summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
* Clear OWNERS for factory/firmware branchfactory-ryu-6212.BBrian Norris2021-09-102-10/+1
* stm32f07: change erase page size to 2kBAlec Berg2014-09-111-1/+1
* Add support for BQ27742 battery gauge chipVic Yang2014-09-101-5/+24
* CHERRY-PICK: Ryu: Sensor hub changes for p1.Gwendal Grignou2014-09-053-5/+24
* CHERRY-PICK: stm32mon: add support for i2c transport.Gwendal Grignou2014-09-052-78/+206
* CHERRY-PICK: First drop of ryu sensor hub fileGwendal Grignou2014-09-055-0/+161
* pd: Initialize dual role state based on chipset stateVic Yang2014-09-051-0/+14
* pd: Expand polarity logic to include Ra pull-down logic.Todd Broch2014-09-051-1/+29
* Put 'hostcmd' console command behind a config flagVic Yang2014-09-052-0/+3
* ryu: disable system hibernateVic Yang2014-09-054-0/+18
* pd: Set pd mux to USB 3.0 (superspeed) initially.Todd Broch2014-09-041-0/+11
* ectool: read max outsize/insize from ec during comm_initPuthikorn Voravootivat2014-08-291-0/+20
* host_command_pd: Fix condition for sending a PD MCU host eventShawn Nematbakhsh2014-08-281-1/+1
* pd: ensure names of PD states are up-to-dateVic Yang2014-08-281-0/+6
* pd: Try soft reset if ping failsVic Yang2014-08-281-14/+24
* pd: handle ACCEPT after a soft resetVic Yang2014-08-281-19/+21
* pd: add sending read info VDM every time source is plugged inAlec Berg2014-08-279-24/+87
* samus: add ability for PD MCU to send host event to APAlec Berg2014-08-273-1/+25
* samus: add host commands for flashing zinger RWAlec Berg2014-08-269-10/+250
* ryu: gate SCL to PI3USB9281Vic Yang2014-08-264-0/+34
* Veyron: Change WARM_RESET gpio to open drainAlexandru M Stan2014-08-261-1/+1
* samus: modify accel orientation data for correct lid angleAlec Berg2014-08-261-2/+2
* lm4 i2c: fixed lm4 i2c_xfer synchronization issueSheng-Liang Song2014-08-262-3/+8
* samus: enable accel & gyro sensorsSheng-Liang Song2014-08-264-2/+69
* samus: added gyro support for lsm6ds0Sheng-Liang Song2014-08-2612-611/+1088
* pd: Move dual role toggle hooks to common codeVic Yang2014-08-262-23/+25
* samus: allow booting without a batteryAlec Berg2014-08-261-0/+14
* samus_pd: GPIO updates for EVT buildAlec Berg2014-08-264-69/+65
* samus: change input current limit to the real limitAlec Berg2014-08-261-7/+0
* ryu: enable inductive chargingVic Yang2014-08-253-1/+3
* Add inductive charging control moduleVic Yang2014-08-2510-2/+194
* samus: Add support for asserting RTCRSTDuncan Laurie2014-08-251-3/+29
* samus: GPIO updates for EVT buildDuncan Laurie2014-08-254-15/+15
* samus_pd: enable check for protected mode to prevent PD commAlec Berg2014-08-232-10/+23
* Support inverted ILIM_SEL for smart USB port powerDuncan Laurie2014-08-232-2/+15
* zinger: add voltage dischargeVincent Palatin2014-08-232-24/+89
* Request to hard-reboot EC should reboot PD as wellRandall Spangler2014-08-231-0/+6
* Add hysteresis to host events for battery capacity changedAlec Berg2014-08-221-1/+3
* lightbar: Enable tap-for-battery even in G3Bill Richardson2014-08-225-6/+57
* zinger: add custom VDM to read last measured currentAlec Berg2014-08-224-2/+19
* pd: zinger: Turn off pings by defaultAlec Berg2014-08-223-14/+63
* zinger: always disable adc watchdog before reading ADC channelAlec Berg2014-08-223-13/+27
* zinger: keyborg: fix runtime bug with task_wait_event()Alec Berg2014-08-222-4/+6
* pd: fix bug in pd transmit retry mechanismAlec Berg2014-08-221-0/+8
* Veyron: Fix the polarity of the backlight overrideAlexandru M Stan2014-08-211-1/+1
* Veyron: Removing some stale tegra codeAlexandru M Stan2014-08-211-20/+2
* ryu: detect recovery mode and set proper eventAaron Durbin2014-08-211-0/+10
* power_button: expose raw signal assertionAaron Durbin2014-08-212-2/+17
* lightbar: correctly revert to the S0/S3/S5 patternsBill Richardson2014-08-206-25/+373
* stfm32f0: Send 0xec over i2c until get NAK from host.Puthikorn Voravootivat2014-08-201-5/+4