summaryrefslogtreecommitdiff
path: root/include/config.h
Commit message (Expand)AuthorAgeFilesLines
* g: add CONFIG_USB_CONSOLE_CRCMarius Schilder2018-02-241-0/+6
* host_command: Count suppressed host commands individuallyDaisuke Nojiri2018-02-161-2/+2
* Nami: Enable hibernate using silegoElthan_Huang2018-02-121-0/+6
* charge_state_v2: Store battery information in new structuresNicolas Boichat2018-02-071-0/+28
* common: Add support for PWM LEDs.Aseda Aboagye2018-02-051-0/+29
* Add support for HW alertsAnatol Pomazau2018-01-311-0/+10
* usb pd: Adding PPC vbus discharge pathJett Rink2018-01-311-9/+15
* stm32: add usb_isochronousWei-Han Chen2018-01-311-0/+3
* cleanup: Remove CONFIG_USB_PD_TCPC_BOARD_INITShawn Nematbakhsh2018-01-301-3/+0
* samus_pd: Remove 'adc' console commandShawn Nematbakhsh2018-01-301-3/+6
* Nami: Update for ALS and temperture sensorElmo_Lan2018-01-281-0/+1
* driver/led: Add LM3630A driverBenjamin Gordon2018-01-251-0/+1
* host_command: Suppress individual host command debug logDaisuke Nojiri2018-01-221-0/+3
* backlight: Adding support for active low GPIO signalJett Rink2018-01-181-0/+9
* CBI: Read board info from EEPROMDaisuke Nojiri2018-01-181-0/+6
* npcx7: Add definition/configuration for npcx7m6xb/npcx7m7wCHLin2018-01-171-0/+3
* power: introducing pwr_avg console commandRuben Rodriguez Buchillon2018-01-161-0/+8
* config.h: Define CONFIG_EC_EC_COMM_BATTERY_MASTER/SLAVENicolas Boichat2018-01-111-0/+14
* driver/charger/isl923x: Make sure CONFIG_CHARGER_NARROW_VDC is setNicolas Boichat2018-01-101-1/+10
* charger/isl923x: Implement charger_get_system_power from PSYSNicolas Boichat2018-01-101-2/+10
* charge_state_v2: Add charge_set_output_current_limit functionNicolas Boichat2018-01-041-0/+6
* Add SB-TSI temp sensor driverAlec Thilenius2018-01-031-0/+1
* ec_flash: Add W25Q128 SPI flashScott Worley2017-12-281-0/+1
* ec_driver: Add ADT7481 and TMP411 I2C sensorsScott Worley2017-12-281-0/+2
* ec_gpio: Add GPIO power down supportScott Worley2017-12-281-0/+6
* ec_chip_mchp: Add MCHP chip folderScott Worley2017-12-281-0/+38
* printf: add %li format for compatibilityVincent Palatin2017-12-251-0/+7
* ec_ec_comm_slave: EC-EC communication slave task and functionsNicolas Boichat2017-12-201-0/+14
* config: Add CONFIG_BUTTON_TRIGGERED_RECOVERY.Aseda Aboagye2017-12-181-4/+17
* ish i2c: use i2c_ports[] to set bus speedli feng2017-12-131-4/+0
* motion: Add bh1730 as a motion sensorYB.Ha2017-12-081-0/+6
* i2c: support large reading in i2c_xfer()Chun-Ta Lin2017-12-071-0/+12
* sn5s330: Add support for Vbus detection.Aseda Aboagye2017-12-061-0/+2
* ppc: Add common APIs.Aseda Aboagye2017-12-051-0/+6
* ish i2c: add I2C Fast Mode Plus 1Mbps speed optionli feng2017-12-041-0/+4
* charger: add sy21612 buck-boost converter driverRong Chang2017-11-291-0/+1
* sb_fw_update: Get rid of CONFIG_SB_FIRMWARE_UPDATEFurquan Shaikh2017-11-281-3/+0
* Separate VBUS detection and measurement mechanismsPhilip Chen2017-11-271-0/+11
* hammer: enable large block reading on usb i2c passthru.Chun-Ta Lin2017-11-241-1/+2
* host_events: Bump up host events and masks to 64-bitFurquan Shaikh2017-11-211-0/+4
* buttons: Make buttons[] common.Aseda Aboagye2017-11-171-6/+6
* common: Add software CTZ implementation when needeedGwendal Grignou2017-11-161-0/+3
* poppy: Lower sensor max ODRGwendal Grignou2017-11-151-2/+9
* gru: Remove `flashinfo` command for RAM savingsShawn Nematbakhsh2017-11-091-0/+1
* bd9995x: Use fixed PD-port-to-VBUS/VCC mappingShawn Nematbakhsh2017-11-071-7/+0
* charge_manager: Enter safe mode at bootShawn Nematbakhsh2017-11-021-0/+6
* driver: add IT5205 mux driverDino Li2017-10-311-0/+3
* port80: Clean up macrosFurquan Shaikh2017-10-311-0/+3
* twinkie: clean-up disabled SNIFFER_HEADER_V2 codeVincent Palatin2017-10-311-8/+0
* chip/npcx: Add support for pad-switching UARTNicolas Boichat2017-10-251-0/+7
View Lorry Controller Status