summaryrefslogtreecommitdiff
Commit message (Expand)AuthorAgeFilesLines
* Cr50: SAFE MODE: all GPIOs are inputs for Kevin0stabilize-7978.Bstabilize-7978.18.BBill Richardson2016-02-271-10/+10
* cr50: use the correct signer invocation optionsVadim Bendebury2016-02-272-1/+2
* cr50: signer: sync up with upstreamVadim Bendebury2016-02-274-302/+264
* Cr50: Debug: Add pinmux and gpiocfg commandsBill Richardson2016-02-271-0/+151
* Cr50: Configure GPIOs for Kevin proto0Bill Richardson2016-02-273-4/+77
* Cr50: cleanup: Remove some unneccessary codeBill Richardson2016-02-272-11/+0
* lucid: add support to detect BC1.2 suppliersMary Ruthven2016-02-267-24/+138
* oak: Enable TI OPT3001 ambient light sensor for rev5Ben Lok2016-02-263-0/+26
* glados_pd: Add WP_L input GPIO for future boardsShawn Nematbakhsh2016-02-253-1/+22
* cleanup: Add warning comment to gpio.inc filesBill Richardson2016-02-2540-19/+122
* Cr50: Remove GPIOs left over from FPGA boardsBill Richardson2016-02-252-80/+4
* Cr50: Cleanup some of the GPIO handling codeBill Richardson2016-02-254-19/+16
* mec1322: port80: Disable port80 interrupt and timer after timeoutShawn Nematbakhsh2016-02-251-29/+47
* it8380dev: util: Fix iteflash flash issueDonald Huang2016-02-251-1/+37
* Cr50: Fix USB two-stage control transfersBill Richardson2016-02-251-5/+6
* g: Clean up pinmux initializationAnton Staaf2016-02-252-99/+93
* util: ec3po: Implement auto interrogation mode.Aseda Aboagye2016-02-242-10/+191
* jerry: Increase UART TX buffer size.Aseda Aboagye2016-02-231-0/+4
* common: console: Change console_init() string.Aseda Aboagye2016-02-231-0/+4
* pd: Don't source VBUS when forcing sink rolestabilize-7956.BShawn Nematbakhsh2016-02-231-0/+2
* cr50: upgrade: fix debug messages to show address instead of offsetVadim Bendebury2016-02-231-1/+2
* CR50: add in-place decrypt support for AES-CFBnagendra modadugu2016-02-231-36/+17
* Lars_PD: GPIO correctionKyoung Kim2016-02-221-1/+1
* cr50: test: do not leave the bootsrtap pin in the wrong stateVadim Bendebury2016-02-221-3/+1
* GPIO: Remove gpio_alt_funcs table from common headerAnton Staaf2016-02-223-35/+32
* cr50: Switch from ALTERNATE to PINMUX macrosAnton Staaf2016-02-222-26/+42
* GPIO: Move definitions of GPIO_KB_INPUT and OUTPUTAnton Staaf2016-02-2221-39/+32
* skylake: do not clear masks in S0ix -> S0 transitionArchana Patni2016-02-222-9/+18
* Kunimitsu: Enable config REPLACE_LOADER_WITH_BSS_SLOWShobhit Srivastava2016-02-191-0/+1
* Cr50: Slightly better USB error messagesBill Richardson2016-02-181-12/+12
* chip: it83xx: it8320 compatibilityDino Li2016-02-182-0/+3
* kunimitsu: hibernate: enable PseudoG3 support at board levelKevin K Wong2016-02-1811-55/+52
* gaia, mediatek, rockchip, tegra: No more disabling key scanning in power filesDouglas Anderson2016-02-184-25/+0
* chip: it83xx: disable fan control timer if all fans are offDino Li2016-02-171-3/+6
* config: it83xx: remove "CONFIG_IT83XX_PECI_WITH_INTERRUPT"Dino Li2016-02-173-15/+0
* hibernate: Inform PD MCU before calling board hibernate callbackShawn Nematbakhsh2016-02-175-15/+17
* Lars: S0ix/S3 EC power improvementKyoung Kim2016-02-171-2/+2
* cr50: add firmware upgrade testVadim Bendebury2016-02-173-2/+71
* cr50: upgrade command extensionVadim Bendebury2016-02-173-0/+188
* cr50: allow board to provide flash configurationVadim Bendebury2016-02-173-9/+101
* cr50: improve flash driver error reportingVadim Bendebury2016-02-171-7/+23
* wheatley / nuc: Modified the internal ref voltage of ADC to 2.816VMulin Chao2016-02-172-3/+3
* Lars: Power LED to blink in S0iX state.Divagar Mohandass2016-02-161-1/+1
* lucid: add battery cutoff functionalityMary Ruthven2016-02-161-0/+2
* Lars: Enable S0ix.Divagar Mohandass2016-02-142-2/+4
* cr50: modify mpsse to work with the new deviceVadim Bendebury2016-02-132-3/+7
* cr50: improve loader logic to consider build timestamp as wellVadim Bendebury2016-02-121-16/+13
* cr50: write protect area where the code jumps toVadim Bendebury2016-02-121-1/+2
* cr50: test: consolidate test exceptionsVadim Bendebury2016-02-116-63/+53
* Add bionic compatibilityAnatol Pomazau2016-02-102-1/+2