1 files changed, 0 insertions, 111 deletions
diff --git a/board/pazquel/board.h b/board/pazquel/board.h
deleted file mode 100644
index 98f7ff2499..0000000000
--- a/board/pazquel/board.h
+++ /dev/null
@@ -1,111 +0,0 @@
-/* Copyright 2021 The Chromium OS Authors. All rights reserved.
- * Use of this source code is governed by a BSD-style license that can be
- * found in the LICENSE file.
- */
-
-/* Trogdor board configuration */
-
-#ifndef __CROS_EC_BOARD_H
-#define __CROS_EC_BOARD_H
-
-#include "baseboard.h"
-
-/* TODO(waihong): Remove the following bringup features */
-#define CONFIG_BRINGUP
-#define CONFIG_SYSTEM_UNLOCKED /* Allow dangerous commands. */
-#define CONFIG_USB_PD_DEBUG_LEVEL 3
-#define CONFIG_CMD_GPIO_EXTENDED
-#define CONFIG_CMD_POWERINDEBUG
-#define CONFIG_I2C_DEBUG
-
-/* Internal SPI flash on NPCX7 */
-#define CONFIG_FLASH_SIZE_BYTES (512 * 1024)  /* 512KB internal spi flash */
-
-/* Keyboard */
-#define CONFIG_KEYBOARD_PROTOCOL_MKBP
-#define CONFIG_KEYBOARD_REFRESH_ROW3
-#define CONFIG_PWM_KBLIGHT
-
-/* Battery */
-#define CONFIG_BATTERY_DEVICE_CHEMISTRY "LION"
-#define CONFIG_BATTERY_FUEL_GAUGE
-#define CONFIG_BATTERY_REVIVE_DISCONNECT
-
-/* BC 1.2 Charger */
-#define CONFIG_BC12_DETECT_PI3USB9201
-
-/* USB */
-#define CONFIG_USB_PD_TCPM_PS8805
-#define CONFIG_USBC_PPC_SN5S330
-#define CONFIG_USB_PD_PORT_MAX_COUNT 2
-
-/* USB-A */
-#define USB_PORT_COUNT 1
-#define CONFIG_USB_PORT_POWER_DUMB
-
-/* Sensors */
-#define CONFIG_DYNAMIC_MOTION_SENSOR_COUNT
-/* BMI160 Base accel/gyro */
-#define CONFIG_ACCELGYRO_BMI160
-#define CONFIG_ACCEL_INTERRUPTS
-#define CONFIG_ACCELGYRO_BMI160_INT_EVENT \
-	TASK_EVENT_MOTION_SENSOR_INTERRUPT(BASE_ACCEL)
-#define OPT3001_I2C_ADDR_FLAGS OPT3001_I2C_ADDR1_FLAGS
-
-/* BMA253 lid accel */
-#define CONFIG_ACCEL_BMA255
-#define CONFIG_ACCEL_FORCE_MODE_MASK BIT(LID_ACCEL)
-
-#define CONFIG_LID_ANGLE
-#define CONFIG_LID_ANGLE_SENSOR_BASE BASE_ACCEL
-#define CONFIG_LID_ANGLE_SENSOR_LID LID_ACCEL
-#define CONFIG_LID_ANGLE_UPDATE
-
-#define CONFIG_TABLET_MODE
-#define CONFIG_TABLET_MODE_SWITCH
-#define CONFIG_GMR_TABLET_MODE
-#define GMR_TABLET_MODE_GPIO_L GPIO_TABLET_MODE_L
-
-/* GPIO alias */
-#define GPIO_AC_PRESENT GPIO_ACOK_OD
-#define GPIO_WP_L GPIO_EC_WP_ODL
-#define GPIO_SWITCHCAP_PG GPIO_SWITCHCAP_GPIO_1
-#define GPIO_ACOK_OD GPIO_CHG_ACOK_OD
-
-#ifndef __ASSEMBLER__
-
-#include "gpio_signal.h"
-#include "registers.h"
-
-enum adc_channel {
-	ADC_VBUS,
-	ADC_AMON_BMON,
-	ADC_PSYS,
-	ADC_CH_COUNT
-};
-
-/* Motion sensors */
-enum sensor_id {
-	LID_ACCEL = 0,
-	BASE_ACCEL,
-	BASE_GYRO,
-	SENSOR_COUNT,
-};
-
-enum pwm_channel {
-	PWM_CH_KBLIGHT = 0,
-	PWM_CH_DISPLIGHT,
-	PWM_CH_COUNT
-};
-
-enum battery_type {
-	BATTERY_GANFENG,
-	BATTERY_TYPE_COUNT,
-};
-/* Reset all TCPCs. */
-void board_reset_pd_mcu(void);
-void board_set_tcpc_power_mode(int port, int mode);
-
-#endif /* !defined(__ASSEMBLER__) */
-
-#endif /* __CROS_EC_BOARD_H */