summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
* endeavour: Increase fan to reduce throttling.firmware-endeavour-13259.B-masterRichard Yeh2023-01-301-59/+33
* fan: Rewrite and test the most common custom fan_percent_to_rpm.Richard Yeh2023-01-303-13/+237
* Clear OWNERS for factory/firmware branchBrian Norris2021-09-107-21/+0
* Endeavour: Update thermal tableDavid Huang2021-07-211-9/+9
* common: motionsense fifo: Reset the initialized bits after commitYuval Peress2021-05-052-2/+13
* endeavour: Reset PSE on warm rebootPablo Ceballos2020-11-201-0/+3
* endeavour: add pse host commandJeff Chase2020-08-192-7/+116
* endeavour: fix PSE init timingJeff Chase2020-07-311-10/+10
* PB: Clear AP_IDLE for recovery bootDaisuke Nojiri2020-07-301-0/+8
* system: Add system_is_manual_recovery APIDaisuke Nojiri2020-07-304-14/+16
* system: Clear AP_IDLE when waking up from hibernation by ACDaisuke Nojiri2020-07-302-2/+15
* PB: Clear AP_IDLE for EC_REBOOT_HIBERNATE_CLEAR_AP_OFFDaisuke Nojiri2020-07-302-3/+3
* PB: Make CONFIG_POWER_BUTTON_INIT_IDLE commonDaisuke Nojiri2020-07-302-32/+31
* Endeavour: Update thermal tableDavid Huang2020-07-161-13/+13
* endeavour: gpios: move USB-C polarity to low-voltage pinJeff Chase2020-06-251-2/+1
* endeavour: gpios: USB-C polarity and PSE resetJeff Chase2020-06-151-1/+2
* console: add micro seconds in timestampsEric Yilun Lin2020-05-301-3/+15
* stm32: Disable option bytes if RO is protected on bootTom Hughes2020-05-302-5/+12
* test: Add test for flash write protectionTom Hughes2020-05-307-0/+94
* test: Add tests for flash option bytes and control registerTom Hughes2020-05-302-0/+99
* stm32: Add helper functions for flash control registersTom Hughes2020-05-303-28/+154
* test: Add flash_physical testTom Hughes2020-05-307-0/+58
* test: Pass commandline arguments to run_testTom Hughes2020-05-3085-86/+86
* test: Add on-device test for calculating MPU regions for RWYicheng Li2020-05-304-18/+59
* test: Check the current image when running the MPU testTom Hughes2020-05-301-4/+20
* Dedede: Enable PD 3.0Diana Z2020-05-301-0/+1
* ANX3447: Add some more registers to dumpAndrew McRae2020-05-302-0/+23
* TCPMv2: Ensure that error flags are cleared upon resetAndrew McRae2020-05-301-1/+9
* Waddledee: Set up C1 interrupt line for board rev 1Diana Z2020-05-302-5/+15
* waddledee/waddledoo: Mark BC1.2 as always poweredAseda Aboagye2020-05-292-0/+4
* test: Test return code on all public MPU functionsTom Hughes2020-05-291-0/+56
* rollback: rollback region must be unlocked in order to erase itTom Hughes2020-05-291-1/+2
* BB retimer: Correct setting USB4 cable speedAyushee2020-05-295-50/+91
* cortex-m: Use MPU REGION_CODE_RAM to lock rollback if neededYicheng Li2020-05-291-1/+1
* cortex-m: Lock RW flash using aligned MPU regionsYicheng Li2020-05-291-5/+27
* baseboard/kukui: move bitbang stability fix to common codeTing Shen2020-05-292-74/+77
* motion_sense: hold 'ready_status' until next lid angle calculationInno.Park2020-05-291-3/+4
* TCPMv2:PRL: PD3 messages should transfer as the correct messageDenis Brockus2020-05-291-4/+23
* pi3usb9201: Add always powered flagAseda Aboagye2020-05-292-6/+21
* bc12: create bc12 driver structureTing Shen2020-05-2919-84/+226
* asurada: enable bmi160/bmm150Ting Shen2020-05-293-3/+117
* core/riscv-rv32i: remove get_sw_int()Tzung-Bi Shih2020-05-292-18/+2
* SM5803: Update initsDiana Z2020-05-291-12/+12
* Lazor: Rename GPIO USB_A_CDP_ILIM_ENWai-Hong Tam2020-05-291-1/+1
* Volteer: Turn off display backlight on lid closeAyushee2020-05-291-0/+4
* tusb422: Enable ADD before setting CCAbe Levkoy2020-05-291-1/+43
* TCPMv2: Restore data_role state directly when sysjump to RWWai-Hong Tam2020-05-281-6/+8
* berknip: implement LED behaviorZick Wei2020-05-283-41/+178
* Bobba: New sku id 27 for Sparky360 (no pen)Sue2020-05-281-2/+6
* kappa: implement battery_get_vendor_param to return oemdataTing Shen2020-05-282-0/+22
View Lorry Controller Status