delta/coreboot/chrome-ec.git - review.coreboot.org: chrome-ec.git

	Commit message (Expand)	Author	Age	Files	Lines
*	Remove board 'wolf' from master/ToT branch.stabilize-falco-4537.91.B stabilize-4537.147.B stabilize-4537.118.B release-R30-4537.B	Dave Parker	2013-08-12	8	-480/+3
*	Add abstract "cond_t" type to detect state transitions.	Bill Richardson	2013-08-09	3	-1/+202
*	Haswell: shutdown directly to G3 without pausing in S5	Bill Richardson	2013-08-09	1	-4/+3
*	Hide battery vendor params override behind config option	Randall Spangler	2013-08-09	8	-22/+11
*	Console command for g781 temperature sensor.	Dave Parker	2013-08-09	2	-13/+194
*	Fix leaving keyboard scanning disabled on brief power button press	Randall Spangler	2013-08-09	1	-4/+4
*	pit: leave 1.35V rail on during warm reboot	Randall Spangler	2013-08-09	1	-1/+7
*	Update Wolf from Slippy.	Hsu Henry	2013-08-08	5	-11/+78
*	pit: If flash registers are disabled all blocks are protected	Randall Spangler	2013-08-08	1	-0/+7
*	Put knowledge of task-config dependency in config.h	Randall Spangler	2013-08-08	13	-41/+41
*	daisy: remove I2C port detection	Randall Spangler	2013-08-08	3	-47/+2
*	console_output: Add commands for saving / restoring print mask.	Shawn Nematbakhsh	2013-08-08	1	-13/+24
*	Use macros for C <-> K conversions	Bill Richardson	2013-08-07	8	-18/+17
*	ectool: Return non-success exit code on bad EC status.	Shawn Nematbakhsh	2013-08-07	2	-0/+4
*	Peppy ectool led command	Dave Parker	2013-08-07	6	-35/+272
*	Clean up configuring GPIO alternate functions	Randall Spangler	2013-08-07	50	-350/+551
*	stm32f: Don't glitch signal when setting GPIO_PULL_UP	Randall Spangler	2013-08-07	1	-1/+0
*	Minor fixes for Kirby board.hstabilize-4512.B	Vic Yang	2013-08-06	1	-4/+1
*	pit: Don't configure PB3 in alternate function mode	Randall Spangler	2013-08-05	1	-3/+0
*	snow: Remove remnants of partial SPI support	Randall Spangler	2013-08-05	2	-15/+0
*	Clean up SPI state machine and add state codes	Randall Spangler	2013-08-05	2	-59/+191
*	Servo V3: Add jtag config for V3	Simran Basi	2013-08-05	1	-0/+10
*	Add kirby board	Vic Yang	2013-08-04	5	-2/+290
*	Remove proxy config flags for unit tests	Vic Yang	2013-08-04	5	-16/+29
*	Move onewire bus support from chip/lm4 to common	Randall Spangler	2013-08-02	3	-1/+1
*	x86: use charge state hook to wake up power button task	Randall Spangler	2013-08-02	2	-13/+14
*	Change one-wire bus to use normal gpio interface	Randall Spangler	2013-08-02	6	-38/+9
*	Move input character processing from UART interrupt to console task	Randall Spangler	2013-08-02	5	-497/+453
*	Remove unneeded includes of registers.h	Randall Spangler	2013-08-02	4	-4/+0
*	Host commands don't set the response pointer	Randall Spangler	2013-08-02	6	-41/+20
*	Falco: Stop charging after a timeout of 10 hours	Dave Parker	2013-08-02	3	-0/+20
*	Track the duration of each charge/discharge state.	Dave Parker	2013-08-02	2	-2/+6
*	Pass command line arguments to make from make_all.sh	Vic Yang	2013-08-01	1	-1/+1
*	Fix documentation for lid change and power button hooks	Randall Spangler	2013-08-01	1	-2/+2
*	spring: Shorten delay for charger redetect	Vic Yang	2013-08-01	1	-1/+1
*	spring: Allow a minimum 100mA current input	Vic Yang	2013-08-01	1	-9/+2
*	spring: Always pull 500mA before charger type is determined	Vic Yang	2013-08-01	1	-11/+2
*	spring: Show yellow LED for battery not fully charged in idle state	Vic Yang	2013-08-01	1	-3/+1
*	spring: Increase CABLE_DET voltage threshold	Vic Yang	2013-08-01	1	-1/+1
*	spring: Ignore battery assist mode when deciding LED color	Vic Yang	2013-08-01	1	-15/+2
*	Revert "spring: always enable the PP3300_WWAN rail"	Vincent Palatin	2013-08-01	2	-3/+4
*	Word-align the host memory map	Randall Spangler	2013-08-01	2	-3/+12
*	Add hook for changes in the charge state machine	Dave Parker	2013-08-01	6	-0/+19
*	bolt: force SYS_PWROK and PP3300_DSW_GATED_EN to 0 in forcing G3 path	Aaron Durbin	2013-08-01	1	-0/+2
*	Abstract polite AP throttling into a function	Bill Richardson	2013-07-31	3	-10/+24
*	Add build-time checks on board-specific array sizes.	Bill Richardson	2013-07-31	23	-62/+101
*	Add led_slippy build rule back to common/build.mk	Dave Parker	2013-07-31	1	-1/+1
*	Add PMU powerinfo host command and console command	Rong Chang	2013-07-29	4	-0/+159
*	ectool: fix console command	Aaron Durbin	2013-07-26	1	-3/+7
*	Add new hostevents to ask the AP to throttle itself	Bill Richardson	2013-07-25	2	-0/+15