summaryrefslogtreecommitdiff
path: root/chip/stm32/registers.h
Commit message (Expand)AuthorAgeFilesLines
* ish: Trim down the release branchstabilize-wristpin-14469.59.B-ishstabilize-voshyr-14637.B-ishstabilize-quickfix-14695.187.B-ishstabilize-quickfix-14695.124.B-ishstabilize-quickfix-14526.91.B-ishstabilize-14695.85.B-ishstabilize-14695.107.B-ishstabilize-14682.B-ishstabilize-14633.B-ishstabilize-14616.B-ishstabilize-14589.B-ishstabilize-14588.98.B-ishstabilize-14588.14.B-ishstabilize-14588.123.B-ishstabilize-14536.B-ishstabilize-14532.B-ishstabilize-14528.B-ishstabilize-14526.89.B-ishstabilize-14526.84.B-ishstabilize-14526.73.B-ishstabilize-14526.67.B-ishstabilize-14526.57.B-ishstabilize-14498.B-ishstabilize-14496.B-ishstabilize-14477.B-ishstabilize-14469.9.B-ishstabilize-14469.8.B-ishstabilize-14469.58.B-ishstabilize-14469.41.B-ishstabilize-14442.B-ishstabilize-14438.B-ishstabilize-14411.B-ishstabilize-14396.B-ishstabilize-14395.B-ishstabilize-14388.62.B-ishstabilize-14388.61.B-ishstabilize-14388.52.B-ishstabilize-14385.B-ishstabilize-14345.B-ishstabilize-14336.B-ishstabilize-14333.B-ishrelease-R99-14469.B-ishrelease-R98-14388.B-ishrelease-R102-14695.B-ishrelease-R101-14588.B-ishrelease-R100-14526.B-ishfirmware-cherry-14454.B-ishfirmware-brya-14505.B-ishfirmware-brya-14505.71.B-ishfactory-kukui-14374.B-ishfactory-guybrush-14600.B-ishfactory-cherry-14455.B-ishfactory-brya-14517.B-ishJack Rosenthal2021-11-051-492/+0
* chip/stm32: Add initial support for STM32L5xx seriesJes B. Klinke2021-08-251-0/+2
* chip/stm32: Rename field since "or" is reserved in C++Tom Hughes2021-03-161-1/+1
* ec: change usage of dummySam Hurst2020-08-051-1/+1
* servo: Adds USB SPI protocol V2 commands and responsesBrian J. Nemec2020-07-241-1/+2
* stm32g4: Add registers file for stm32g4 chip familyScott Collyer2020-07-231-0/+2
* c2d2/servo_micro: invert SDA during ITE programming seqJett Rink2020-04-161-0/+2
* c2d2: add support for I2C-based flashingJett Rink2020-02-271-1/+2
* cleanup: tab over register valuesJett Rink2020-02-251-20/+20
* ServoMicro: Enable Brownout detection with PVD circuitBrian J. Nemec2020-01-181-0/+1
* stm32: Factor out stm32f7 family registersCraig Hesling2019-07-171-1/+2
* stm32: Add header guard and fix fmt/doc of registers header fileCraig Hesling2019-07-171-1/+36
* stm32: Split registers.h into independent filesCraig Hesling2019-07-151-2706/+17
* LICENSE: remove unnecessary (c) after CopyrightTom Hughes2019-06-191-1/+1
* stm32f0: Set ADC sampling rate before every readDaisuke Nojiri2019-05-041-8/+2
* stm32f412: add TRNG supportNicolas Norvez2019-04-031-0/+1
* common: Add BIT macroGwendal Grignou2019-03-261-597/+598
* chip: stm32: Fix Timers 9 through 11 for STM32F4Moritz Fischer2019-03-161-0/+6
* chip: stm32: Fix GPIO base addresses for STM32F4/LMoritz Fischer2019-03-061-3/+12
* chip: stm32: Enable additional I2C/UART DMA channels for STM32F412Moritz Fischer2019-01-291-5/+9
* Make ADCs on STM32F4 workMoritz Fischer2018-09-281-0/+7
* Refactor ADC clock enable for STM32F0/F3Moritz Fischer2018-09-271-0/+1
* stm32h7: Use high performance voltage scaler before clock upDaisuke Nojiri2018-09-271-0/+5
* stm32h7/nocturne_fp: Enable RDP level 1, tie it to flash protection statusNicolas Boichat2018-09-221-0/+5
* servo_micro: Add enable_ite_dfu and get_ite_chipid console commands.Matthew Blecker2018-08-091-0/+18
* stm32/system: Fix watchdog-initiated resetNicolas Boichat2018-07-131-0/+3
* stm32h7: Add support for TRNGNicolas Boichat2018-07-101-0/+12
* stm32: fix power configuration for STM32H7Vincent Palatin2018-06-291-0/+8
* stm32: low power idle for STM32H7Vincent Palatin2018-06-151-0/+65
* servo_micro: switch parity to 8 bit dataNick Sanders2018-03-121-0/+2
* stm32: crank up CPU PLL frequency to 400Mhz on STM32H743Vincent Palatin2018-03-051-0/+28
* scarlet: Turn off ADC after board version is readPhilip Chen2018-03-021-0/+1
* stm32: fix AXI memory corruption on STM32H743Vincent Palatin2018-02-211-0/+10
* stm32: add internal flash support for STM32H7 familyVincent Palatin2018-02-091-1/+69
* stm32: Fix bkpdata accountingShawn Nematbakhsh2018-01-301-3/+7
* stm32: make half-duplex SPI works on STM32F0Wei-Han Chen2018-01-251-3/+4
* stm32: add SPI slave support for STM32H7Vincent Palatin2018-01-121-0/+8
* stm32: Add STM32H7 familyVincent Palatin2018-01-081-9/+482
* stm32: re-factor registers.h addressesVincent Palatin2017-12-251-161/+167
* stm32: jtag: Enable clock to debug module on stm32f0xMoritz Fischer2017-11-151-0/+1
* chip/stm32/clock: Optionally use LSE as RTCCLKPhilip Chen2017-10-111-5/+11
* stm32: add embryonic support for STM32F76xVincent Palatin2017-08-181-4/+28
* scarlet: Remap DMA channels for USART1Philip Chen2017-08-151-1/+2
* stm32f4: Add OTP support.Gwendal Grignou2017-07-281-0/+13
* stm32f4: Set unique ID properlyGwendal Grignou2017-07-201-1/+5
* servo_micro: add parity settingNick Sanders2017-07-131-0/+4
* chip/stm32/flash-f: Clear option byte write enable/erase operation when doneNicolas Boichat2017-07-071-1/+1
* chip/stm32/registers.h: Fix STM32_FLASH_OPT_LOCKED polarityNicolas Boichat2017-07-061-1/+1
* stm32f4: clock stm32f412 at 96MHzWei-Ning Huang2017-06-211-1/+15
* stm32: flash: enable data and instruction cache properlyWei-Ning Huang2017-06-201-0/+2
View Lorry Controller Status