY_L21M2PG1,
-	BATTERY_TYPE_COUNT,
-};
-
-/* Reset all TCPCs. */
-void board_reset_pd_mcu(void);
-void board_set_tcpc_power_mode(int port, int mode);
-/* Base detection */
-void base_detect_interrupt(enum gpio_signal signal);
-
-void motion_interrupt(enum gpio_signal signal);
-
-#endif /* !defined(__ASSEMBLER__) */
-
-#endif /* __CROS_EC_BOARD_H */